2024 GMC Yukon Xl

6/16 Vehicle issues while driving home from work. Rough idle, multiple check engine lights coming on, Multiple warnings display on dashboard. Vehicle in limp mode from work to home. 6/20 While driving in Roanoke rough idle began. Vehicle check engine light appeared, limp mode only lasted for less than 30 seconds before it went back to normal. 6/23 Vehicle issues began again while driving to work. Pulled into parking lot, turned vehicle off and restarted. Vehicle seemed back to normal. Made appointment through GMC App for first available on 6/29. Leaving work vehicle check engine lights came on again and went into limp mode. 26,764 miles. Drove straight over to Hart GMC (2 miles away) and dropped it off. 6/30 Picked up Vehicle at Hart GMC. Miss fire on cylinder #3. Replaced spark plug #3 and cleared all dtcs codes. 8/6 Oil Change with Consumption Test started 29,072 miles 8/28 Engine Oil Low-Add Oil alarm. Instructed by dealer to not tamper with Test. Must drive 2000 miles before returning vehicle to validate consumption test. 29,728 miles 8/30 Pulling into drive way rough idle began. Vehicle check engine light appeared, limp mode, multiple lights. Scanned with OBD2 scanner- P0303 code. Misfire cylinder 3. 8/31 Vehicle towed from home to Hart motors 29,860 miles. Scanned by service showing P0300 codes along with other codes. I have documented all events with this engine since owning. Concerned the engine would run out of oil before validating consumption test (2000 miles). Dealer told me to keep driving even if it says add oil. Engine historically 2 qts low when add oil warning flashes.

On August 20, 2026, while driving my 2024 GMC Yukon XL Denali equipped with the 6.2L V8 engine at approximately 70 mph on the interstate, the vehicle experienced a sudden and complete loss of motive power without adequate warning. The vehicle unexpectedly shifted into neutral and would no longer accelerate or maintain highway speed. This occurred in active interstate traffic and almost resulted in a serious accident as I attempted to maneuver the vehicle out of the flow of traffic. The engine would not restart, and the vehicle had to be towed to a GMC dealership. The GMC dealership subsequently diagnosed that the engine had locked up and determined that the engine requires complete replacement. This failure created an immediate and significant safety hazard for me, my family, and surrounding motorists. My vehicle is affected by the 6.2L engine recall, and I am extremely concerned about the safety and reliability of the proposed replacement engine. I have become aware of reports from other owners alleging failures involving replacement engines as well, including similar sudden losses of propulsion. I am concerned that replacing the engine may not adequately address the underlying safety risk if replacement engines are experiencing similar failures. I am requesting that NHTSA investigate not only the original engine failure, but also whether replacement engines used as a remedy are adequately correcting the defect. A sudden engine lockup and complete loss of propulsion at interstate speeds presents a serious risk of collision, injury, or death.

Driving on highway at 80 MPH and accelerator stopped working and car turned off. We had to coast off toll rd and hope for the best. No warning and happened with our whole family in the car. I had a recall notice from manufacturer but last time I tried contacting manufacturer/dealer they said no resolution was available to repair recall yet and that I couldn’t drop off my vehicle.

1.XXX XX— GM Recall Notification (Recall No. N252494000) I received official notification from General Motors of Recall N252494000 affecting my vehicle. I brought the vehicle to [XXX] as directed to have the recall remedy performed. 2. XXX — First Report of Engine Propulsion Issues I reported engine propulsion concerns to Jim Ellis. This was my first formal complaint regarding the performance of the vehicle following the recall remedy. 3. XXX — Oil Type Change Performed by Jim Ellis Jim Ellis performed an engine oil type change, switching to 0W-40 oil, and advised me that this change would serve as the fix for Recall N252494000. I accepted this remedy in good faith. 4. XXX — Low Oil Warning Light Activated Approximately nine months after the recall remedy, and well before the end of the recommended oil life cycle, the low oil warning light activated on my dashboard. This is abnormal and indicative of excessive oil consumption. I returned to Jim Ellis, who performed a fresh oil change and placed my vehicle on a 6,000-mile oil consumption test — an acknowledgment that an oil consumption problem exists. 5. XXX — Active Engine Misfires, Jerking, and Flashing Check Engine Light While operating my vehicle on Sunday, May 31, 2026, I experienced severe engine jerking and misfires. The check engine light began flashing — not steady — which I understand to indicate an active and serious engine misfire event. I was genuinely concerned for my personal safety and immediately parked the vehicle. It has not been driven since. 6. XXX — GM Corporate Case Opened I contacted GM Customer Care and was assigned Corporate Case Number INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

****This complaint is an addendum to ODI Complaint #11715415 **** This report updates the prior complaint to reflect complete engine seizure and pending engine replacement following post-repair loss of propulsion. I respectfully request that NHTSA include my vehicle’s failure in its ongoing evaluations related to L87 engine failures, including Recall 25V-274, Engineering Analysis EA25007, and Recall Query RQ26001. My 2024 GMC Yukon XL Denali experienced progressive internal engine failure beginning at approximately 61, 975 miles. First attempt: The vehicle required camshaft and lifter replacement due to internal mechanical damage. Immediately after 4.5 week repair, the vehicle suffered sudden loss of motive power at highway speed.  The engine shut down without warning at 75 mph with children in the car. (Car was in owners possession for no more than 15 hours, and was driven 25 miles on the highway when it switched to neutral and shut down). Second attempt: The vehicle was towed back to the dealership. Additional electrical repairs were then attempted. (Fuse box) It shut down again during dealer testing. Third attempt: Subsequent internal inspection revealed cylinders 5 and 6 seized, requiring full engine replacement. This represents: • Repeated loss of motive power • Escalation from top-end failure to catastrophic lower-end seizure • Failure occurring immediately after dealer-performed repair(s) • A 2024 model-year vehicle with relatively low mileage Given NHTSA’s ongoing investigations into post-remedy failures (RQ26001) and out-of-scope bearing failures (EA25007), I request that this incident be evaluated as part of the broader defect pattern analysis.

About 4 weeks ago my vehicle began shaking uncontrollably while driving. The check engine light illuminated and multiple warnings appeared including emissions system, variable valve timing system, engine and transmission failures shown on the GMC app. I contacted the selling dealership and was given an appointment 4 days later. Later that day I drove less than 5 miles to pick up my children from school. During that drive the vehicle filled with a strong gasoline odor and exhaust fumes were overwhelming. I feared the vehicle could catch fire. I contacted the dealership again, stated the vehicle was unsafe, dropped it off at approximately 8:00 PM and was required to obtain my own rental vehicle. After one week I was told the engine required a camshaft and lifter replacement. Inspected & approved by extended warranty, parts were ordered and installed. I retrieved the vehicle on 23 days after the initial failure. The following morning (24th day) while driving approximately 75 mph on a major interstate with my children the vehicle suddenly shifted into neutral and would not re-engage. I was unable to shift into any gear and coasted to a narrow shoulder inches from traffic and guardrail.The dashboard stated the vehicle could not shift into gear and instructed me to push the start button. The engine would not restart. We were stranded approximately two hours in 10-degree weather on a major interstate with heavy semi-truck traffic. Roadside assistance was required. 3 days later the dealership stated the failure was a fuse block. After replacement the vehicle was test driven and stated to be operating normally. A second dealership employee test drove the vehicle, it died again and had to be towed back to the dealership. The battery was replaced after draining while disabled. Repeated mechanical and electrical failures resulted in complete loss of power at highway speeds and placed my children and me in immediate danger. I no longer believe this vehicle is safe to operate.

I was driving on interstate and thank God I got off the exit and vehicle suddenly cut off. An indicator came on stating to push start to restart vehicle while the vehicle shifted to Neutral on its own. Then a Low oil pressure sign came up on dashboard. I tried push start again and nothing happened. Lucky by this time I was just off the exit so I was able to come to a stop and shift to Park. I tried push start again and the dashboard just went dark and started making a clicking noise. After some time around 1 min I tried again and it did crank up and I was able to try and get as close the the edge as possible but still in a two lane road on the bridge of an off ramp. I say thank God because 30 seconds sooner I was going around 60mph with my 4 month old in the backseat. Lucky I got to the exit when this happened. From the research I have done apparently this happens a lot to this model I have 2024 GMC Yukon Denali XL. I had a recall for this issues supposedly fixed back in October 2025. Things could of been much worse. Also this all happen coming from just having an oil change done at the dealer. Literally leaving the dealership going home. The dealership loaned me a vehicle they say for 3 days for free after that I may have to pay because it may not be covered by GM which is ridiculous. The vehicle is at the dealer and I will be waiting to hear there analysis.

I am filing this complaint regarding GM Recall N252494000 (NHTSA Campaign Number 25V274) for my 2024 GMC Yukon XL (VIN: [XXX] ). The issue involves a serious engine defect related to the crankshaft and/or connecting rods, which can result in catastrophic engine failure and loss of propulsion while driving—a clear and dangerous safety risk. I first became concerned when early reports of this issue began circulating publicly. As a father of young children, I became increasingly uneasy that my vehicle could potentially fail while in operation. Receiving GM’s formal recall letter only validated my growing concern for my family’s well-being. It’s deeply frustrating and unsettling. The notice states that parts to repair or replace the engine are not currently available, and offers no clear timeframe for when a remedy will be provided. I feel like we are being strung along while forced to continue using a vehicle that may become unsafe at any moment. This delay is unacceptable. There has been no offer of a loaner vehicle, no proactive communication from the dealer, and no assurance from GM that they are prioritizing driver safety over logistics. I am requesting that NHTSA investigate whether GM is doing enough to provide timely remedies to affected customers. I also urge you to consider whether interim solutions (such as alternative transportation or more aggressive recall execution) should be mandated. Thank you for your attention to this matter. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)