2026 GMC Sierra 1500

I bought the truck brand new from Gregg Young in Atlantic, IA. While an hour into the drive home, the truck began shuttering as if the transmission was having problems finding the gear. I immediately made an appt with their parent dealership of Gregg Young in Plattsmouth, NE. They had the truck for a week and couldn’t duplicate the transmission issues after I reported several occurrences and symptoms, they also didn’t provide a service invoice of the work performed while I found was unusual. As I was driving the truck home from repairs it started hesitating and having difficulty finding gears. I didn’t think much of it since the dealer claimed there was nothing wrong. This past weekend while going 65 mph down the freeway the transmission started shuttering as well as the truck and the tires began to lock up to the point of almost losing control, there was also metal on metal noises. I had to pull over and luckily driving real slow I made it home. The Gregg Young dealership were I bought it will take no responsibility and provided falsification since no service was provided nor upon checking app gps there was no indications it left the dealership while in there possession for a week, will contact GMC in the AM since this has now become a safety issue and there was metal on metal contact noises and the serious risk of a crash.

The motor on my 2026 GMC Sierra stalled 2 weeks ago with a p0016(crankshaft position sensor issue). Was able to clear code and limp home. Vehicle did stall on a busy road and stop abruptly. Scheduled service and was advised to drive it in. Was experiencing irregular idle when warmed up, and a slight hesitation in the pedal. Service advisor started the vehicle and claimed no codes, and everything appear OK. Later in the afternoon the service advisor called to inform me that the vehicle had a siezed engine and had siezed during a test drive on the highway. Currently waiting on warranty information, and engine replacement information but i've been informed it will require a whole new engine. This is the same 6.2l L87 V8 that has been in near constant recalls from GMC over the last 6 years.

While driving at approximately 60 mph on an open road with no obstacles present and no braking input, the rear wheels spontaneously locked up without warning. No brake pedal input. No warning light prior to the event. No obstruction in the road. The vehicle has been subject to an active manufacturer recall for rear wheel lockup due to transmission control valve failure. The dealer's own diagnostic system generated a report showing six active fault codes in the following days including lost communication with the Brake System Control Module and Transmission Control Module. These codes were not addressed on the repair order. The dealer attributed the lockup to an Automatic Emergency Braking activation without diagnostic confirmation and performed no repair. The manufacturer's own internal bulletin dated January 22, 2026 acknowledges the exact fault codes present on this vehicle as a known defect. The dealer cited this bulletin to dismiss the concern while stating no problems exist. A persistent brake noise has been confirmed by two separate authorized dealers across three visits with no repair performed at any visit. The vehicle has required five dealer visits in 77 days of ownership with 1,729 miles. The defect remains unresolved and poses serious risk of loss of vehicle control at highway speed.

Vehicle stalled in busy intersection in McKinney Texas , unable to start are shift into a neutral position on transmission to remove from extreme dangerous intersection, sheriff advised that road side assistance that was contacted is not going to be in time (90min)to keep from causing an ongoing traffic backup , sheriff dispatched their own towing service to resolve the situation from getting extremely dangerous .vehicle and my wife was towed to McKinney Buick gmc dealership.

Odd noise from bell housing area at 1200 miles that went with engine rpm. Took the truck in to the dealer and they said they couldn't recreate it but to bring it back in if it returned. Jan 27th at 5200 miles on the truck, I was driving down the highway at 60mph and got a reduced acceleration message on the dash along with a check engine light. Brought it to the dealer and was informed it was a bad thrust bearing and needed and engine and turbo replacement. Still waiting for the truck to be done.

I am submitting this complaint regarding a recurring transmission issue in my vehicle. The transmission consistently jerks and shifts erratically, particularly in the morning during initial operation when at cruising speeds of about 50-75 mph. This behavior occurs when the transmission temperature is below approximately 100°F and happens on a daily basis. The gear changes feel harsh and abrupt, kind of like it doesn’t know what gear to be in its raising concerns about both drivability and long-term transmission reliability. I brought the vehicle to an authorized dealership for inspection. After evaluating the issue, the dealer informed me that the behavior was due to the vehicle being in “Sport Mode.” However, this explanation does not resolve the concern, as the severity and consistency of the jerking appear abnormal and occur regularly under the same temperature conditions. Given the persistent nature of this problem and its potential safety implications — especially during acceleration and low-speed driving — I am requesting that this issue be formally documented and investigated. Thank you for your attention to this matter.

My 2026 GMC AT4 3.0L Duramax had a catastrophic engine failure on Sunday, February 8, 2026. It went into reduced acceleration and also fault code PO6DD. Thankfully I was not on a highway. The truck would not run over 45 MPH on flat ground, and then by the time I got it to a safe location 5 miles away it would not run over about 30MPH. This obviously resulted in the truck being towed to a dealership. I have been told the entire engine will be replaced. Upon further reading, I suspect this is a thrust bearing failure that is a well-known issue in this LZ0 Duramax engine. What I have read, this issue is occurring mostly on trucks built from May-Sept 2025, and my truck has a 7/2025 build date. This could have been major safety hazard if the engine had failed in a major freeway/highway.