WITH LESS THAN 500 MILES ON NEW VEHICLE, NOTICED NOT ONLY HEADLIGHTS WERE VERY DIM, BUT EXTREMELY WEAK ON DRIVER SIDE. WHEN SAFELY AT HOME, OPEN HOOD TO SEE IF THERE WAS A PROBLEM. THE WHITE PLASTIC RETAINING RING THAT HOLDS THE HEADLIGHT BULB (9007) IN THE HEADLIGHT HOUSING WAS OFF AND HANGING ON THE WIRES, AND THE HEADLIGHT BU…
Read full complaint
WITH LESS THAN 500 MILES ON NEW VEHICLE, NOTICED NOT ONLY HEADLIGHTS WERE VERY DIM, BUT EXTREMELY WEAK ON DRIVER SIDE. WHEN SAFELY AT HOME, OPEN HOOD TO SEE IF THERE WAS A PROBLEM. THE WHITE PLASTIC RETAINING RING THAT HOLDS THE HEADLIGHT BULB (9007) IN THE HEADLIGHT HOUSING WAS OFF AND HANGING ON THE WIRES, AND THE HEADLIGHT BULB WAS STARTING THE COME OUT OF THE HEADLIGHT HOUSING. AFTER TALKING TO THE DEALERSHIP, THEY COMPARED THE RETAINING RING TO THREE OTHER NEW, NEVER SOLD BEFORE FRONTIERS AND FOUND THIS WAS A STANDARD PART. THE RING DOES NOT MAKE A FULL 1/4 TURN TO TIGHTEN AND THE AMOUNT OF PRESSURE / FORCE TO TIGHTEN RETAINING RING EQUALED TO ALMOST NOTHING. UNKNOWN IF THIS WILL BE A CONSTANT ISSUE IN MY FUTURE OWNERSHIP OF THIS VEHICLE, BUT SINCE THIS WAS AN ISSUE ON EVERY FRONTIER ON THIS LOT, EVEN THOUGH THEY OFFERED TO REPLACE THE RING, NOTHING WOULD BE RESOLVED, IT'S AN IDENTICAL RING. A) UNKNOWN IF THIS WILL CONSTANTLY COME UNDONE ALLOWING THE BULB TO LOOSEN AND FALL OUT. B) IF THIS CONTINUES TO COME UNDONE, WATER / MOISTURE ? DIRT CAN CONSTANTLY ENTER THE HEADLIGHT HOUSING. C) IF BULB FALLS OUT AND IN USE THE HOT BULB CAN / COULD MELT THE HEADLIGHT UNIT, OR FALL ON WIRES MELTING THE MATERIAL CAUSING ELECTRICAL ISSUE. D) CONTACTED NISSAN CORPORATE WITH ANOTHER ISSUE AND THE RESPONSE WAS THEY PREFER TO HAVE THE DEALERSHIP HANDLE VEHICLE CONCERNS. SO DON'T KNOW HOW TO COMMUNICATE WITH NISSAN THEY HAVE A POOR PRODUCT DESIGN / POSSIBLE SAFETY ISSUE AND SHOULD CONSIDER REDESIGN OF NOTHING ELSE, THE WHITE RETAINING RING. I DID SUGGEST THE SERVICE DEPARTMENT SHOULD CONTACT CORPORATE OF THIS, BUT UNKNOWN IF THIS WAS TURNED IN TO NISSAN CORPORATE. *TR
Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Frontier Crew Cab vehicles manufactured June 11, 2014 to June 26, 2014. The affected vehicles were manufactured with an out of specification anchor nut installed on the weld nut plate where the rear seat belt anchor is attached. The seat belt anchor bolt may not be attached as designed.
Consequence & remedy
Consequence: If the seat belt anchor bolt is not attached as designed, that increases the risk of injury in the event of a vehicle crash.
Remedy: Nissan will notify owners, and dealers will inspect the seat belt anchor attachment and repair it if necessary, free of charge. The recall began on August 18, 2014. Owners may contact Nissan customer service at 1-800-647-7261.
Nissan North America, Inc. (Nissan) is recalling certain model year 2012 through 2014 Frontier vehicles manufactured from November 28, 2012, through December 17, 2013. In the affected vehicles, a circuit breaker may have been installed incorrectly causing the main wire harness connected to the circuit breaker to face outward, potentially contacting a metal bolt located on the A-pillar.
Consequence & remedy
Consequence: The bolt may wear through the wire harness covering, resulting in an electrical short which could cause a fire.
Remedy: Nissan will notify owners, and dealers will inspect the circuit breaker orientation. If the circuit breaker orientation is incorrect, dealers will repair the vehicles free of charge. The recall began on March 17, 2014. Owners may contact Nissan at 1-800-647-7261.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2014 Nissan Frontier Problems, Complaints & Recalls | Skip That Year