Electrical System. Review the 104 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Seat Belts. Review the 71 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Fuel System, Gasoline. Review the 59 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

19 crash reports61 fire reports14 injury reports

Fuel System, Other complaints

3 reports

Clear category filter

Mileage unknown · Jun 3, 2003

Fuel System, Other

VEHICLE WAS HAVING THE SAME PROBLEM AS MENTIONED IN RECALL#92V17000 CONCERNING FUEL TANK. DEALER WILL NOT REPAIR VEHICLE BECAUSE IT IS NOT COVERED UNDER RECALL DUE TO VIN. *AK

NHTSA ODI #10022205

Mileage unknown · Nov 13, 1996

Fuel System, GasolineFuel System, OtherSeat Belts

THE FUEL GAUGE IS NOT WORKING RIGHT; ALSO THE FRONT SUSPENSION IS OFF ON THE DRIVER'S SIDE AND SEAT BELT RETRACTOR STOPPED WORKING .*AK CONSUMER STATES FUEL GUAGE READS FULL ALL THE TIME, FRONT WHEEL BOUNCE WHILE DRIVING DOWN THE ROAD OR A VIBRATING SOUND, SEAT BELT ON DRIVER'S SIDE STOPPED WORKING.*JB

NHTSA ODI #804912

Mileage unknown · Oct 5, 1995

Fuel System, Other

FUEL GAUGE FAILURE, DRIVER DOES NOT KNOW HOW MUCH GAS IS IN VEHICLE. TT

NHTSA ODI #973013

Official recalls

93V057000 · Electrical SYSTEM:IGNITION:ANTI-THEFT:CONTROL Module

Apr 15, 1993

THE ROLL PINS SECURING THE IGNITION LOCK IN THE STEERING COLUMN HOUSING CAN SEPARATE OR MOVE OUT OF POSITION.

Consequence & remedy

Consequence: THE IGNITION LOCK CYLINDER MAY DISENGAGE FROM THESTEERING COLUMN HOUSING WHICH COULD CAUSE THE STEERING COLUMN TO LOCK UP,RESULTING IN LOSS OF VEHICLE CONTROL AND A POSSIBLE ACCIDENT.

Remedy: IF ONE OR BOTH OF THE ROLL PINS ARE MISSING OR NOT FULLY INSERTED, THE IGNITION LOCK HOUSING WILL BE REPLACED, ALONG WITH THE DOOR-LOCKS AND THE LIFTGATE OR DECK-LID LOCKS SO THAT KEY COMPATIBILITY IS MAINTAINED. IF BOTH PINS ARE PRESENT AND FULLY INSERTED, A PLASTIC SNAP-ON SLEEVE WILL BE INSTALLED AS A PRECAUTION TO PREVENT THE ROLL PINS FROM COMING OUT.

92V117000 · Fuel System, Gasoline

Aug 19, 1992

FATIGUE CRACKS CAN DEVELOP IN THE SOLDER JOINT BETWEEN THE FUEL RETURN TUBE AND THE FUEL PUMP SENDING UNIT LOCATED AT THE TOP OF THE FUEL TANK.

Consequence & remedy

Consequence: SHOULD A CRACK DEVELOP, FUEL VAPOR CAN ESCAPE FROM THETANK WHEN THE TANK IS FULL, AND A SMALL AMOUNT OF FUEL CAN LEAK FROM THE CRACK.FUEL LEAKS CAN RESULT IN FIRE WHEN EXPOSED TO A SOURCE OF IGNITION.

Remedy: INSTALL A NEW FUEL PUMP SENDING ASSEMBLY.

90V076000 · Vehicle Speed Control:accelerator Pedal

Apr 17, 1990

INTERFERENCE OCCUR BETWEEN BOLT THAT SECURES A FUEL LINE SHIELD TO THE LOWER PORTION OF THE DASH PANEL AND THE ACCELERATOR PEDAL.

Consequence & remedy

Consequence: THIS COULD CAUSE THE ACCELERATOR PEDAL TO STICK AT THE WIDE OPEN THROTTLE POSITION AND RESULT IN LOSS OF CONTROL WITH THE RISK OF A VEHICLE ACCIDENT.

Remedy: CUT OFF EXTRA LENGTH OF BOLT THAT PROTRUDES ABOVE SURFACE OF WELD NUT TO PREVENT INTERFERENCE.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗