2025 GMC Yukon

The contact owns a 2025 GMC Yukon. The contact stated that while driving at an undisclosed speed, the vehicle unexpectedly went into LIMP Mode with a limited speed availability message displayed. The vehicle was restarted; however, the failure recurred. The vehicle was taken to the dealer, where it was diagnosed with engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 8,837

While driving on a highway, the vehicle intermittently suffers a sudden loss of engine power during acceleration, accompanied by a flashing check engine light. The most serious event occurred while merging into traffic when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. Pulling over and restarting temporarily restores normal acceleration, but the problem recurs. The malfunction appears consistent with an engine misfire/powertrain fault. An OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and often occurs after approximately 10–45 minutes of driving. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times. Dealers reported they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been evaluated through authorized service channels, but the underlying cause has not been identified. This remains a safety hazard because it reduces acceleration in traffic. Incident list: • 10/25/2025 (~12:25 PM; ~3,108 miles): Loss of power while merging; flashing CEL; restart temporarily resolved. • 10/27/2025–11/04/2025: Intermittent recurrence, usually lasting a few minutes then clearing. • 11/05/2025 (~8:01 AM; ~3,641 miles): Flashing CEL and misfire/loss-of-power symptoms; taken for service. • 11/26/2025 (~10:06 AM): Another episode consistent with the same pattern. • 12/17/2025 (~8:21 AM): Another episode, including during travel to a service visit. • Ongoing: Episodes after ~10–45 minutes; sometimes requires restart to restore drivability. Observed codes: P0300 and P0301. Safety risk: loss of power during acceleration/merging increases risk of rear-end or side-impact collision.

2025 Yukon Denali - Purchased in July of 2025 Specifically to pull air stream trailer. Vehicle Was equipped with necessary tow package for this purpose! #1 problem: Went into limp mode, stopped in traffic, towed to dealer. One week to repair and replace fuel system. ( under 700 Miles ) #2 Problem: Went into limp mode while pulling trailer, vehicle lost all the transmission fluid on ground. In shop sixteen days waiting for new transmission parts. ( Under 700 Miles ) #3 Problem: Vehicle stopped in traffic, towed to dealer where it was determined it needed new engine. In shop Nov 27, 2025, still in shop as of Jan 14, 2026. No ETA on engine or delivery. ( Under 2000 Miles ) #4 Problem: During last failure attempt to use "on star" failed, still not resolved. This vehicle is a danger to the owner and its passengers as well as others when it simply stops working in the middle of a busy highway with a 23' trailer in tow. Not to mention I have $160,000 invested in a car and camper I have yet to be able to use.