2020 Ford Fusion

My Ford started making a loud noise whenever the accelerator wasn't being pressed, after taking it to the mechanic, he said it is the cracked flex plate. After some light research, it was aparent that this is an issue that Ford's cars have, and ford has tried to make it better by offering free fixes. I contacted the local ford dealer and since the car has 90,000 miles, it would have been covered. However, since it doesn't have a clean title, I was declined this service free of charge. I don't agree with this decision since I've been driving this car for over a year since it was purchased off IAA auction, and this issue was made clear only yesterday, but this issue is prevalent in cars like mine.The damage to my car specifically was to the back, and only affected the rear bumper and trunk. Therefore I don't think it is fair that I was declined the serve even though Ford has made it clear it is there manufacturing mistake and they are willing to fix it, just not with cars with my type of title. I was hoping to send in this incident so that this issue becomes a national recall, and more people can get their cars rightfully fixed and aware of this serious issue that can make the car completely unusable before it gets too late. I wasn't aware this was a common issue when purchasing this car, so a recall would protect more people since it will become mandatory information for owners to be aware of this issue. Thank you!

2020 Ford Fusion SE- Transmission problems. Only 98,000 miles on the car and have had issues with this transmission after a year of having it. Transmission fluid was good but there is a small leak, slipping gears, winding, and gear auto shifting back to park. No combustion or power until it hits 60 mph. Has been checked by mechanics. No lights on dash at all!

VIN: [XXX] Issue Category: Powertrain / Flex Plate / Transmission Failure Dealerships Involved: Freeway Ford – Bloomington, MN J.C. Lewis Ford – Savannah, GA Summary: I am requesting reimbursement from Ford Motor Company for repeated flex plate repairs and a resulting transmission failure on my 2020 Ford Fusion. The vehicle has had five flex plate replacements — three at Freeway Ford in Bloomington, MN, and two at J.C. Lewis Ford in Savannah, GA. Despite all repairs being performed by Ford dealerships, the issue persisted, and the transmission ultimately failed. I was required to pay for a new transmission out of pocket, even though the repeated flex plate failures clearly caused the damage. Ford has a Customer Satisfaction Program (CSP 22N12) addressing flex plate issues on this model, but I received no reimbursement or coverage. I contacted Ford via email to crcfmc@ford.com with documentation but received no response. I have copies of all invoices, repair orders, and service notes from both dealerships to support my claim. I am requesting full reimbursement of all related costs under goodwill or warranty consideration, as this is a known manufacturer-related defect that led to a major drivetrain failure. Total $3,103.93 Requested Resolution: Reimbursement for all flex plate repair costs and the transmission replacement due to defective parts covered under CSP 22N12. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

This makes the third time the transmission had to be redone and I have only 95.000 miles on it the first time was about 2months after I purchased the car brand new in December 2020 and each time the transmission gets repaired it cost more and more and they tell me that it need other stuff with it that needs to be replaced nothing in the dash showed failure to any thing

The contact owns a 2020 Ford Fusion. The contact stated that upon starting the vehicle, there was an abnormal rattling coming from the vehicle. There was no warning light illuminated. The contact stated that while driving at 20 MPH, the vehicle lost automotive power. There was no warning light illuminated. The vehicle was taken to a local dealer where it was diagnosed, and the contact was informed that the flywheel was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 123,000.

My 2020 Ford Fusion has experienced three separate flexplate failures, as well as transmission issues following the most recent repair. Failure #1: Occurred before I owned the vehicle (confirmed later in the vehicle’s history). The flexplate was replaced by a prior owner in 2022. Failure #2: [8/2023] – While I owned the vehicle, a loud rattling noise came from the engine area. My vehicle was towed to Foothill Ford, where it was purchased, and they replaced the flexplate. No power loss occurred. Failure #3: [5/2025] – The same rattling sound returned. I drove it to Green Ford, who confirmed the flexplate needed to be replaced, and they replaced it. No power loss occurred, but the noise was severe. After the third flexplate replacement, the transmission began slipping during acceleration. This issue did not exist before the repair, and Green Ford had told me the transmission was fine before they replaced the flexplate. Safety concern: Repeated flexplate failures and subsequent transmission slipping could cause loss of propulsion or difficulty maintaining speed if the problem occurs at highway speeds or in heavy traffic, creating a potential crash risk. I did lose power on the highway, but was able to pull safely off the shoulder and called a tow truck.

The flexplate in my 2020 Ford Fusion SE (1.5L EcoBoost engine) failed at just over 53,000 miles. The car began making loud knocking and rattling noises while driving, and it vibrated heavily at idle and during acceleration. This posed a serious safety concern, as we feared the car could stall or break down while on the road with our toddler in the backseat. We took it to an independent, certified repair shop where they diagnosed a broken transmission flexplate, which required immediate replacement. The repair cost nearly $3,000, and the shop confirmed it was not caused by driver error or normal wear-and-tear. The failure was premature and mechanical in nature. The mechanic informed us that this specific engine and flexplate design have been recalled before in other Ford models using the same 1.5L EcoBoost engine and parts. They suggested we contact Ford, as this appeared to be a known defect that should be covered under goodwill or extended warranty. We followed their advice and reached out to Ford directly, but Ford refused to offer any assistance — even though they are aware of these ongoing flexplate failures across similar vehicles. After researching, I discovered Ford has had multiple flexplate and powertrain-related recalls in other 1.5L and 1.6L EcoBoost engines in previous model years. I also found many online complaints from other Ford owners experiencing the same flexplate failures, often at similar mileage. Yet, this issue has not been acknowledged or recalled for the 2020 Ford Fusion SE. This is clearly a design or manufacturing flaw that should be investigated by the NHTSA. Flexplate failure puts lives at risk and results in major repair bills for consumers. Please investigate this ongoing issue before someone is seriously hurt.

The contact owns a 2020 Ford Fusion. The contact stated that while driving at various speeds or while the vehicle was idling, there was an abnormal clunking sound coming from the vehicle. There were no warning lights illuminated. The vehicle was taken to the local dealer where it was diagnosed and determined that the flex plate had fractured. The vehicle was repaired; however, the failure recurred. The manufacturer was not contacted. The failure mileage was approximately 25,000.

I purchased a used 2020 Ford Fusion from Carmax n 2023 with about 56,800 miles. A week later was involved in a nor side impact accident on the back end driver side, insurance paid for a dinted door and there was no other issues with the vehicle according to SONS ford. In 2024 I was on the highway (going about 80 mph) when my engine light came on, no more than 3 minutes later all the lights in my car flickered and i lost power to my entire car almost causing me my life, roadside assistance and a mechanic who had thankfully pulled over explained that my alternator completely shredded my belt. I paid for both my alternator and belt to be replaced But most recently (2025) I continued to whirring and knocking noises for 3 days (no warning lights) , I took it to firestone who stated I needed a motor repair so I got it towed to the dealership. A Ford certified mechanic stated my Flex Plate was cracked and it begin breaking off and how I needed a new starter as well leaving the car inoperable. They confirmed this was very uncommon due to the car age and the miles on it (80,000 mi) I’ve also reviewed the complaints on NHTSA and it looks like a lot of 2020 ford fusions are having these issues but yet no recall.

My car is at 47,000 miles and i started To hear a loud noise . Turns out ford says it’s the Flywheel, transmission pump, and torque converter per ford technician who completed my inspection . No warning lights came on nor was there any alerts the ford app. My 2020 Ford Fusion with approximately 48,000 miles experienced a cracked flexplate. This caused severe engine vibration, knocking sounds, and ultimately loss of power while driving. A cracked flexplate can lead to sudden engine stalling or failure to accelerate, especially at highway speeds or during intersections. This puts the driver and passengers at serious risk of a crash due to unexpected loss of power or control. This issue happened without warning and is a known problem in vehicles with the 2.0L EcoBoost engine and 6F35 transmission. Ford is aware of the issue (Customer Satisfaction Program 22N12), but my VIN was not included, even though the symptoms and components match the defect. I am reporting this because it jeopardized my safety and others on the road, and I believe more vehicles should be covered under the existing CSP or a recall.