IllustrationCONSUMER INDICATED THAT TRANSMISSION WENT INTO LIMP MODE. WHEN THIS OCCURRED TRANSMISSION SWITCHED OVER TO SECOND GEAR AND STAYED IN THAT GEAR UNTIL VEHICLE WAS TURNED OFF. DEALERSHIP INDICATED THIS WAS CAUSED BY AN ELECTRICAL SYSTEM FUSE FAILURE RECALL 96V180000 WAS ISSUED, BUT THIS VEHICLE WAS NOT INCLUDED DUE TO VIN. *AK
1996 GMC G35
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all G35 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 1 of 1 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Electrical System. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
Electrical System complaints
1 reportsOfficial recalls
396V186000 · Electrical System:wiring:fuses And Circuit Breakers
Sep 26, 1996
WATER INTRUSION INTO THE KICK PANEL AREAS IN FRONT OF BOTH THE DRIVER AND PASSENGER DOORS CAN CAUSE A CORROSION PATH BETWEEN THE BATTERY FEED AND THE ELECTRICAL GROUND.
Consequence & remedy
Consequence: THIS CONDITION CAN CAUSE AN ELECTRICAL SHORT LEADING TO IGNITION AND COMBUSION OF THE PLASTICS IN THE ELECTRICAL COMPONENTS OF THE VEHICLE RESULTING IN A VEHICLE FIRE.
Remedy: DEALERS WILL REPLACE THE 25 AMP CIRCUIT BREAKERS WITH 25 AMP FUSES IN THE FUSE BLOCK; REMOVE A TEMPORARY PAPER FUSE-BLOCK COVER; INSTALL A PLASTIC SHIELD OVER THE FUSE BLOCK; REPLACE AND REORIENT THE POWER DOOR LOCK RELAY (IF EQUIPPED); INSPECT THE REMOTE KEYLESS ENTRY MODULE (IF EQUIPPED) FOR SIGNS OF CORROSION, REPLACE IF CORRODED, AND REORIENT IT; AND APPLY ADDITIONAL BODY SEALER IN KEY AREAS.
96V187000 · Steering:linkages
Sep 26, 1996
THE STEERING LINKAGE ASSEMBY CONTAINS A RELAY ROD TAPERED-STUD ATTACHMENT NUT THAT WAS NOT TORQUED TO PROPER SPECIFICATIONS.
Consequence & remedy
Consequence: THE TAPERED STUD CAN LOOSEN AND THE DRIVER WOULD NOTICE A LAG IN THE RESPONSIVENESS TO STEERING WHEEL INPUTS. EVENTUALLY THE RELAY ROD STUD CAN FRACTURE RESULTING LOSS OF STEERING CONTROL.
Remedy: DEALERS WILL REMOVE THE EXISTING CRIMPED NUT AND INSTALL A NEW NUT TORQUED TO SPECIFICATIONS.
96V117000 · Tires:bead
Jul 1, 1996
THESE TIRES HAVE BEAD DAMAGE WHICH OCCURED DURING TIRE MOUNTING.
Consequence & remedy
Consequence: THIS DAMAGE TO THE TIRE REINFORCING STRUCTURE IN THE BEAD "TOE" AREA CAUSES A BULGE IN THE SIDEWALL AFTER THE TIRE IS INFLATED. THIS CONDITION WILL RESULT IN A SLOW AIR LOSS CAUSING THE TIRE TO GO FLAT. HOWEVER, IT IS POSSIBLE FOR THE DAMAGE TO RESULT IN A RAPID AIR LOSS CAUSING INJURIES TO ANYONE IF THEY WERE HANDLING THE TIRE WHEN THIS OCCURRED.
Remedy: DEALERS WILL DEMOUNT EACH TIRE AND INSPECT FOR BEAD DAMAGE. IF BEAD DAMAGE IS FOUND, THE TIRE WILL BE REPLACED.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.