THIS TRUCK HAS HAD A CONSTANT STALLING PROBLEM. IT RUNS FINE ON THE OPEN ROAD BUT WHEN IT I STOP FOR A LIGHT OR STOP SIGN OR MAKE A TURN & REAPPLY THE ACCELERATOR IT STUMBLES, HESITATES & STALLS. IF I AM QUICK ENOUGH TO BACK OFF THE ACCELLATOR & REAPPLY IT I CAN KEEP IT FROM STALLING. IF NOT IT WILL STALL. IT USUALLY STARTS RIG…
Read full complaint
THIS TRUCK HAS HAD A CONSTANT STALLING PROBLEM. IT RUNS FINE ON THE OPEN ROAD BUT WHEN IT I STOP FOR A LIGHT OR STOP SIGN OR MAKE A TURN & REAPPLY THE ACCELERATOR IT STUMBLES, HESITATES & STALLS. IF I AM QUICK ENOUGH TO BACK OFF THE ACCELLATOR & REAPPLY IT I CAN KEEP IT FROM STALLING. IF NOT IT WILL STALL. IT USUALLY STARTS RIGHT UP AGAIN BUT THIS SITUATION HAS BECOME DANGEROUS. IT HAS BEEN TO FORD NUMEROUS TIMES FOR THIS PROBLEM. FORD TOLD ME THAT NO CODES SHOW UP. THEY TOLD ME THE ONLY THING WAS A SLIGHT FLAT SPOT IN THE CARB. & ADVISED ME TO HAVE IT REBUILT AT A CARB. PLACE. I DID THAT & THE PROBLEM CONTINUES.THE TRUCK HAS HAD A VALUE JOB, A TUNEUP WITH NEW WIRES BUT THE PROBLEM CONTINUES. IT ALSO SEEMS TO RUN BETTER IF THE VACUUM HOSES ON THE PASSENGER ENGINE SIDE WALL ARE DISCONNECTED. THERE IS A UNIT THAT HAS 3 VACUUME HOSES ON IT THAT CONNECT THERE. THE TRUCK STARTS RIGHT UP IN COLD OR WARM WEATHER & IDLES & RUNS OK. THIS PROBLEM SEEMS TO ACT UP MORE WHEN THE WEATHER IS DAMP OR RAINING BUT NOW IT SEEMS TO DO IT AT WILL & ONLY FROM A START OR WHEN REAPPLY THE ACCELERATOR WHEN MAKING A TURN. OVERALL THIS TRUCK IS IN VERY GOOD CONDITION AS FAR AS THE EXTERIOR & INTERIOR ARE CONCERNED. I WOULD LIKE TO FIND THE PROBLEM BECAUSE I WANT TO KEEP THIS TRUCK FOR TRANSPORTATION. IT IS CURRENTLY OFF THE ROAD BECAUSE OF THIS PROBLEM. I HAVE TALKED WITH MANY MACHANICS & NO ONE SEEMS TO KNOW WHAT IS CAUSING IT. I KNOW THAT FORD WAS JUST ORDERED TO RECALL VECHICLES WITH STALLING PROBLEMS LINKED TO A DISTRIBURTOR PART THAT OVER HEATS & STALLS THE ENGINE. ANY INFORMATION THAT YOU CAN SUPPLY ME WITH AS FAR AS FINDING THE PROBLEM WOULD BE GREATLY APPRECIATED.
NHTSA ODI #751424
Mileage unknown · Jun 6, 2000
Engine And Engine CoolingFire
POSSIBLE ENGINE FAILURE RESULTED IN VEHICLE FIRE. (OHIO TRAFFIC CRASH REPORT) *MJS
COMPONENTS IN THE LOCKING HUBS WERE IMPROPERLY HEAT-TREATED AND MAY CRACK OR FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. THE BROKEN COMPONENT ON THE LEFT FRONT WHEEL MAY BECOME JAMMED AGAINST THE NUT.
Consequence & remedy
Consequence: Not supplied
Remedy: CAM ASSEMBLIES IN FRONT WHEEL AUTOMATIC LOCKING HUBS WILL BE REPLACED.
THE BOLTS THAT ATTACH THE D-SHAPED RING FOR THE SHOULDER BELT ARE INADEQUATELY SUPPORTED BY THE MATERIAL IN WHICH THEY ARE MOUNTED. THE ATTACHMENT DOES NOT COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".
Consequence & remedy
Consequence: Not supplied
Remedy: DEALERS WILL INSTALL NEW ATTACHING HARDWARE TO IMPROVE THE STRENGTH OF THE MOUNTING.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
4
DP97006 · Vehicle Rollover
Opened Dec 3, 1997 · Closed May 5, 1999
Status: closed (inferred from source dates) · Structure
PETITIONER ALLEGED BRONCO II SPORT UTILITY VEHICLES 1983-1990 WERE DESIGNED WITH HANDLING AND STABILITY DEFECTS
EA89013 · Rollover Propensity
Opened Feb 9, 1989 · Closed Oct 31, 1990
Status: closed (inferred from source dates) · Suspension
SUMMARY:THE BRONCO II IS INVOLVED IN MORE FATAL SINGLE VEHICLE, FIRSTEVENT ROLLOVERS COMPARED TO ANY OTHER CLOSED BODY UTILITY VEHICLE (WITHOR WITHOUT NORMALIZING VEHICLE POPULATIONS AND EXPOSURE).===
DP88020 · Vehicle Rollover
Opened Aug 11, 1988 · Closed Feb 8, 1989
Status: closed (inferred from source dates) · Suspension
VEHICLE ROLLOVER
PE87020 · Eng. And Under Dash Fires
Opened Feb 6, 1987 · Closed May 26, 1987
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
SUMMARY OF INFORMATION FROM MANUFACTURER:INSTANCES WERE FOUND WHERESPRING LOCK COUPLINGS FAILED CAUSING GASOLINE TO BE RELEASED THROUGHOUT THEENGINE COMPARTMENT CAUSING FIRES.FAILURE OF THE COUPLINGS CAN TAKE PLACEAFTER COMPLIANCE WITH A FORD RECALL CAMPAIGN, ON NEWLY DELIVERED VEHICLESFROM THE FACTORY WITH MINIMAL MILEAGE ON THE ODOMETER, AND AT ANY VEHICLEMILEAGE.___________________________________________________________________________ANALYSIS:DATA INDICATES THAT THE ALLEGED PROBLEM MAY BE CAUSED BY THESPRING LOCK QUICK CONNECT COUPLINGS WHICH CONNECT THE FUEL SUPPLY ANDRETURN LINES TO THE ENGINE AS WELL AS FUEL LEAKAGE FROM THE FUEL LINES.___________________________________________________________________________PROPOSED ACTION:UPGRADE THIS PE TO AN EA.(EA87-020)===
1984 Ford Bronco Ii Problems, Complaints & Recalls | Skip That Year
Illustration