2020 Jeep Gladiator

This is in relation to 24V – 652. I know this has been a recall for other models built in the same year, but the recall is not on my particular Jeep for some reason. I am having the exact same issue. The instrument cluster panel has gone out and does not work and needs to be replaced. It is the same issue that is being had with a 3.5 screen, but it is now happening on the Rubicon edition, and it is not under the recall which does not make any sense. Can you please help me with this

Driving down the highway at normal rate of speed, the engine light came on and then started blinking and I loss power in the engine. After about 10-15 seconds, the engine light went off and the engine regained power. A few minutes later, the same thing occurred. In the mornings when the engine was cold, the engine would sputter when idling and the check engine light would come on. The dealership mechanics found the problem to be the cam shaft lobe being scored causing piston #5 to misfire. The dealership told me that there are 12,000 backlogged requests for this part. In other words, there is a known defect in the cam shaft. The price of repair is over $4000. This needs to be a mandatory recall by the manufacturer!! 12,000 back logged requests for this part? Really? This is a safet issues because of the engine power loss while driving down the highway. My truck was in the shop at the dealership for 41 days. Ridiculous.

The 7" Instrument Panel Cluster (IPC) began flickering constantly in January 2025 then stopped turning on altogether in May 2025. A similar issue led to safety recalls for Jeep Gladiators and Wranglers with 3.5" IPCs. This is much more concerning for owners with 7" IPCs, as these versions do not have analog temperature and fuel gauges. A dealership (Bayside King George, VA) first observed the flickering when test driving the vehicle after performing the last safety recall. I have not brought the vehicle back since the display stopped turning on because dealerships regularly charge ~$2,000 and hold the vehicle for an extended period to fix this with a replacement IPC. Losing the digital speedometer and ability to observe what speed the cruise control is set to, fluid temperatures, tire pressure, and battery voltage is very concerning, and it is puzzling why Jeeps with 7" IPCs, which are harmed more due to this fault, were excluded from this recall. While searching forums about this issue, it was apparent that this was a widespread issue for Wranglers and Gladiators with 7" IPCs.

On May 17th 2025, I brought my vehicle to the Jeep Chrysler Dodge of Paramus (315 Rte 4 West, Paramus, NJ 07652) for the recall repair. Today, on May 20, 2025, I received my vehicle back after refusing an additional $580 charge for a hydraulic clutch master cylinder replacement, which the dealership claimed was unrelated to the recall. I declined this service due to the financial burden and my belief that the repair should be covered under the recall, but this leaves my vehicle in a potentially unsafe condition. As a Material Planning Specialist in Paramus, NJ, I rely on my Gladiator for daily commuting, and operating it with a damaged component poses significant risks. The repair delay, while only three days and not yet qualifying for New Jersey’s Lemon Law, has resulted in my vehicle being returned without addressing a critical safety issue. During the repair, the dealership informed me that the hydraulic clutch master cylinder is damaged and requires replacement at an additional cost of $580, claiming it is unrelated to the recall. However, when I spoke with the service manager on May 20th, they admitted they have no evidence that the master cylinder damage is not due to the recalled clutch pressure plate. Given the recall’s documented risk of the pressure plate fracturing and causing collateral damage to nearby components (e.g., transmission case), I believe the master cylinder failure is likely a direct result of the defective clutch system. The recall repair should cover such related damages, yet the dealership refuses to include this repair under the recall’s scope without providing a clear explanation or diagnostic evidence.

While driving in rush hour traffic, stop and go driving, a service shifter message started to intermittently appear, then the forward collision warning message started to frequently chime in and off, then I lost power steering, check engine light illuminated, other messages auto start stop service, service sway bar disconnect, transmission was stuck in 3rd gear then after a stop it would not shift out of 1st even switching to manual shift mode, was able to pull over to side of road. Turned off the vehicle, used my code reader to clear the codes, started the vehicle back on and everything was clear and vehicle drove as normal. Sure glad it didn’t happen at speed! I have read of other people having the same issue so I wanted it to add my concern as well.

On [XXX], the cluster of my 2020 Gladiator JT turned black. After searching similar issues online, I found that there is an NHTSA Recall Number: 24V-652, Manufacturer Recall Number: 30B that affects Models: 2020–2024 Jeep Gladiator. The Issue is summarized as follow: " The IPC may experience an internal short circuit, leading to a blank screen. This malfunction prevents the display of critical information such as speed, fuel level, and warning indicators, posing a safety risk". This is exactly what I am experiencing with my car. I entered my VIN number [XXX] on the NHTSA website but my car has no recalls. I'd like to file a formal request to have this VIN number included in the recall so I can get this issue fixed rapidly. This is a safety hazard as it distract the driver's attention and is in violation of federal motor vehicle standard 101. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The 2020 Jeep Gladiator dash Cluster failed on January 28. 44,267 miles, off warranty of 3 years, 36000 miles. No off roading to date. Deemed unsafe to drive by dealer. Part through Chrysler has been "ETA'd" a month at a time, despite weekly updates. I believe this should be reported and investigated throughout the consumer purchases. No warning, driver display went black while driving down the interstate. No idea on gas level, had analog speedometer and RPM, thankfully, but I was 40 miles from my dealer. Manufacturer to date has not "inspected" my Gladiator. They only contacted the dealer to indicate they are "expediting" my part order. Vehicle is available for inspection. It has been sitting outside on the dealer lot since Jan 28, 2025. It was never subjected to the elements prior to this incident: always garaged.