THERE WAS CONSTANT KNOCKING FROM THE REAR OF THE VEHICLE AND I TOOK THE SUV TO DEALER. THE DEALER SAYS "THE RIGHT REAR STRUT IS NOT CONNECTED TO THE BODY OF THE CAR. THERE IS HEAVY RUST AND THIS IS NOT A SAFE CONDITION TO TRY THE CAR". OVER THE WEEKEND, THE SHOCK MOUNT BRACKET COMPLETELY FELL OFF. IT DOESN'T SEEMS TO BE A GOOD D…
Read full complaint
THERE WAS CONSTANT KNOCKING FROM THE REAR OF THE VEHICLE AND I TOOK THE SUV TO DEALER. THE DEALER SAYS "THE RIGHT REAR STRUT IS NOT CONNECTED TO THE BODY OF THE CAR. THERE IS HEAVY RUST AND THIS IS NOT A SAFE CONDITION TO TRY THE CAR". OVER THE WEEKEND, THE SHOCK MOUNT BRACKET COMPLETELY FELL OFF. IT DOESN'T SEEMS TO BE A GOOD DESIGN ORIGINALLY TO USE THE SHEET METAL OF THE FENDER WELL AS THE CONNECTION POINT, WITHOUT EXTRA MEASURE TO SECURE THE SHOCK TO THE BODY. IT IS A DEFECT. *TR
NHTSA ODI #10648717
70,000 miles · May 17, 2014
StructureSuspensionWheels
WHILE DRIVING TO WORK I STARTED TO HEAR A BANGING SOUND FROM THE BACK OF MY VEHICLE. IT SOUNDED LIKE THE BACK WINDOW WAS OPEN & BANGING EVERY TIME I HIT A BUMP. I PULLED OVER AND MADE SURE EVERYTHING WAS SHUT. I PROCEEDED TO WORK BUT THE BANGING PERSISTED. WHEN I GOT TO WORK I CHECKED THE BACK COMPARTMENT & REMOVED MY CARGO INC…
Read full complaint
WHILE DRIVING TO WORK I STARTED TO HEAR A BANGING SOUND FROM THE BACK OF MY VEHICLE. IT SOUNDED LIKE THE BACK WINDOW WAS OPEN & BANGING EVERY TIME I HIT A BUMP. I PULLED OVER AND MADE SURE EVERYTHING WAS SHUT. I PROCEEDED TO WORK BUT THE BANGING PERSISTED. WHEN I GOT TO WORK I CHECKED THE BACK COMPARTMENT & REMOVED MY CARGO INCASE THAT WAS CULPRIT. ON MY DRIVE HOME THE BANGING STILL PERSISTED. MY HUSBAND LOOKED AT THE VEHICLE AND SAID THAT THE SHOCKS/STRUTS WERE BLOWN. I TOOK IT TO THE GARAGE THAT NIGHT & IT TURNS OUT THAT THE PASSENGER SIDE REAR WHEEL WELL WAS COMPLETELY RUSTED THROUGH & THERE WAS NO WHERE FOR THE SHOCK TO MOUNT. WHEN THE MECHANIC PULLED UP MY CARGO MAT IN THE BACK IT IS AMAZING THAT NOTHING FELL OUT, THE SIZE OF THE HOLE FROM THE RUST IS COMPARABLE TO THE SIZE OF A BASKETBALL. WELDING IS NOT EVEN AN OPTION TO REPAIR THIS DAMAGE. THERE IS NO OTHER RUST OR BODY DAMAGE TO MY VEHICLE. THERE WAS A PROTECTIVE COATING ON THE INNER WHEEL WELL TO PREVENT THIS. THE DRIVER SIDE IS FINE AND IS SHOWING NO SIGN OF RUST/ROT. WHILE SEARCHING THE WEB FOR SUPPORT I SEE THIS IS A VERY COMMON PROBLEM IN THE FORD ESCAPE AND MAZDA TRIBUTE (VIRTUALLY ONE IN THE SAME). WHEN WILL SOMETHING BE DONE ABOUT THIS COSTLY PROBLEM? AS A SIDE NOTE, THIS CAR HAS BEEN A PROBLEM SINCE I BOUGHT IT IN 2006. I FILED A MAGNUS AND MOSS WARRANTY ACT SUIT AGAINST MAZDA AND WON FOR NUMEROUS ISSUES REGARDING THE TRANSMISSION AND POWER TRAIN SYSTEM. *JS
NHTSA ODI #10592153
10 miles · Nov 7, 2006
Electrical SystemStructure
I PURCHASED A MAZDA TRIBUTE 2006 MODEL ON 9/4/06 AND I TOOK IT IN ON 11/1/06 FOR WATER IN HEADLAMP, WATER WAS GETTING DOWN THE IN WINDOWS, AND TIRE PRESSURE LIGHT BLINKING. I WAS TOLD AT THE END OF THE DAY THAT THE CAR WAS NOT READY BECAUSE THEY COULD NOT FIGURE OUT THE TIRE PRESSURE LIGHT PROBLEM AND THEY ORDERED A PART. WELL,…
Read full complaint
I PURCHASED A MAZDA TRIBUTE 2006 MODEL ON 9/4/06 AND I TOOK IT IN ON 11/1/06 FOR WATER IN HEADLAMP, WATER WAS GETTING DOWN THE IN WINDOWS, AND TIRE PRESSURE LIGHT BLINKING. I WAS TOLD AT THE END OF THE DAY THAT THE CAR WAS NOT READY BECAUSE THEY COULD NOT FIGURE OUT THE TIRE PRESSURE LIGHT PROBLEM AND THEY ORDERED A PART. WELL, THE NEXT DAY IT WAS THE SAME THING, NEEDED ANOTHER PART AND THEY HAVE BEEN ON THE PHONE WITH MAZDA TECH SUPPORT. WELL TODAY IS 11/7/06 AND I STILL DO NOT HAVE MY VEHICLE BACK. THEY ARE NOW SAYING THAT THEY HAVE ORDERED ANOTHER PART AND IT WILL BE THREE TO FOUR DAYS BECAUSE THE PART IS ON BACK ORDER. I FEEL I HAVE BOUGHT A DEFECTIVE VEHICLE AND MAZDA SHOULD GIVE ME ANOTHER VEHICLE TO REPLACE IT. THIS VEHICLE (FROM THE SOUNDS OF SOUTHERN STATES) HAS HAD ALL OF THE COMPUTER CENSORS REPLACED MINUS THE MAJOR ONE (ACCORDING TO SOUTHERN STATES) AND FOR A VEHICLE TO BE NEW AS THIS ONE IS WITH THESE KIND OF PROBLEMS, I FEEL IS DEFECTIVE. *JB
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Consequence & remedy
Consequence: A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Remedy: Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.
Additional source detail variants (2)
Vehicle Speed Control:cables
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Consequence: A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Remedy: Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.
Engine And Engine Cooling
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Consequence: A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Remedy: Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.
ON CERTAIN TRUCKS AND SPORT UTILITY VEHICLES, THE WINDSHIELD WIPER MOTOR MAY HAVE BEEN PRODUCED WITHOUT GREASE APPLIED TO THE OUTPUT SHAFT GEAR.
Consequence & remedy
Consequence: AFTER A PERIOD OF CONTINUOUS USE ON THE HIGH SPEED SETTING, LACK OF GREASE ON THE OUTPUT SHAFT GEAR MAY CAUSE THE GEAR TEETH TO DISTORT OR FRACTURE DURING OPERATION RESULTING IN THE LOSS OF WIPER FUNCTION. INOPERATIVE WIPERS UNDER INCLEMENT WEATHER CONDITIONS COULD CAUSE A CRASH DUE TO IMPAIRED VISIBILITY.
Remedy: DEALERS WILL INSPECT THE WIPER MOTOR FOR THE PRESENCE OF GREASE AND GREASE THE WIPER MOTOR GEARS IF NECESSARY. THE RECALL BEGAN ON NOVEMBER 28, 2005. OWNERS MAY CONTACT MAZDA AT 1-800-222-5500.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2006 Mazda Tribute Problems, Complaints & Recalls | Skip That Year