Air Bags. Review the 26 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Service Brakes, Hydraulic. Review the 7 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Electrical System. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

18 crash reports1 fire reports11 injury reports

Vehicle Speed Control complaints

1 reports

Clear category filter

Mileage unknown · May 24, 2001

Vehicle Speed Control

Read full complaint

IN EARLY APRIL OF 1997 THE GAS PEDAL BEGAN SLIPPING TOWARD THE CLUTCH UPON PRESSING IT TO ACCELERATE. ABOUT A WEEK AFTER THE ORIGNAL INCIDENT, THE SUPPORT BRACKET WHICH IS WELDED TO THE FIREWALL TO SUPPORT THE PEDAL AND ALSO ACT AS A PRESSURE POINT FOR THE TROTTLE LINKAGE BROKE. THE PIECE I AM REFERING TO CONTAINS A SPRING UNIT FOR THE PEDAL. IT SEEMS THAT THE PRESSURE OF THE PEDAL WORE THE BRACKET, MADE OF APPARENTLY ALUMINUM, INTO AT THE FOLDS WHICH PROVIDE THE PIECE A PLACE TO BE SPOT WELDED TO THE FIREWALL.*AK

NHTSA ODI #745841

Official recalls

98V093000 · Visibility:windshield Wiper/washer:linkages

May 5, 1998

VEHICLE DESCRIPTION: PASSENGER VEHICLES. WATER CAN ENTER AND DISPLACE THE GREASE IN THE WIPER ARM LINKAGE BALL JOINT WHERE THE WIPER LINKAGE ATTACHES TO THE WIPER MOTOR LINKAGE.

Consequence & remedy

Consequence: THIS CAN RESULT IN GRADUAL WEAR OVER A PERIOD OF TIME INSIDE THE JOINT THAT COULD LEAD TO THE SEPARATION OF THE WIPER LINKAGE ASSEMBLY FROM THE WIPER MOTOR LINKAGE AT THE BALL JOINT. A LOSS OF WINDSHIELD WIPER FUNCTION CAN RESULT IN THIS SEPARATION OCCURS.

Remedy: TO PREVENT GREASE FROM BEING WASHED OUT OF THE JOINT, THE DEALERS WILL MODIFY BY ADDING A WATER DIVERSION SEAL THAT WILL PREVENT WATER FROM ENTERING THE WINDSHIELD WIPER LINKAGE BALL JOINT AREA.

95V028000 · Service Brakes, Hydraulic:antilock/traction Control/electronic Limited Slip

Mar 1, 1995

THE ANTI-LOCK BRAKING SYSTEM (ABS) HYDRAULIC ACTUATOR WAS NOT PROPERLY PURGED OF ALL AIR DURING THE FILL AND EVACUATION PROCESS CAUSING AIR BUBBLES TO GET INTO THE BRAKE SYSTEM.

Consequence & remedy

Consequence: THIS CONDITION CAN CAUSE INCREASED BRAKE PEDAL TRAVEL AND STOPPING DISTANCES.

Remedy: DEALERS WILL BLEED THE ABS HYDRAULIC ACTUATOR TO REMOVE ANY AIR BUBBLES IN THE BRAKE SYSTEM.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

No exact-year investigations in this snapshot.