TL* THE CONTACT OWNS A 2006 JEEP WRANGLER 4X4. THE CONTACT STATED THAT AFTER PUTTING ON HER SEAT BELT AND TRYING TO TIGHTEN IT, THE METAL PART INSIDE THE CHAIR FAILED. THE VEHICLE WAS TAKEN TO A DEALER WHO WAS UNABLE TO DETERMINE WHAT CAUSED THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS CONTACTED AND THEY OFFER…
Read full complaint
TL* THE CONTACT OWNS A 2006 JEEP WRANGLER 4X4. THE CONTACT STATED THAT AFTER PUTTING ON HER SEAT BELT AND TRYING TO TIGHTEN IT, THE METAL PART INSIDE THE CHAIR FAILED. THE VEHICLE WAS TAKEN TO A DEALER WHO WAS UNABLE TO DETERMINE WHAT CAUSED THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS CONTACTED AND THEY OFFERED NO ASSISTANCE. THE FAILURE AND CURRENT MILEAGE WAS 61,113.
NHTSA ODI #10480677
29,700 miles · Dec 13, 2011
Seat Belts
TL* THE CONTACT OWNS A 2006 JEEP WRANGLER SPORT. THE CONTACT STATED THAT THE PASSENGER SIDE SEAT BELT WOULD NOT RETRACT, AND COULD NOT BE UTILIZED. THE DEALER AND THE MANUFACTURER WERE NOTIFIED OF THE FAILURE, BUT DENIED ANY ASSISTANCE WITH REPAIRS TO THE VEHICLE. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS 29,700 …
Read full complaint
TL* THE CONTACT OWNS A 2006 JEEP WRANGLER SPORT. THE CONTACT STATED THAT THE PASSENGER SIDE SEAT BELT WOULD NOT RETRACT, AND COULD NOT BE UTILIZED. THE DEALER AND THE MANUFACTURER WERE NOTIFIED OF THE FAILURE, BUT DENIED ANY ASSISTANCE WITH REPAIRS TO THE VEHICLE. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS 29,700 AND THE CURRENT MILEAGE WAS 29,828. THE VIN WAS UNAVAILABLE.
NHTSA ODI #10439763
1,079 miles · Jun 6, 2006
Seat Belts
DT*: THE CONTACT STATED WHILE HITTING A POT HOLE AT 7 MPH THE PASSENGER SIDE SEATBELT ANCHOR CAME LOOSE FROM THE VEHICLE FLOOR. THE DEALER AND MANUFACTURER HAVE NOT BEEN ALERTED AND NO INSPECTIONS HAVE BEEN MADE.
Chrysler (FCA US LLC) is recalling certain model year 2006 Dodge Viper and Jeep Wrangler and Liberty vehicles manufactured July 1, 2005, to July 31, 2006. In the affected vehicles, the springs within the clutch pedal position switch that prevents the vehicle from starting unless the clutch pedal is pushed down may break. As a result, the vehicle may not be started when the clutch pedal is pushed down or the engine may crank and start without the clutch pedal being pushed down causing the vehicle to unexpectedly lurch.
Consequence & remedy
Consequence: If the vehicle unexpectedly moves there is an increased risk of a crash.
Remedy: Chrysler will notify owners, and dealers will replace the clutch ignition interlock switch, free of charge. The recall began on August 31, 2015. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R13.
ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH 6 SPEED MANUAL TRANSMISSIONS, THE HYDRAULIC CLUTCH MASTER CYLINDER LINKAGE ROD MAY BREAK. THIS MAY NOT ALLOW DISENGAGEMENT OF THE CLUTCH WHEN THE PEDAL IS DEPRESSED.
Consequence & remedy
Consequence: UNINTENTIONAL VEHICLE MOVEMENT, INCREASED STOPPING DISTANCE, AND ENGINE STALLING COULD OCCUR WHICH COULD RESULT IN A CRASH.
Remedy: DEALERS WILL REPLACE THE CLUTCH MASTER CYLINDER LINKAGE ROD FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 7, 2006. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
ON CERTAIN PICKUP TRUCKS, SPORT UTILITY AND PASSENGER VEHICLES EQUIPPED WITH 42RLE AUTOMATIC TRANSMISSIONS, THE CUP PLUG THAT RETAINS THE PARK PAWL ANCHOR SHAFT MAY BE IMPROPERLY INSTALLED. IF THE SHAFT MOVES OUT OF POSITION, THE VEHICLE MAY NOT BE ABLE TO ACHIEVE 'PARK' POSITION.
Consequence & remedy
Consequence: IF THIS OCCURS AND THE PARKING BRAKE IS NOT APPLIED, THE VEHICLE MAY ROLL AWAY AND CAUSE A CRASH WITHOUT WARNING.
Remedy: DEALERS WILL INSPECT THE TRANSMISSIONS AND INSTALL A BRACKET TO ENSURE THE PARK PAWL ANCHOR SHAFT IS RETAINED IN THE PROPER POSITION. THE RECALL BEGAN ON NOVEMBER 28, 2005. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
PE06015 · Clutch Linkage Failure
Opened Apr 20, 2006 · Closed Jun 13, 2006
Status: closed (inferred from source dates) · Power Train:clutch Assembly; Power Train:clutch Assembly:pedal/hand Lever(motorcycle)
ON MAY 2, 2006 DAIMLERCHRYSLER CORPORATION (DCC) SUBMITTED TO THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION (NHTSA) A PART 573 REPORT ADVISING THAT CERTAIN MODEL YEAR 2006 JEEP WRANGLER VEHICLES WOULD BE VOLUNTARILY REC ALLED TO REPLACE A DEFECTIVE CLUTCH LINKAGE COMPONENT.THE RECALL ACTION IS IDENTIFIED BY NHTSA NO. 06V147 (DCC NO. F22).THE LINKAGE ROD BETWEEN THE CLUTCH PEDAL AND CLUTCH MASTER CYLINDER CAN BREAK WHEN THE CLUTCH PEDAL IS DEPRESSED; LINKAGE ROD FAILURE UNDER THESE CONDITIONS RESULTS IN IMMEDIATE ENGAGEMENT OF THE CLUTCH AND RENDERS THE CLUTCH PEDAL INEFFECTIVE THEREAFTER .THE 6,876 MANUAL TRANSMISSION VEHICLES INCLUDED IN THE RECALL ACTION WERE ALL MANUFACTURED BETWEEN 11/3/2005 AND 2/13/2006.DCC WILL REPLACE THE DEFECTIVE LINKAGE WITH A COMPONENT OF A PREVIOUS DESIGN LEVEL WHICH HAS NOT EXPERIENCED FIELD FAILURE.THE TIMING OF DCC'S ACTION HAS NOT BEEN DETERMINED.ACCORDINGLY, THIS PRELIMINARY EVALUATION IS CLOSED.
Additional source detail variants (2)
Power Train:clutch Assembly
ON MAY 2, 2006 DAIMLERCHRYSLER CORPORATION (DCC) SUBMITTED TO THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION (NHTSA) A PART 573 REPORT ADVISING THAT CERTAIN MODEL YEAR 2006 JEEP WRANGLER VEHICLES WOULD BE VOLUNTARILY REC ALLED TO REPLACE A DEFECTIVE CLUTCH LINKAGE COMPONENT.THE RECALL ACTION IS IDENTIFIED BY NHTSA NO. 06V147 (DCC NO. F22).THE LINKAGE ROD BETWEEN THE CLUTCH PEDAL AND CLUTCH MASTER CYLINDER CAN BREAK WHEN THE CLUTCH PEDAL IS DEPRESSED; LINKAGE ROD FAILURE UNDER THESE CONDITIONS RESULTS IN IMMEDIATE ENGAGEMENT OF THE CLUTCH AND RENDERS THE CLUTCH PEDAL INEFFECTIVE THEREAFTER .THE 6,876 MANUAL TRANSMISSION VEHICLES INCLUDED IN THE RECALL ACTION WERE ALL MANUFACTURED BETWEEN 11/3/2005 AND 2/13/2006.DCC WILL REPLACE THE DEFECTIVE LINKAGE WITH A COMPONENT OF A PREVIOUS DESIGN LEVEL WHICH HAS NOT EXPERIENCED FIELD FAILURE.THE TIMING OF DCC'S ACTION HAS NOT BEEN DETERMINED.ACCORDINGLY, THIS PRELIMINARY EVALUATION IS CLOSED.
Power Train:clutch Assembly:pedal/hand Lever(motorcycle)
ON MAY 2, 2006 DAIMLERCHRYSLER CORPORATION (DCC) SUBMITTED TO THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION (NHTSA) A PART 573 REPORT ADVISING THAT CERTAIN MODEL YEAR 2006 JEEP WRANGLER VEHICLES WOULD BE VOLUNTARILY REC ALLED TO REPLACE A DEFECTIVE CLUTCH LINKAGE COMPONENT.THE RECALL ACTION IS IDENTIFIED BY NHTSA NO. 06V147 (DCC NO. F22).THE LINKAGE ROD BETWEEN THE CLUTCH PEDAL AND CLUTCH MASTER CYLINDER CAN BREAK WHEN THE CLUTCH PEDAL IS DEPRESSED; LINKAGE ROD FAILURE UNDER THESE CONDITIONS RESULTS IN IMMEDIATE ENGAGEMENT OF THE CLUTCH AND RENDERS THE CLUTCH PEDAL INEFFECTIVE THEREAFTER .THE 6,876 MANUAL TRANSMISSION VEHICLES INCLUDED IN THE RECALL ACTION WERE ALL MANUFACTURED BETWEEN 11/3/2005 AND 2/13/2006.DCC WILL REPLACE THE DEFECTIVE LINKAGE WITH A COMPONENT OF A PREVIOUS DESIGN LEVEL WHICH HAS NOT EXPERIENCED FIELD FAILURE.THE TIMING OF DCC'S ACTION HAS NOT BEEN DETERMINED.ACCORDINGLY, THIS PRELIMINARY EVALUATION IS CLOSED.
Illustration