IllustrationI WAS ON THE HIGHWAY IN MOTION WHEN ALL OF A SUDDEN MY SHIFTER BROKE OFF AND I WASN'T ABLE TO MOVE. I HAD TO CALL I TOW
2008 Mazda MAZDASPEED3
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all MAZDASPEED3 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
40–25K
1325–50K
450–75K
775–100K
2100–150K
0150K+
30 reports with mileage · 3 unknown
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Power Train. Review the 23 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
1 crash reports2 fire reports2 injury reports
Unknown Or Other complaints
2 reportsI BEGAN TO ACCELERATE MY MAZDASPEED 3 SHIFTING FROM 1ST GEAR TO SECOND GEAR. I SHIFTED INTO THIRD WHERE MY SHIFT BROKE AND REMAINED IN MY HAND. MY CAR STALLED OUT IN 3RD BECAUSE I COULD NOT SHIFT OUT. I TOOK OFF THE PLASTICS COVERING THE SHIFTER AND PULLED THE PLATE BACK INTO NEAUTRAL SO I COULD PUSH MY CAR TO THE LOCAL GAS STAT…
Read full complaint
I BEGAN TO ACCELERATE MY MAZDASPEED 3 SHIFTING FROM 1ST GEAR TO SECOND GEAR. I SHIFTED INTO THIRD WHERE MY SHIFT BROKE AND REMAINED IN MY HAND. MY CAR STALLED OUT IN 3RD BECAUSE I COULD NOT SHIFT OUT. I TOOK OFF THE PLASTICS COVERING THE SHIFTER AND PULLED THE PLATE BACK INTO NEAUTRAL SO I COULD PUSH MY CAR TO THE LOCAL GAS STATION. MY SHIFTER ROD SNAPPED AND THE SPRING CAME OUT.
Official recalls
111V329000 · Visibility:windshield Wiper/washer:motor
Jun 15, 2011
MAZDA IS RECALLING CERTAIN MODEL YEAR 2008-2009 MAZDA3 AND MAZDASPEED3 VEHICLES MANUFACTURED FROM JANUARY 7, 2008, THROUGH NOVEMBER 28, 2008. THE GROUND TERMINAL OF THE WINDSHIELD WIPER MOTOR MAY HAVE BEEN INADVERTENTLY BENT DURING ASSEMBLY. IF THIS CONDITION EXISTS THEN OVER TIME THE ELECTRICAL RESISTANCE OF THE MOTOR CIRCUIT MAY INCREASE UP TO A POINT THAT THE WINDSHIELD WIPERS WOULD NOT WORK.
Consequence & remedy
Consequence: THE LOSS OF WIPER FUNCTION IN ADVERSE WEATHER COULD POTENTIALLY INCREASE THE RISK OF A CRASH.
Remedy: DEALERS WILL INSTALL AN ADDITIONAL GROUND HARNESS ON THE WIPER MOTOR FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE JULY 15, 2011. OWNERS MAY CONTACT MAZDA CUSTOMER ASSISTANCE CENTER AT 1-800-222-5500.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.