IllustrationI UNDERSTAND MITSUBIHI IS HAVING PROBLEMS WITH CRANKSHAFT BOLT PROBLEMS IN OTHER VEHICLES, AND THIS IS ANOTHER INCIDENT.*AK (DOT NUMBER: N/A TIRESIZE: N/A)
1991 Mitsubishi Montero
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Montero years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 3 of 18 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Engine And Engine Cooling. Review the 7 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Steering. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Tires. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports2 fire reports0 injury reports
What owners actually said
18 reportsCURT & HAL SERVICE DEPARTMENT CALLED THE MITSUBISHI DEALER IN OUR AREA AND WERE TOLD THAT THIS PART WAS A VERY COMMON REPAIR TO THIS PARTICULAR VEHICLE. WHEN LOOKING FOR A USED PART, THERE WAS ABSOLUTELY NONE TO BE HAD IN ENTIRE WESTERN U.S., AND REPAIR OF THIS PART, AFTER IT HAS BEEN BURNED IS NOT AN OPTION. THE HOUSING HAS B…
Read full complaint
CURT & HAL SERVICE DEPARTMENT CALLED THE MITSUBISHI DEALER IN OUR AREA AND WERE TOLD THAT THIS PART WAS A VERY COMMON REPAIR TO THIS PARTICULAR VEHICLE. WHEN LOOKING FOR A USED PART, THERE WAS ABSOLUTELY NONE TO BE HAD IN ENTIRE WESTERN U.S., AND REPAIR OF THIS PART, AFTER IT HAS BEEN BURNED IS NOT AN OPTION. THE HOUSING HAS BURNED TO WHERE THEY AREN'T ABLE TO ATTACH NEW COMPONENTS TO IT. THANK YOU FOR LOOKING INTO THIS. IT SEEMS TO ME, THAT IF MITSUBISHI HAS HAD THIS KIND OF PROBLEM IN MANY OTHER MONTEROS, THEN THEY SHOULD BE DOING A RECALL. THANKS AGAIN, LORI LANNIGAN NO SAFETY DEFECT LISTED. *AK
THE TREAD JUST CAME FLYING RIGHT OFF OF THE TIRE, AND ALMOST CAUSED MY WIFE WHO IS PREGNENT AND MY CHIL OF FOUR TO ROLL. *AK( DOT NUMBER: TIRE SIZE: P235/75R15 )
WHILE CONSUMER WAS IN THE STORE VEHICLE CAUGHT ON FIRE FROM THE ELECTRICAL SYSTEM, AND CONSUMER CAN'T DETERMINE THE PROBLEM. *AK
STEERING COLUMN FAILURE; ALSO, FRONT/REAR SEAT BELT BUCKLES FAILED. *AK
TRANSMISSION GEAR SHIFTER WILL NOT LOCK WHEN KEY IS REMOVED FROM IGNITION SWITCH, ALLOWING VEHICLE TO ROLL BACKWARDS.
DURING VEHICLE OPERATION WHEN THE VEHICLE COMES TO A STOP, IT PERIODICALLY TENDS TO ACCELERATE AND SURGE FORWARD. *AK
FRONT BRAKE ROTORS HAVE BEEN REPLACED 5 TIMES WITHIN 4 YEARS; WEAR THIN; METAL TO METAL GRINDING SOUND; EXCESSIVE STOPPING EFFECT. TT
Official recalls
195V103004 · Seat Belts:front:buckle Assembly
May 24, 1995
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence & remedy
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1EA95004 · Takata Seat Belt Buckle Failure
Opened Mar 10, 1995 · Closed Aug 1, 1995
Status: closed (inferred from source dates) · Seat Belts:front:buckle Assembly
There is no summary currently available