2010 Mazda MAZDA5

REAR SLIDING DOORS OF MAZDA 5 ARE FREEZING SHUT WHEN PULLING ON HANDLE DOOR OPENS SLIGHTLY AND FRREZES. DOOR THEN CANNOT BE OPENED OR CLOSED AND THEN HAVE TO DRIVE CAR WITH A PARTLY OPENED REAR DOOR. THIS IS HAPPENING ON BOTH REAR DOORS. THE VEHICLE WAS PARKED DURING THE DAY IN A CARPARK. THIS HAS NOW HAPPENED ON 6 SEPARATE OCCASIONS AND IS VERY UNSAFE. DOOR LATCH IS FREEZING AND WILL NOT OPEN OR CLOSE REAR SLIDING DOORS. DOOR WILL START TO OPERATE NORMALLY ONCE CAR IS DRIVEN INTO A HEATED GARAGE AND RETURNS TO ABOVE FREEZING TEMPERATURES.

THE AIRBAG SENSOR IN MY VEHICLE WHEN OFF ONE DAY. I HAVE NOT BEEN AN ANY ACCIDENTS THAT WOULD HAVE TRIGGERED THE AIRBAG. I HAS CONTINUED TO GO OFF AND ON AND IT DOESN'T MATER IF I AM PARKED OR IN MOTION. I HAVE TAKEN TO DEALERSHIP AND OTHER MECHANICS (FOR SECOND OPINION) AND THEY BOTH STATED THAT THE AIRBAG SYSTEM IS DEFECTIVE AND WILL NOT WORK PROPERLY IN AN ACCIDENT. I HAVE CHECKED FOR RECALLS AND HAVE FOUND NON. BUT I HAVE FOUND MANY OTHER MAZDA5 2010 OWNERS WHO ARE HAVING THE SAME EXACT PROBLEM WITH THEIR AIR BAGS. I WOULD LIKE FOR SOMEONE TO INVESTIGATE THIS AND ADD IT TO A RECALL, BEFORE SOMEONE IN MY FAMILY IS KILLED OR INJURED IN AN ACCIDENT.

CORRODED TIRE PRESSURE SENSOR CAUSED SUDDEN LOSS OF AIR AND TIRE "EXPLODED" WHILE DRIVING ON FREEWAY AT HIGHWAY SPEED. NO POTHOLES, OBSTRUCTIONS OR OTHER IMPEDIMENTS TO CAUSE LOSS OF TIRE PRESSURE. RESULT WAS A VERY DANGEROUS SITUATION REQUIRING DRIVER TO CROSS THREE LANES OF TRAFFIC TO REACH SHOULDER. TIRE WAS "SHREDDED" NEARLY AROUND ENTIRE CIRCUMFERENCE, AND RUBBER CRUMBLED. DEALERSHIP TECH SAID PROBABLE CAUSE WAS CORROSION OF TIRE PRESSURE SENSOR. TIRE PRESSURE SENSOR WAS ORIGINAL EQUIPMENT ON VEHICLE.

FRONT SWAY BAR BUSHINGS WERE REPLACED NO LESS THAN 3 TIMES BY THE DEALER UNDER WARRANTY. THE SYMPTOM IS A CLUNKING OR THUMPING NOISE ON ROUGH OR WASHBOARDED ROADS. THE SWAY BAR IS .908 INCHES IN DIAMETER AND THE WALL THICKNESS OF THE BUSHINGS IS APPROXIMATELY .25 INCHES. THEY ARE RUBBER FROM MAZDA AND APPARENTLY, CHANGING THEM EVERY 20K MI OR SO ARE NOT ADEQUATE FOR THE APPLICATION. SEEMS THAT THERE IS A KNOWN ISSUE BY MAZDA FOR THIS BUT ONE OF THE BUSINING THAT WAS JUST REMOVED 2/3/18 WAS TORN NEARLY IN HALF ACROSS BETWEEN THE SWAY BAR AND THE CROSS MEMBER. IF THESE WERE IGNORED AND THE BUSHINGS COMPLETELY FELL OUT OF THE BRACKETS THER WOULD BE ENOUGH MOVEMENT OF THE SWAY BAR TO CAUSE INTERFERENCE IN STEERING THE VEHICLE DUE TO THE FULLY ARTICULATED DESIGN OF THE SWAY BAR ENDLINKS. THIS HAS THE POTENTIAL TO BE A DEADLY ISSUE.

POWER STEERING WILL RANDOMLY FAIL WHILE MAKING TURNS. DURING THE TURN, ALL WARNING LIGHTS WILL ILLUMINATE, POWER STEERING WILL FAIL. POWER STEERING FAILURE LIGHT WILL REMAIN ILLUMINATED. VEHICLE IS EXTREMELY DIFFICULT TO CONTROL. WE HAVE AVOID AT LEAST THREE COLLISIONS BY MERE INCHES. AFTER A FEW SECONDS, POWER STEERING WILL RETURN, LIGHTS WILL EXTINGUISH. DEALER HAS NOT BEEN ABLE TO FIND A FAULT CODE AND HAS NOT BEEN ABLE TO DUPLICATE THE PROBLEM. VEHICLE IS TOO DANGEROUS TO DRIVE. THIS HAS HAPPENED MULTIPLE TIMES IN THE PAST SEVERAL YEARS. IT HAS HAPPENED AT SPEEDS FROM 15 MPH TO 55 MPH.