IllustrationINTERMITTENTLY WHEN APPLYING THE BRAKES ON NORMAL ROAD CONDTIONS THE PEDAL IS HARD AND THERE IS NO BRAKING ABILITY. VEHICLE WAS TAKEN TO DEALER (4) TIMES IN (3) MONTHS SINCE 1990. NEW BRAKE PADS WERE PUT ON AT 28,000 MILES IN 1993 OR 1994. *AK
1990 Pontiac 6000
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all 6000 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 11 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Service Brakes, Hydraulic. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Seat Belts. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
1 crash reports0 fire reports2 injury reports
Service Brakes, Hydraulic complaints
4 reportsWHEN APPLYING THE BRAKES, CAR SLID AND THERE NO BRAKE . PLEASE DESCRIBE . *AK
ABS BRAKE SYSTEM FAILED 3 TIMES, VEHICLE VEERS TO THE LEFT WHEN BRAKE APPLIED, REPLACE VALVE BLOCK TWICE/HYDRAULIC PRESSURE UNIT, TO NO AVAIL. TT
LEFT REAR CALIPER LOCKED UP, DAMAGING ROTORS. *SKD
Official recalls
295V173000 · Seat Belts:front:anchorage
Sep 15, 1995
THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."
Consequence & remedy
Consequence: CONSEQUENCE OF NON-COMPLIANCE: IN A COLLISON, STRESS CAN CAUSE THE ATTACHMENT METAL TO TEAR AND ALLOW THE ANCHORAGE TO SEPARATE FROM THE BODY OF THE VEHICLE. THE SAFETY BELT MAY NOT PROTECT AN OCCUPANT IN THE EVENT OF A VEHICLE CRASH.
Remedy: DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.
92V124000 · Seats:front Assembly:recliner
Sep 1, 1992
THE POWER SEAT OR RECLINER WIRING HARNESS CAN BE PINCHED OR CAN CHAFE ON THE SEAT FRAME OR SPRING SUPPORT ROD, WEARING THROUGH THE WIRE INSULATION AND CAUSING AN ELECTRICAL SHORT.
Consequence & remedy
Consequence: THE HIGH CURRENT CAUSED BY THE ELECTRICAL SHORT WELDS THECIRCUIT BREAKER ELEMENTS TOGETHER IN THE CLOSED POSITION, LEAVING THE CIRCUITUNPROTECTED AND GENERATING SUFFICIENT HEAT TO BURN THE WIRE INSULATION ANDIGNITE THE SEAT CUSHION MATERIAL.
Remedy: REPAIR ANY ABRADED WIRING AND REROUTE THE WIRING HARNESS USING A WIRING HARNESS CLIP.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2PE94048 · SUB-FRAME Absorber Failure
Opened Jun 21, 1994 · Closed Dec 30, 1994
Status: closed (inferred from source dates) · Engine And Engine Cooling
There is no summary currently available
EA92024 · Sticking Throttle
Opened Jun 26, 1992 · Closed Jan 31, 1994
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
There is no summary currently available