2009 Honda Civic

TL* THE CONTACT OWNS A 2009 HONDA CIVIC. THE CONTACT STATED THAT WHILE TRAVELING AT AN UNKNOWN SPEED, THE DRIVER CRASHED INTO ANOTHER VEHICLE AND THE AIR BAGS FAILED TO DEPLOY. THE CONTACT STATED THAT THE SEAT BELT FAILED TO RESTRAIN THE DRIVER AND AS A RESULT, THE DRIVER HIT THE ROOF OF THE VEHICLE. THE DRIVER WAS NOT INJURED. A POLICE REPORT WAS FILED. THE VEHICLE WAS DESTROYED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE FAILURE AND CURRENT MILEAGE WAS 65,000. THE VIN WAS NOT AVAILABLE.

I PURCHASED A NEW 2009 HONDA CIVIC IN MAY OF 2009, AT THE SAME TIME I PURCHASED HONDA FLOOR MATS FOR MY CAR. THE DRIVER SIDE FLOOR MAT HAS TWO RETENTION HOLES IN IT AND IS RETAINED BY TWO PLASTIC HOOKS THAT ARE MOUNTED ON THE FLOOR. THE HOLES IN THE MAT DUE TO NORMAL WEAR AND TEAR HAVE RIPPED AND NOW THE MAT SLIDES UNDER THE GAS PEDAL OF MY CAR, WHICH CAUSES ACCELERATION PROBLEMS WITH THE CAR. I CONTACTED HONDA AT 1-800-999-1009 ABOUT THIS SAFETY CONCERN (CONFIRMATION NUMBER:N012014-05-2901759). THEY INFORMED ME THAT THE CAR IS OUT OF WARRANTY 3YR/36000 MILES AND THEY COULD NOT OFFER A RESOLUTION TO REPLACE THE MAT. THIS IS A SAFETY PROBLEM, WHICH IS SIMILAR TO THE TOYOTA FLOOR MAT PROBLEM FROM A COUPLE OF YEARS AGO. *TR

I WAS HIT ON THE PASSENGER SIDE OF THE CAR BY AN SUV. THE REPAIRS WERE WITH GENUINE HONDA PARTS BUT EVER SINCE THEN THE FRONT CONTROLS WHERE THE RADIO IS HAS BEEN EXTREMELY HOT. ALMOST TO THE POINT I THINK I BURN MY HANDS TO CHANGE THE RADIO STATION. I THINK IT MAY BE HOT ENOUGH TO START A FIRE WITH MELTING THE CONTROLS IN THE BACK. I HAVE BEEN TOLD THERE IS NOTHING THAT CAN BE DONE OR IT WILL COST ME A LOT OF MONEY TO DIAGNOSE IT. I JUST SEE IT AS A SAFETY ISSUE TO HAVE THE DASH SO HOT IT BURNS PEOPLE. THE PASSENGER AIRBAG DID NOT DEPLOY IN THE CRASH AND POSSIBLY SHOULD HAVE. *TR

TL* THE CONTACT OWNS A 2009 HONDA CIVIC. THE CONTACT STATED THAT WHILE DRIVING AT AN UNKNOWN SPEED, THE FRONT DRIVER'S SIDE TIRE DEFLATED AT RANDOM WITH THE ILLUMINATION OF THE TIRE PRESSURE WARNING LIGHT. THE WARNING LIGHT REMAINED ILLUMINATED AFTER THE CONTACT ADDED AIR TO THE TIRE. THE VEHICLE WAS TAKEN TO AN AUTHORIZED DEALER WHERE IT WAS DIAGNOSED THAT THE O-RING FAILURE WAS CAUSING AIR TO LEAK OUT OF THE TIRE. THE O-RING WAS REPLACED HOWEVER, THE TIRE PRESSURE SENSOR LIGHT ILLUMINATED AFTER THE REPAIR. THE FAILURE WAS RECURRING. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 13,000.

RIGHT DRIVE SHAFT POPPED OUT FROM THE REAR DIFFERENTIAL AFTER SWITCHING GEAR FROM R TO D WHILE THE DRIVER WAS TRYING TO GET OUT OF THE DRIVE WAY. THE CAR WENT INTO ROLL IN PARK SITUATION. THE CAR IS AT RELATIVE LOW MILEAGE AND HAVE NO PREVIOUS ACCIDENT. A FAULTY DRIVE SHAFT ASSEMBLY COULD BE REALLY DANGEROUS IF THE INCIDENT WAS HAPPENED ON THE ROAD. *TR

I BOUGHT A SET OF CONTINENTAL PROCONTACT TIRES 205/55/16 FOR A HONDA CIVIC. ON 12-12-13 AND DROVE TO HARRISONBURG VA ABOUT 200 MILES ON 12-17-13. THAT NIGHT THE TIRE PRESSURE INDICATOR LIT UP SINCE IT WAS LATE WE WAITED UNTIL MORNING TO CHECK THE TIRE AT WHICH TIME IT WAS FLAT. EMBEDDED IN THE TIRE WAS A WIRE GOING FROM NEAR THE WHEEL ALONG THE SIDEWALL TOWARD THE TREAD. IT WAS ABOUT 5 INCHES IN LENGTH AND ABOUT 0.125 INCHES IN DIAMETER. BOTH ENDS WERE IN THE TIRE AND THERE APPEARED TO BE A SLICE IN THE SIDEWALL BENEATH THE WIRE. WENT TO WALMART WHERE THE TIRE WAS EXAMINED, THEY PULLED ONE END OUT BUT THE OTHER DIDN'T BUDGE. HAD TO GO TO ANOTHER STORE FOR THE REPLACEMENT. THEY WERE ALSO NOT ABLE TO PULL THE WIRE OUT. UPON RETURNING HOME I TOOK THE DAMAGED TIRE TO THE STORE IT WAS ORIGINALLY PURCHASED FROM. THEY CONTACTED CONTINENTAL AND I RECEIVED A FULL REFUND AND THE TIRE WAS RETURNED TO CONTINENTAL. UPON EXAMINATION IT SEEMED THAT THE WIRE WAS EMBEDDED IN THE TIRE DURING MANUFACTURE AS EVIDENCED BY THE "SLICE" IN THE SIDEWALL FROM WHICH THE WIRE EMERGED WHILE DRIVING LEADING TO AIR LOSS, THE IMPOSSIBILITY OF PULLING THE WIRE FROM THE WHEEL AREA AND THE ABSENCE OF PENETRATION OF THE WIRE ON THE WHEEL ASPECT.. I DO HAVE PHOTOS OF THE WIRE AND SIDEWALL AND TIRE INTERIOR SHOWING THE ABOVE. MY STRONG FEELING, AND THAT OF THE ORIGINAL TIRE SHOP, WAS THAT THE WIRE WAS MOLDED INTO THE TIRE DURING MANUFACTURE. THE DIAMETER OF THE WIRE WAS MUCH GREATER THAN STEEL MESH WIRE. MOST LIKELY THE WIRE WAS FORCED TO THE SURFACE AS A CONSEQUENCE OF TIRE COMPRESSION DURING THE DRIVE. I ALMOST FEEL THAT IT WAS INTENTIONALLY ADDED TO THE MOLD BECAUSE OF THE LENGTH AND POSITION AS WELL AS THE DIAMETER. *TR

2009 HONDA CIVIC 4 DOOR SEDAN, BOUGHT BRAND NEW ? WITHIN THE FIRST 30,000 MILES, THE CAR BEGAN TO HAVE INTERMITTENT PROBLEMS WITH STARTING IN LOWER TEMPERATURE WEATHER (50 AND BELOW). CAR ENGINE WILL CRANK AND FAIL TO TURN OVER IF LEFT IN COLDER TEMPERATURE FOR MORE THAN 12 HOURS, I HAVE INSTALLED A NEW BATTERY AND THE PROBLEM HAS PERSISTED. BROUGHT THE CAR INTO THE DEALER AND THE STARTER, ALTERNATOR, FUEL PUMP, BATTERY, EVERYTHING WAS ?FINE.? PROBLEM CONTINUES TO THIS DAY AND HONDA HAS NEVER BEEN ABLE TO ANSWER WHY. *TR

2009 HONDA CIVIC SEDAN EX WELL MAINTAINED. PAINT AND CLEAR COAT FADING AND PEELING AT 1/2012. I OWNED THE CAR ONLY 3 MONTHS UPON ONSET OF THE ISSUE. I HAVE NOTED THAT THIS YEAR HAS BEEN STATED TO HAVE THESE ISSUES AND WILL TAKE TO LOCAL HONDA DEALERSHIP WITH BODYSHOP TO REVIEW AND ASSIST. THIS CAUSES THE CAR TO LOOK VERY OLD. UNABLE TO POLISH OR WAX TO HALT THE ISSUE. UNSURE WHY IT BEGAN BEYOND WHAT THE FORUMS HAVE NOTED BY OTHER DRIVERS PER THE PAINT AND CLEAR COAT USED BY HONDA WAS NOT LASTING. *TR