2019 Jeep Cherokee

URGENT: Date of near life & death situation.10-6-2023.This 2019 KL Cherokee lost accelerating power while in heavy traffic. As the car was losing speed the "D" drive indicator on center dash started flashing a moments later 2 messages displayed: Msg 1: Service transmission Restart in Park with vehicle @ zero speed. Msg 2: Shift to park or neutral Press brakes and select gear. (Center dash is the screen between tachometer and speedometer) Followed instructions, turned key to off position for a few seconds then started engine placed shifter in drive, accelerated engine to 2000 RPMs, car failed to move. Turned key off a second time, waited about 18 seconds for the mileage readout to clear then another 6 seconds (+-) for the outline light bars for the center screen to clear. Then when started it engaged a drive gear. Even in residential areas there are large trash trucks and large delivery trucks hurrying about, added to this vehicle faulting in roadway much less a center lane on the interstate with no time to pull out of traffic. Don't trust the car seat and booster seat even with air bags to save your children. Action is required to remove these vehicles from service after it has been proven the manufacturer cannot supply the dealership with a successful repair for a well documented failure of a common safety hazard in many of their vehicles. The dealership did not duplicate the problem but did confirm all of the information supplied them matched with the faults stored in PCM Memory. Not being able to duplicate leaves the Technician with just an image of the perils these faults puts the operator and public in, Catastrophic. No specific component could be proven at fault, with vehicle operating normal. After a diagnostic fault code retrieval the option was to allow them to spend maximum 6 hours in electrical testing to verify integrity of electrical connections and components. Trust and confidence in an organizations leadership to accept responsibility for mistakes

The contact owns a 2019 Jeep Cherokee. The contact stated that the vehicle randomly accelerated. The RPM had increased to a high level. The 4WD service message was displayed. The vehicle was taken to the local dealer, where it was diagnosed that the PTU needed to be replaced. The vehicle was repaired, but the failure recurred. The contact stated that while driving at an unknown speed, there was an abnormal dinging sound. There were no warning lights illuminated. The vehicle was taken to the same local dealer, where it was determined that the PTU was blocked and not working. The vehicle was not repaired. The manufacturer was not contacted. The failure mileage was approximately 114,000.

The car lost acceleration power when driving, showed no codes, and displayed a message to shift to park and restart car. This incident happened twice including after the car was taken to the dealer, who could not find anything wrong with the car. A google search revealed several 2018 vehicles with that problem and a recall for 2017 models and earlier; however, the 2018 model has not been recalled and should be.

Hello -- My Jeep has had a repetitive issue with the Start/Stop system since I took ownership. In recent months, my vehicle has stalled on two separate occasions by completely shutting down at a stop light. First the "hood switch is open" alert comes up, then an emergency braking alert comes up, all while the vehicle completely shuts off as I am accelerating. This is extremely dangerous as it could definitely cause an accident as I'm mid-intersection. I have taken my vehicle to Jeep to complain of the issue, but they have let me know that the vehicle is not recording the error codes and there is nothing to be done. They literally send me home to continue driving it and have the stalling happen again. I have done extensive research and found that I am not the only Jeep owner with this issue. In fact, they have also gone through very similar frustrations with the dealership as they state there is nothing to be done. From my research it looks like it could be the IBS connector (intelligent battery sensor), but it also could be a poor electrical system. Please help.

On saturday 3/5/22 around 2:30 pm i was driving and the engine shut off on midlle of street. No warning or any previus signs. On sunday 3/6/22 i got a low oil presure warning ligth. The safety of my family and any person around us was at risk becouse my vehicle was in movement, it could have couse an accident luckily i was driving in a street at low speed if it had happened at high speed it could be really bad. There was not an accident for police to report and today is sunday so the jeep corporation does not work on sundays, so no one have inspected the problem. Like i stated on the day after the engine shut off i got a low oil pressure warning light on the dashboard. I have read some information on internet of issues were the tiger jeep engine shuts of and couses serius accidents and i am concern for my familly safety while using the jeep. Last time i had this issue the jeep company was supposed to fix the issue of engines shutting down with the recall. Please help solve this problem before someone get into a serius accident.

The P2122 OBD-II trouble, or fault, code means that the vehicle's on-board computer has detected low voltage in the throttle position sensor (TPS), which is usually below 0.17 volts. The battery is also at 8.3 volts indicating a potential short somewhere and potentially a faulty alternator. This is not what you want while driving a vehicle.

In January of 2021 I was driving my vehicle out of the car wash when it suddenly accelerated on its own across a busy roadway out of the parking lot. The vehicle was going 65 MPH without my foot on the gas. I had to keep my foot on the brake to control its speed and get myself to work that way. I got the car to stop in those parking lot and put the vehicle in Park. The RPMs shot up to 5000, the Stop Start and a couple of other warning lights were on. I shut the vehicle off, restarted it and then it was fine as if nothing ever happened. After work I brought the vehicle to the dealer, they checked the OBD computer and verified that the incident happened. They replaced some sensor and everything was fine until May 20th, 2021. On that day the vehicle started to accelerate on its own again. I immediately pulled into a Walmart parking lot, put the vehicle in Park, took a picture of the dashboard to show the dealer and turned the vehicle off. I did not run the car long enough for the warning lights to come on. I restarted the vehicle and again it was as if nothing happened. I bright the vehicle to my dealership and as of 06/08/2021 it is still there waiting on Chrysler to figure something out. The dealer cannot fix it unless they can get it to happen again because I did not run the car long enough for the OBD computer to register and record the second incident as per Chrysler’s policy.