2007 Ford F-150

The contact owned a 2007 Ford F-150. The contact stated that when depressing the accelerator pedal while in reverse, the vehicle suddenly accelerated, crossing a field, and crashing into a nearby building, where the vehicle came to a stop. The contact sustained neck injuries, and the front passenger sustained neck injuries as well. The contact did not seek medical attention; however, they intended to do so in the future. The air bags did not deploy. A police report was filed. The rear end of the vehicle was damaged. The vehicle was driven home. The vehicle was taken to Collision Center who diagnosed that the rear of the vehicle needed extensive bodywork and determined the vehicle was totaled. The manufacturer was not informed of the failure. The failure mileage was approximately 300,000. The VIN was not available.

The contact owns a 2007 Ford F-150 The contact stated while driving at an undisclosed speed, the vehicle stalled and jerked. There was no warning light illuminated. The vehicle was restarted; however, the failure recurred. The vehicle was taken to an independent mechanic where it was diagnosed and determined that the transmission had failed and needed to be replaced. The vehicle was repaired; however, the failure recurred, with the check engine warning light illuminated. The vehicle was taken back to the mechanic where it was diagnosed and determined that the spark plugs, and torque converter had failed and needed to be replaced. The vehicle was not repaired. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for assistance. The approximate failure mileage was 126,963.

Transmission and rear end jerking when putting in or taking out of park, reverse or drive and now doesn't want to go forward when putting it in drive and I can't get it to shift out and transmission fault light came on and I re set it by taking black cable off battery and put transmission fluid in it and it still does it and also headlights doesn't work on bright and power steering pump makes noise and it's full of fluid I don't know if it is leaking or what small stuff I can deal with but major transmission and engine stuff on truck I can't.

The contact's daughter owns a 2013 Ford Focus. The contact stated that the vehicle had failed to shift properly and shuddered. There were no warning lights illuminated. The vehicle was taken to the local dealer, where it was diagnosed that the clutch assembly needed to be replaced. The vehicle was repaired, but the failure recurred. The vehicle was taken to another local dealer, #1 Cochran Ford Boardman (7955 Market St., Youngstown, OH 44512); where it was diagnosed and determined that the clutch assembly needed to be replaced. The vehicle was not repaired. The manufacturer was contacted and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 17,000.

The contact owns a 2007 Ford F-150. The contact stated while making a right turn from a complete stop at 7-10 MPH, the vehicle shuddered significantly. The contact pulled over to the side of the road. The vehicle was towed to the dealer, where it was diagnosed and determined that the driveline assembly had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and a case was opened. The failure mileage was approximately 120,000.

The contact owns a 2007 Ford F-150. The contact stated that while driving at an undisclosed speed, the gear shifter was difficult to shift. The contact stated that the gear shifter was stuck in park(P). There were no warning lights illuminated. The local dealer was not contacted. The vehicle was diagnosed or repaired. The contact stated that the transmission shifter cable was repaired several times by an independent mechanic. The manufacturer was contacted and referred the contact to the NHTSA Hotline. The failure mileage was 171,639. The VIN was not available.

EVERY VEHICLE THAT FORD PUT OUT WITH A CAM PHASER IS EXPERIENCING ISSUES WITH THE CAN PHASER. ANY SAE CERTIFIED MECHANIC WILL VERIFY THIS. THIS IS A HORRIBLE DESIGN. WHY HASN'T FORD STEPPED UP TO THE PLATE AND FIXED THIS ISSUE? I BELIEVE THEY ARE TRYING TO BURY IT SO THAT THEY DON'T HAVE TO INCUR THE COST OF FIXING THEIR MISTAKE. DUE TO THIS ISSUE I'VE BEEN STRANDED ON THE HIGHWAY. THE TRUCK LOOSES POWER, WON'T GO INTO GEAR....ETC....THIS HAPPENS AFTER THE CAN PHASER HAS ACTIVATED AND THEN I COME TO A STOP. THEN IT'S MISFIRING STALLING NOT GOING INTO GEAR...YOU NAME IT IT'S AN ISSUE. A COMPUTE READ ON THE OBD2 STAYED THAT I HAD MISSES IN IGNITION COILS 1,3 AND 7 REPLACED THEM THEN THE TEACHING STAYED MISFIRED IS 2,4 AND 5 REPLACED THEM AND ALL THE SAME ISSUES... EVERY MECHANIC I'VE SPOKEN TO SAYS ABSOLUTEY THE PHASES AND THAT THEY HAVE TO PUT A CAM PHASER DELETE KIT IN THESE VEHICLES DO GET RID OF THESE PROBLEMS. WHY HASN'T FORD BEEN HELD RESPONSIBLE FOR SUCH A TERRIBLE DESIGN?