2024 GMC Sierra 2500

Trailer brake controller will intermittently stop working. “Check trailer wiring” will show up randomly on the display and no trailer braking will be available. This has happened with 3 different trailers. The trailer wiring was gone over and the issue is with the truck. Trailer brakes work with other trucks and aftermarket trailer brake controllers. GMC and dealer were notified and no fix is available. Researching online there are several complaints about this. The trailer brake signal should default to being sent similar to all aftermarket trailer brake controllers. This would be much safer rather than not sending the brake signal at all. This HD truck is rated to tow trailers over 20,000lbs and without trailer brakes it causes an extremely dangerous situation. I was forced to pull over on the highway and purchase an aftermarket trailer brake controller to continue safe travel.

The contact owns a 2024 GMC Sierra 2500. The contact stated while driving approximately 55 MPH and towing a 28-foot RV, the contact was unable to safely view the blind spot on the left and right sides of the RV using both side view mirrors. The contact stated that the failure had created a dangerous situation while changing lanes. The contact called the local dealer and was informed that the side view mirrors performed as designed, and that there was no fix for the issue. The vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 5,000.

Vehicle surges and stays at 1700 rpm in low range four wheel drive when accelerator pedal is touched Dangerous situation if someone or something is in its path. Dealer is aware of the problem but is unable to repair, says it is inherent on those vehicles for the last couple of model years. (i can't safely hook up a trailer in low range 4X4)

The contact owns a 2024 GMC Sierra 2500. The contact stated that while driving at various speeds, the two outside cabs were smoking. There was smoke detected near the fuel tank. The contact stated that there was an abnormal odor of diesel and DEF detected. There were no warning lights illuminated. The vehicle was taken to the local dealer, but the vehicle was not diagnosed or repaired. While driving, there was a lot of smoke detected from the vehicle. The vehicle was taken back to the local dealer, who was unable to determine the cause of the failure. The vehicle was not diagnosed or repaired. The manufacturer was not contacted. The failure mileage was approximately 100.

First date was 04/23/2024 my truck went into limp mode with an alert reading engine and transmission control module problem. Brought it in and they reset the sensors. Shortly after the alert warning goes off again and I turn the engine off and start it back up. It cleared the alert, I brought it back in on 06/15/2024. They reset sensor and fixed a recall on tailgate. I picked up truck, drove it for 2 months and TCM warning came up and threw truck into limp mode while pulling a 2 horse trailer. It turned a 3 hr drive into a 6 hr drive. I brought back to dealer on 8/19/2024 they had it for 4 days and they notified me that this is an on going problem. It is a transmission solenoid valve stuck open and they ordered the part and told me it could be months before the part gets here due to the ongoing backorder from all the other trucks that have the same problem. I use this truck for work and leisure to pull my boat and 2 horse trailer and now I have a vehicle payment to make and no vehicle to use. I cannot use it to work or anything else because it is at the dealer for an unspecified amount of time. I have read online that this is a major problem with this truck and GMC as well as the dealerships know about this problem and they still sold it to me. There are so many complaints online about this GMC 2500 AT4 truck problem that GMC should stop selling this truck.

I drove from California to ohio after I bought the truck, I noticed that when stopping to get gas my tailgate was open without me touching it. I drove with cameras showing the truck bed to see what happened and I watched it do it again while driving the vehicle, it just opened on its own while driving. The incident happened again once I was back in ohio when I had my trailor hooked up and it cause the tailgate to collide with the trailor tongue and dented the whole top of the tailgate.3

I purchased a 2024 GMC 2500 HD truck to pull a 2021 8,000 lb gvw camping trailer that is equipped with electric trailer brakes. My trailer has functioned perfectly related to the trailer brakes with my previous vehicle (2011 Toyota Tundra). With the GMC 2500, at approximately 3000 miles on the vehicle, a “trailer brake disconnected or disabled” and “check trailer wiring” warning began popping up on my information center of the truck. The trailer braking system would not function, though all other functions of the lighting and camera systems to the trailer worked indicating that the wiring and grounding were not an issue with the trailer. The brake system would intermittently return to normal. And then this warning and disconnected condition (i.e. no functioning trailer brakes) would return. This occurred rapidly, and very frequently. GMC has acknowledged a problem with some vehicles with this problem by publishing a TSB that purports to correct this issue (23-NA-149) that recommends replacement of the trailer brake control module (part no. 212327200000019B). I had this repair performed while on a trip in South Dakota away from my home state in Arkansas and the truck and trailer functioned as normal for approximately 3000 miles of towing. However, the issue has returned and my local GMC dealer repair shop (Little Rock, AR) places the blame on the trailer and not the truck. Towing with this 2024 GMC 2500 HD is very unsafe to the occupants and any others on the road due to loss of braking while towing a heavy load or navigating steep grades with a trailer equipped as described. This problem is now all over GMC/Chevy truck forums and is not just me or my combination. This issue is gonna get people killed.

The contact owns a 2024 GMC Sierra 2500. The contact stated that while driving at an undisclosed speed, the vehicle briefly hesitated before returning to normal functionality. The check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the transfer case seals. The vehicle was repaired, but the failure reoccurred. The vehicle was taken back to the dealer, who again diagnosed a failure with the transfer case seals. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 6,000.