← New search

2009 Kawasaki KL650E9F

Owner reports · Recalls · Investigations

Limited comparison data

There is not enough comparable history to draw a useful model-year comparison.

About this comparison →

How this year compares

Owner complaints by model year

Other model years Selected year
Compare all KL650E9F years →

Counts vary with age, sales and reporting. They are not failure rates.

What owners reported most

Tap a category to read its complaints. One report may name several components.

When problems were reported

Mileage at the reported incident

Limited mileage data: 2 of 2 reports include usable mileage. There isn’t enough coverage to show a useful chart.

NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.

What to inspect

Issues worth paying extra attention to based on owner reports.

  • Engine And Engine Cooling. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Service Brakes, Hydraulic. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Structure. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

0 crash reports0 fire reports0 injury reports

Engine And Engine Cooling complaints

1 reports
Clear category filter
851 miles · Jun 6, 2010
Engine And Engine Cooling

2009 KAWASAKI KLR650 MOTORCYCLE BUILD DATE SEPT. 2008. THE STARTER IDLER SHAFT BEARING HOLE IN THE OUTER ALTERNATOR CASE SIDE IS BORED TOO DEEP. THIS ALLOWS THE SHAFT TO MIGRATE OVER SO THAT IT IS ONLY SUPPORTED ON ONE END. RESULT IS THE OTHER END WOBBLES, GRINDS AWAY AT THE BEARING AND CASE SURFACE, AND COULD CAUSE THE IDLER…

Read full complaint

2009 KAWASAKI KLR650 MOTORCYCLE BUILD DATE SEPT. 2008. THE STARTER IDLER SHAFT BEARING HOLE IN THE OUTER ALTERNATOR CASE SIDE IS BORED TOO DEEP. THIS ALLOWS THE SHAFT TO MIGRATE OVER SO THAT IT IS ONLY SUPPORTED ON ONE END. RESULT IS THE OTHER END WOBBLES, GRINDS AWAY AT THE BEARING AND CASE SURFACE, AND COULD CAUSE THE IDLER GEAR TO JAM. IF THIS HAPPENS, THE ENGINE WILL STOP ABRUPTLY. KAWASAKI FIXED THIS IN LATER BUILD 2009S AND THE 2010 MODELS BY PUTTING A STEP IN THE BORE SO THAT THE SHAFT CANNOT MIGRATE, BUT WILL NOT PUT THIS CHANGE INTO EARLIER MODELS THAT ARE OUT OF WARRANTY. I THINK THIS IS A SAFETY ISSUE AND THAT THIS CHANGE SHOULD BE MADE TO ALL AFFECTED MOTORCYCLES. NOTE: MINE HAS NOT YET FAILED, BUT ONLY BECAUSE I WAS INFORMED OF THE PROBLEM AND TOOK CORRECTIVE ACTION TO PREVENT THIS FROM OCCURRING. *TR

NHTSA ODI #10334779

Official recalls

0

No recalls in this snapshot.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

0

No exact-year investigations in this snapshot.