2024 Ford Ranger

The incomplete recall 26V238 is a concern. They say in the letter from Ford that it could be a fire issue. It seems the harness in the A pillar gets pinched and could short out causing the overhead lighting or mirror lighting to either cause a smoke issue or fire. BUT THE ANSWER IS NOT GOING TO BE AVAILABLE UNTIL LATE JULY MAYBE!! Why send a letter and state you have no answer yet or will have for a couple of months!!! Am I supposed to be happy that I will know why the fire breaks out? Some 1400 potential failures out of 140,000 is the prediction per a conversation with your [XXX] on the chat line. This is to me a lame response to an issue with a potential for a real safety issue and should have more response than "WE ARE WORKING ON THE ANSWER AND MAYBE END OF JULY" INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The brake pedal is extremely soft and routinely travels to the floor during normal driving conditons. It also catches at various levels. It is impossible to tap the brakes to slow the vehicle down when rounding a corner which has led to several scary incidents and near misses. The truck is currently at Crossroads Ford in Indian Trail NC for 3 weeks. It has been there once before and 3 times at Town and Country Ford in Charlotte. Both dealers said this is the way the brakes are supposed to work. I was also told by a service manager that this is due to the electronic braking system and they are reluctant to spend time on troubleshooting because Ford cut their renumeration. A service Field Engineer stated that the brakes were in spec and traveled 2 3/4" toward the floor. This is a subjective observation as every person uses different foot pressure. The gas pedal is at 3" off the floor and the brakes are 5". The brake pedal passes the gas pedal and many times, my foot hits both pedals. My inspection with a ruler shows the brake pedal going 1 1/2" past the gas pedal. There were no warnings the first time this happened. I have taken the vehicle to an independent mechanic who bled air out of both rear brake lines which helped. This repair lasted 3 months and now the issue is back. I've been told by independent mechanics that the problem is in the ABS module (which pulls the pedal to the floor when activated).

My 2024 Ford Ranger XLT 2W has been suddenly losing power or stumbling upon initial acceleration. This has been occurring intermittently. My truck now has approximately 20,000 miles. The problem has become increasingly frequent. It seems to occur most often when accelerating from a complete stop. The loss of power can last for several seconds, then normal power is regained. Several times, the truck has lost power while making a left turn. It simply will not accelerate, and I find that I am stuck, unable to complete my turn and clear the oncoming traffic. I have taken my truck to a local dealer who attempted to diagnose the problem and they didn’t offer a solution since they were unable to reproduce the problem during their road test. It has happened many times since then and I am scheduled to return the vehicle to the same dealership to attempt to diagnose and fix the problem again soon. The problem seems to occur, regardless of which drive mode the truck is in and also occurs with Electronic Stability Control both enabled and disabled. There are no warning lights or check engine codes shown.

My 2024 Ford Ranger Raptor has been suddenly losing power or stumbling upon initial acceleration. This has been occurring intermittently since it was nearly new. My truck now has approximately 10,500 miles. The problem has become increasingly frequent. It seems to occur most often when accelerating from a complete stop. The loss of power can last for several seconds, then afterwards, normal power is regained. It poses a safety risk since it has nearly caused collisions. Several times, the truck has lost power while making a left turn in front of oncoming traffic. It simply will not accelerate, and I find that I am stuck, unable to complete my turn and clear the oncoming traffic. Once when accelerating away from a stoplight, the truck lost power, and I was nearly struck by following vehicle. I have taken my truck to a local dealer who attempted to diagnose the problem and they didn’t offer a solution since they were unable to reproduce the problem during their road test. It has happened many times since then and I am scheduled to return the vehicle to the same dealership to attempt to diagnose and fix the problem again soon. The problem seems to occur, regardless of which drive mode the truck is in and also occurs with Electronic Stability Control both enabled and disabled. There are no warning lights or check engine codes shown.

The contact owns a 2024 Ford Ranger. The contact received notification of NHTSA Campaign Number: 24V597000 (VISIBILITY); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. The VIN was unavailable.

I received a letter several months ago for: Manufacturer Recall Number25C41 NHTSA Recall Number25V541 I called the Ford dealership to schedule the recall repair and they told me parts were not available. I explained to them I had a recall letter stating parts were now available and to schedule the repair. The dealer said they had the parts on order and they have not received any yet. I asked them if I could get put on their schedule for when parts came in and they agreed. They said they would call me as soon as they had parts to make the repair. Meanwhile, I received another recall letting from Ford saying parts are available, please schedule the repairs. I have been calling Ford recall hotline and the Ford dealership for over two months trying to get the safety recall repairs completed. They will not fix my compromised airbags and I am not getting any support from Ford to get this resolved.

I came up to a stop sign on a snow cover highway. When I applied the brakes my ABS brakes came on, but instead of slowing down, I felt the vehicle accelerating instead. I was pushed into the middle of the intersection and involved in an accident. An accident report was filed with the state of Wisconsin. No injuries occurred. I mentioned the problem to the Ford dealer, but they said there was no recall notice on file. An insurance adjuster inspected the damage to my vehicle last week. I have made an appointment with a body shop in February. I have not driven the vehicle since the accident. There were no warning messages before the accident.

I am the original owner of this vehicle and the engine and controls have not been modified in any way. Yesterday while driving at approximately 30 mph on a surface street with dry road conditions in the “2H” setting on the Drive Modes Selection Dial my truck spontaneously shifted into four-wheel drive high and then attempted to switch into four-wheel-drive low – “Rock Crawl Mode.” The rear differential locked, speed was suddenly reduced, and the steering became more difficult. Luckily, I was able to safely pull over. I captured a video at this time documenting the control settings and display image. It took multiple attempts, even in Park and Neutral, to get out of 4WD and back into the 2H setting. Once back in 2H, the truck drove normally. I have had similar experiences at least twice before in this truck with months between them. In those cases, I wondered if I had accidentally bumped the dial control. I am certain that this was not the case yesterday, so this was a spontaneous event initiated by the truck’s computer and/or mechanical controls. I consider this to be a very serious safety hazard, as it dramatically and unexpectedly affected the speed and handling of my truck. I did some online searching today and found that multiple other Ranger Raptor owners have experienced this issue, suggesting that this may be a serious design flaw affecting multiple vehicles. I plan to schedule a service appointment with Ford and notify them directly of this problem and hazard.