THE GL1800 MOTORCYCLE HAS A REVERSE ON IT. THIS SHOULD ONLY BE ALLOWED TO ENGAGE, WHEN IN NEUTRAL & NEVER WHILE RUNNING. I FOUND A CIRCUMSTANCE THAT ALLOWED IT TO START ENGAGING, AND POSSIBLY COULD HAVE BEEN DISASTROUS HAD I NOT ACTED QUICKLY. THE STEPS FOR THIS ARE: -BIKE IS IN 1ST GEAR -BIKE IS STARTED -THE REVERSE SWITCH I…
Read full complaint
THE GL1800 MOTORCYCLE HAS A REVERSE ON IT. THIS SHOULD ONLY BE ALLOWED TO ENGAGE, WHEN IN NEUTRAL & NEVER WHILE RUNNING. I FOUND A CIRCUMSTANCE THAT ALLOWED IT TO START ENGAGING, AND POSSIBLY COULD HAVE BEEN DISASTROUS HAD I NOT ACTED QUICKLY. THE STEPS FOR THIS ARE: -BIKE IS IN 1ST GEAR -BIKE IS STARTED -THE REVERSE SWITCH IS ACCIDENTALLY HIT WHILE PRESSING THE START BUTTON (RIDING GLOVES MAKE THIS SOMEWHAT SIMPLE IN THE DARK - IT IS LOCATED RIGHT BY YOUR STARTER AND YOUR CRUISE CONTROL BUTTONS) -YOU TAKE OFF IN 1ST GEAR (IN MY SCENARIO I WAS STRAIGHT, THEN WAS TAKING OFF AND MAKING A SOMEWHAT RIGHT SHARP TURN) -BEFORE THE BIKE IS STRAIGHTENED COMPLETELY (BUT MOSTLY), YOU TRY TO SHIFT TO 2ND GEAR -NEUTRAL WHICH IS RIGHT IN BETWEEN 1ST AND 2ND SEEMED TO GRAB HOLD AND NOT LET ME GO INTO 2ND -REVERSE ENGAGED WHILE AT SPEEDS OF 10-20 MPH -REVERSE STARTED WHINING/ENGAGING, LUCKILY I GOT IT OFF QUICKLY (~1 SEC) WHEN REALIZING I WAS NOW IN NEUTRAL AS IT DIDN'T SEEM TO LET ME GET TO 2ND, AND SEE THE 'R' LIGHT ILLUMINATED -YOU COULD SMELL THE MATERIAL WHERE IT HAD "GROUND" I TRIED REPORTING THIS TODAY TO HONDA, AND THEY SEEMED TO BLOW IT OFF. I SPECIFCALLY ASKED IF IT WAS JUST A FLYWHEEL TYPE ITEM OR IF IT WAS TRUE GEARS THAT WOULD ENGAGE. THEY NOTED IT WAS GEARS. THIS CONCERNS ME EVEN MORE AS THIS COULD HAVE CAUSED A SERIOUS BIKE ACCIDENT (LUCKILY IN MY CASE IT DIDN'T GET THAT FAR AND NOBODY WAS BEHIND ME). *TT
American Honda Motor Co., Inc. (Honda) is recalling certain model year 2001-2010 and 2012-2015 GL1800, 2001-2005 GL1800A and 2013-2015 GL1800B motorcycles. The rear brakes of the affected motorcycles may drag after the brakes are released.
Consequence & remedy
Consequence: A rear brake that drags may increase the risk of a vehicle crash. Additionally, extended riding with the rear brake dragging could generate enough heat to result in a fire.
Remedy: Honda will notify owners, and dealers will replace the secondary brake master cylinder and the rear brake master cylinder, and flush the brake fluid, free of charge. The recall began on December 7, 2015. Owners may contact Honda customer service at 1-866-784-1870. Honda's number for this recall is JV6. Note: This recall supercedes recall 14V-472.
HONDA IS RECALLING CERTAIN MODEL YEAR 2001-2010, AND MODEL YEAR 2012 GL1800 GOLDWING MOTORCYCLES. UNDER CERTAIN CONDITIONS, THERE IS A POSSIBILITY THAT THE COMBINED BRAKING SYSTEM'S SECONDARY MASTER CYLINDER MAY CAUSE THE REAR BRAKE TO DRAG.
Consequence & remedy
Consequence: UNEXPECTED BRAKING INCREASES THE RISK OF A CRASH, AND RIDING THE MOTORCYCLE WITH THE REAR BRAKE DRAGGING MAY GENERATE ENOUGH HEAT TO CAUSE THE REAR BRAKE TO CATCH FIRE.
Remedy: HONDA WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT THE SECONDARY MASTER CYLINDER AND IF NECESSARY, REPLACE IT, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 6, 2012. OWNERS MAY CONTACT HONDA CUSTOMER SERVICE AT 1-866-784-1870.
ON SOME MOTORCYCLES, CERTAIN FRAME WELDS DO NOT MEET MANUFACTURING SPECIFICATIONS. HIGH LOADS CREATED WHEN RIDING ON ROUGH ROAD SURFACES OR THROUGH POTHOLES CAN CAUSE THE AFFECTED WELDS TO CRACK.
Consequence & remedy
Consequence: THE WELDED AREA COULD BREAK, RESULTING IN REAR SUSPENSION COLLAPSE OR LOWER CROSS MEMBER SEPARATION, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT AND, IF NECESSARY, REINFORCE THE WELDS ON 2001-2002 MOTORCYCLES FREE OF CHARGE. ON 2003-2004 MOTORCYCLES, THE UNITS WILL BE REPAIRED, NO INSPECTION WILL BE NECESSARY. THE RECALL BEGAN ON FEBRUARY 9, 2005. OWNERS MAY CONTACT HONDA AT 1-866-784-1870.
CERTAIN MOTORCYCLES EQUIPPED WITH COMBINED-BRAKE SYSTEMS HAVE A PROPORTIONING CONTROL VALVE (PCV) THAT MECHANICALLY PROPORTIONS BRAKE FORCE WHEN THE REAR BRAKE IS APPLIED. A SEAL IN SOME PCVS IS IMPROPERLY SHAPED, AND BRAKE FLUID LEAKAGE MAY OCCUR.
Consequence & remedy
Consequence: IF THE MOTORCYCLE CONTINUES TO BE USED AFTER A LEAK OCCURS, THE REAR BRAKE WOULD EVENTUALLY BECOME INOPERATIVE. A LOSS OF REAR BRAKE FORCE COULD INCREASE THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT THE REAR BRAKE FORLEAKAGE. IF LEAKAGE IS CONFIRMED, THE DEALER WILL REPLACE THE PCV FREE OF CHARGE. THE RECALL BEGAN ON JANUARY 31, 2005. OWNERS MAY CONTACT HONDA AT 866-784-1870.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2
AQ12001 · Southern Honda Powersports
Opened May 14, 2012 · Closed May 13, 2013
Status: closed (inferred from source dates) · Unknown Or Other
NHTSA opened Audit Query (AQ) 12-001 to determine whether Southern Honda Powersports (Southern Honda) of Chattanooga, Tennessee, had complied with the requirements of the National Traffic and Motor Vehicle Safety Act, as amended, 49 U.S.C. Chapter 301 (Safety Act) and its implementing regulations. The Safety Act requires, among other things, that a motor vehicle or equipment manufacturer notify its dealers of defects related to motor vehicle safety and non-compliances with federal motor vehicle safety standards.In turn, a dealer may not sell and deliver a new vehicle subject to a recall unless the recall remedy has been performed.(see 49 U.S.C. 30120(i); 49 C.F.R. 573.11)NHTSA issued an information request to Southern Honda on May 14, 2012 to which they responded on July 6, 2012.NHTSA?s inquiry led it to believe that Southern Honda had failed to complete the requirements of five recalls that required inspections and/or repairs of motorcycles prior to their sale or delivery.NHTSA believes that 329 motorcycles affected by recalls had not been inspected and/or repaired prior to their sale and delivery between 2007 and 2012.The agency is unaware of any deaths or injuries involving these vehicles.NHTSA concluded that it had a potential civil penalty claim against Southern Honda for violations of the Safety Act.Southern Honda denied any violations of the Safety Act.In order to settle this matter, Southern Honda agreed to pay a civil penalty in the amount of $125,000, to be paid in five annual installments.This AQ is closed.
RQ04009 · Frame Crossmemeber Weld Failures
Opened Sep 21, 2004 · Closed Feb 2, 2005
Status: closed (inferred from source dates) · Structure:frame And Members
HONDA IS AMENDING THE SCOPE OF 03V-350 TO ADD 34,919 POTENTIALLY AFFECTED GL1800 GOLD WING MOTORCYCLES.THE INITIAL RECALL RANGE INCLUDED FRAMES MANUFACTURED WITH ONE OF A NUMBER OF WELDING PROCESSES.HONDA BELIEVED, ON THE BASIS OF DATA AVAILABLE AT THAT TIME, THAT ONLY THOSE GL'S BUILT WITH THAT ONE PROCESS WERE AT RISK OF FAILURE.WITH THE ORIGINAL RECALL (IN SEPTEMBER, 2003), HONDA INTRODUCED YET ANOTHER WELD PROCESS.SUBSEQUENTLY, HONDA BECAME AWARE OF INCIDENTS INVOLVING GL'S NOT INCLUDED IN THE ORIGINAL RECALL, BUILT USING ANOTHER EARLY WELDING PROCESS.THUS, HONDA HAS DECIDED TO RECALL ALL GL1800'S BUILT PRIOR TO SEPTEMBER 20, 2003 REGARDLESS OF WHAT WELD PROCESS WAS BEING USED AT THE TIME.THIS RECALL EXPANSION AFFECTS THE 2001, 2002, 2003 AND 2004 MODEL YEARS AND THE TOTAL NUMBER OF AFFECTED U.S. GL1800 MOTORCYCLES INCREASES FROM 8,196 TO 43,115.
2004 Honda GL1800 Problems, Complaints & Recalls | Skip That Year
Illustration