Structure. Review the 7 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Suspension. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Wheels. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

2 crash reports1 fire reports1 injury reports

Fuel/propulsion System complaints

1 reports

Clear category filter

2,900 miles · Jul 13, 2016

EngineFuel/propulsion SystemStructureCrashFireInjury

Read full complaint

AN ALMOST NEW 2014 NEWMAR BAY STAR 3303 MOTORHOME WITH A FORD V10 GASOLINE ENGINE ON A FORD CHASSIS. MY FAMILY AND I WERE PREPARING TO LEAVE ON OUR FIRST BIG FAMILY OUTING IN OUR NEW RV. AT THE LAST MINUTE WHILE LOADING THE VEHICLE A GASOLINE ODOR WAS NOTICED. UPON VACATING THE VEHICLE, GASOLINE WAS SEEN DRIPPING FROM THE HOT EXHAUST PIPES UNDER THE RV. THE RV WAS SHUT OFF AND TOWED TO A FORD TRUCK GARAGE. FORD TECHS DISCOVERED GASOLINE UNDER PRESSURE WAS SQUIRTING ONTO THE ENGINE EXHAUST AND WITHIN MINUTES OF LEAVING ON OUR VACATION THE GAS FUMES WOULD HAVE IGNITED AND EXPLODED. THE FIRE WOULD NOW HAVE BE FUELED BY GAS FROM A MELTED HIGH PRESSURE PLASTIC GASOLINE LINE. THEN, AS A RV WITH THE ENGINE LOCATED BETWEEN THE FRONT SEATS, THE FIRE AND EXPLOSION WOULD HAVE PREVENTED ANYONE FROM EXITING THROUGH THE DOOR. THE GASOLINE FUELED FIRE AND EXPLOSION WOULD HAVE INJURED OR KILLED MY ENTIRE FAMILY. FORD HAS NO REPAIR FOR THE DESIGN/MANUFACTURING DEFECT IN THEIR HIGH PRESSURE FUEL LINE FOR THIS VEHICLE. IT SEEMS FORD'S NYLON/PLASTIC FUEL LINE IS INSULATED WITH A SOY BASED FOAM AND/OR OTHER INGREDIENTS THAT ARE NATURALLY GOOD TASTING FOOD PRODUCTS FOR RODENTS/CRITTERS. AS A FOOD BASED PRODUCT, THE FOAM INSULATION AND PLASTIC LINES ATTRACT RODENTS/CRITTERS TO EAT THE FOAM AND FUEL LINE THUS DAMAGING THE PLASTIC LINE CREATING A DANGEROUS GASOLINE LEAK. ON DISCUSSIONS WITH FORD THEY HAVE NO CORRECTION FOR THE PROBLEM. FORD RECOMMENDS PLACING MOTHBALLS UNDER THE VEHICLE AND TO AVOID PARKING IN WOODED AREAS. THE DANGER IS THAT THE PLASTIC FUEL LINE COATED WITH A FOOD BASED FOAM INSULATION IS LOCATED NEAR THE ENGINE CAUSING THE GASOLINE TO LEAK DIRECTLY ONTO THE HOT ENGINE MANIFOLD AND EXHAUST. THE SAFETY OF MY FAMILY IS AT RISK EVERY TIME WE USE THE RV DUE TO A DESIGN AND ENGINEERING DEFECT BY FORD AND THE LOCATION OF THE ENGINE AND EXIT DOOR ON THE NEWMAR.

NHTSA ODI #10884460

Official recalls

14V405000 · Service Brakes, Hydraulic:foundation Components:disc:caliper

Jul 2, 2014

Ford Motor Company (Ford) is recalling certain model year 2014 F-53 motorhome chassis and F-59 commercial chassis manufactured February 14, 2014, to March 7, 2014. The affected chassis may have incorrectly machined brake calipers that may leak brake fluid.

Consequence & remedy

Consequence: Brake caliper leaks will cause longer brake pedal travel and lengthened stopping distances, increasing the risk of a crash.

Remedy: Ford has notified owners. Dealers will inspect the vehicles and replace the affected brake calipers, free of charge. The recall began on July 28, 2014. Owners may contact Ford customer service at 1-800-392-3673. Ford's number for this recall is 14S14.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE20021 · Trimark 060-1650 Door Latch Failures

Opened Nov 23, 2020 · Closed Dec 13, 2024

Status: closed (inferred from source dates) · Equipment

On November 23, 2020, the Office of Defects Investigation (ODI) opened PE20021 to investigate allegations of inoperative Trimark THP 060-1650 door lock/latches originally equipped on model years (MY) 2015-2017 Class A and Class C motorhomes.ODI received forty-six Vehicle Owner’s Questionnaires (VOQs) describing consumers being locked in or out of their vehicles.The door latch, containing a die-cast zinc plunger, was produced by Equality during calendar years 2014-2016. The die-cast may become porous and brittle over time and can break without warning, causing the vehicle owner to be unable to open the recreational vehicle door equipped with the latch.If the motorhome does not have any other doors such as some Class A models, occupants could be trapped inside, needing to climb out using the emergency exits. If locked out, owners would be unable to easily get in and retrieve children and pets. ODI analyzed the data provided by Trimark in response to its January 27, 2021 information request letter.Although an elevated failure rate was evident on a specific combination of plunger bolt, door lock/latch assembly and door, the data showed that most failures occurred within the first two years of service on the affected 2015-2017 vehicles.This data suggests that component failures generally would have already occurred.Further, ODI data reflects a downward trend in complaints after calendar year 2018 and for post- MY 2016 vehicles.This downward trend may be attributed Trimark's actions in 2016 such as changes in the manufacturing process of its zinc plunger component for the relevant population and its 2016 decision to switch to a steel plunger. In view of the nature of early-life failure, and failure rate trending downward for model years 2017 and newer, this Preliminary Evaluation (PE) is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist.The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.