2016 GMC Canyon

Transmission has been shuddering since 15,000 miles till now. Dealerships says it's normal on these transmissions, 6 fluid and filter changes and now at 72,000 miles the transmission is failing just outside of warranty. They scammed me and kept my transmission barely alive until warranty ran out and now they want 8k-10k for a replacement. They knew. Dash goes crazy from the touch screen to the digital information screen in the speedometer. They say it's normal and happens on all the units. But it's distracting and has been messing up since bought the truck new. Again they just kept saying it was nothing they can do. Now they say it needs to be replaced after my warranty has run out. DEF system is failing conveniently after the warranty has run out. It's dangerous because they programmed the truck to go into limp mode when anything emissions related fails stranding me anywhere at anytime. Emission failures like sensors should not restrict travel. This is a major issue with the diesels in these trucks and they need to be forced to remove anything that's not dangerous to the health of the engine or drive train from the software or hardware from being able to restrict travel. In every situation I've been restricted to limp mode by dirty particulate sensors, but the code that pops and puts my truck in limp mode says that the NOX sensor is bad. This is false and is just a way for GM to get service at their dealers. Then they charge customers a fortune to replace parts that don't need to be replaced when you can just remove and clean the four particulate sensors and the restrictions will clear themselves shortly after. EMISSIONS RELATED ISSUES SHOULD NOT RESTRICT TRAVEL BY ANY MEANS! It is dangerous to be stranded on a trip because your emission sensors may be malfunctioning.

The contact owns a 2016 GMC Canyon. The contact stated while driving at various speeds, the steering wheel became stiff and difficult to turn. The message "Drive with Care" was displayed. The traction control warning light and an unknown warning light were illuminated. The vehicle was taken to a local independent mechanic, where it was diagnosed that the power train torque sensor needed to be replaced. An unknown local dealer was contacted. The vehicle was not repaired due to the cost. The contact related the failure to an unidentified recall; however, the VIN was not included. The manufacturer was made aware of the failure. The failure mileage was approximately 60,000.

The contact owns a 2016 GMC Canyon. The contact stated that while driving at an undisclosed speed, the vehicle lost electric power steering, and the steering wheel became difficult to steer. The contact pulled to the shoulder of the roadway and turned the vehicle off. The contact stated that upon restarting the vehicle, the power steering became operable; however, the failure recurred while driving. The power steering warning light was illuminated. The vehicle was not diagnosed or repaired by the dealer or an independent mechanic. The contact related the failure to an unknown recall; however, the VIN was not included in the recall. The manufacturer was notified of the failure and a case was filed. The contact was referred to the NHTSA Hotline for assistance. The failure mileage was 120,000.

As I was pulling away from the stop sign my power steering quit working and I was almost hit by another vehicle. The dash light flashed and said there was Drive System problems. I was able to get the truck turned back around and headed back home. I got into my garage and checked the power steering fluid and it was full. I started my truck back up and was able to drive to the dealership (Everett GMC where I purchased the truck new) The service representative said he will put it on the diagnostic machine and find out what was wrong. The next day they called me and said they found out what it was a drive gear that quit working. He said that he would get this ordered and put it in, I got a call 2 days later and said it was finished. My wife checked to see if there was a recall. There was a recall for this problem for 2015 Canyon in 2021 for the same issue. I am thinking that this issue and a very

Car repeatedly gives stabilitrack warning while driving and power steering goes out completely. It is incredibly dangerous and it appears this was a problem with the previous model year as well. This has continued to happen and looking online it looks like many owner of this year are plagued with this problem and the cost to fix is very expensive, even though it is a known recall for the previous model year.

While driving the truck's stabilitrak and power steering lights came on and I lost the use of power steering. This first happened while going 70 mph on the toll road and I almost lost control of the car it happened so suddenly. I was able to pull over and turned the truck off and back on again. The issue seemed to have resolved itself. Then a week later I was turning right into traffic and it happened again mid turn causing me to almost hit a car in the adjacent lane. It resolved itself again upon restarting the truck but has happened with each trip since. When I looked up the issue I saw that there was an issue with corrosion on the electrical part that controls these features in this particular model.

While driving, power steering system quits providing power assist. This problem is intermittent and can occur at any time without any warning and at any speed. This is a safety concern since no warning is given as to when the power steering system will fail. Have contacted local GMC dealer and was told there is a recall for the 2025 model but not the 2016. Contacted General Motors and was told the same.

4/17/2025:Approached a 4 way intersection and truck steering lost power assist. Vehicle engine still running and hard steered thru intersection. A convenience store on corner so turned wheel (manually) into parking lot. StabiliTrak light was on as well, turned key off. Re start truck and power steering good, stabiitrak light off. 4/25/2025: Driving truck and stopped at red light, truck engine stopped. Pressed accelerate pedal, no response. Turned key off and back on, started and drove normal with no problems.