1998 Dodge RAM 2500

FRONT SEAT BELTS WILL NO LONGER RELEASE THEREFORE CANNOT BE USED ANYMORE. REQUIRES REPLACEMENT OF SEAT BELT CONTROL MODULE AND IT IS NO LONGER AVAILABLE AT DEALERS OR ANYWHERE ELSE. THIS IS A HUGE SAFETY ISSUE IF YOU CANNOT USE YOUR SEAT BELTS ANYMORE. CHRYSLER SHOULD BE REQUIRED TO ISSUE A RECALL ON ALL DODGE TRUCKS WITH THE SEAT BELTS MOUNTED IN THE SEAT BACKS THAT USE THIS MODULE FOR PROPER OPERATION. THERE ARE A TON OF PEOPLE POSTING ON THE INTERNET HAVING THIS SAME SEAT BELT LOCK UP PROBLEM. PLEASE HELP!!!! *TR

I OWN A 1998 DODGE RAM 2500, I HAVE NOTICED THIS PROBLEM ON MULTIPLE DODGES AND READ ABOUT IT ON THE INTERNET, THE FRONT LOWER AXLE MOUNT ROTS OUT DUE TO POOR DESIGN LEAVING NOTHING TO HOLD THE SPRING IN PLACE MY COIL MOUNT IS ROTTED OUT AND THERE IS BARELY ANY LEFT OF IT, AND DODGE NOR DO ANY AUTO PART STORES SELL COIL MOUNTS TO REPLACE IT THE MOUNT IS WELDED DIRECTLY ON THE AXLE SO THE AXLE HOUSING WOULD NEED TO BE REPLACED, THIS IS VERY UNSAFE IF THE AXLE WERE TO GIVE OUT DEW TO THIS. *TR

1998.5 24VALVE CUMMINS DIESEL, ONE OWNER WITH FACTORY ECM (799) UPDATE, NEVER ANY "CHIPS". ON COLD START UP, EVERYTHING NORMAL UNTIL I GO TO TAKE OFF, ANY APPLICATION TO THE ACCELERATOR AND AS IF I PUT THE ACCELERATOR ALL THE WAY TO THE FLOOR, TRUCK WILL CONTINUE TO ACCELERATE UNTIL EITHER I REMOVE MY FOOT COMPLETELY OFF THE PEDAL, OR THE GOVERNOR KICKS IN. *TR

DRIVING ON HWY880 NORTH BOUND JUST PAST 238 JUNCTION PULLING MY BOAT. MY BOAT WEIGHS APPROX 7000#. I HAD JUST MERGED ONTO THE HIGHWAY AND I WAS GOING ABOUT 50MPH WHEN I NOTICED A SEVERE VIBRATION. THE VIBRATION GOT WORSE AND ALL OF A SUDDEN A HUGE PIECE OF TREAD SEPARATED FROM THE REAR DRIVERS SIDE TIRE. I CAN SAY THIS BECAUSE I SAW IT FLY PAST ME IN THE LANE TO MY LEFT. FOLLOWING THE TREAD SEPARATION THE TIRE EXPLODED AND MY TRUCK STARTED TO FISHTAIL. I WAS ABLE TO SIGNAL AND MAKE MY WAY TO THE RIGHT HAND SHOULDER. THE TIRE HAD 3/4 OF THE TREAD MISSING AND HAD A HUGE HOLE IN THE SIDEWALL. I WAS ABLE TO REMOVE TIRE AND REPLACE WITH SPARE. WHEN THE TREAD DETACHED IT DID SOME DAMAGE TO THE REAR QUARTER PANEL. THE 2 SIDEBODY SUPPORT RODS IN THE WHEEL WELL WHERE COMPLETELY TORN FREE. ALSO THE WHEEL WELL TRIM WAS COMPLETELY TORN LOOSE. THE METAL BEHIND THE TIRE IN WHEEL WELL WAS CRUSHED UP AGAINST THE UNDERSIDE OF THE BED. I BROUGHT TIRE BACK TO 4WHEEL PARTS AND WAS TOLD IT WAS JUST A BLOWOUT AND THAT THEY CAN BE PRETTY NASTY SOMETIMES. I PURCHASED ANOTHER TIRE FROM THE SAME MANUFACTURER. MOVE FORWARD ONE YEAR TO 5/4/13 I HAVE ANOTHER TREAD SEPARATION WHILE TRAVELING ON HIGHWAY. THIS TIME IT IS THE RIGHT REAR TIRE. SPEED IS APPROX. 60MPH TIRE STARTS TO VIBRATE BADLY. I IMMEDIATELY START TO MOVE TO SHOULDER FROM NUMBER 3 LANE WHEN TREAD SEPARATES FROM TIRE I SEE IT PASS ME IN RIGHT LANE. THIS TIME THE TIRE DOES NOT BURST. I REPLACE TIRE WITH SPARE. THERE IS EXPENSIVE DAMAGE TO WHEEL WELL AREA. CRUSHED METAL, BENT AND DETACHED SUPPORT MEMBERS AND THE TREAD WHEN IT DETACHED FLEW UP A LONG THE PASSENGER SIDE OF VEHICLE AND LEFT DEEP SCRATCHES IN PAINT AND BLACK TIRE MARKS. RETURNED TO 4WHEELPARTS AND WAS TOLD TO CONTACT COOPER TIRE. I AM CURRENTLY WAITING FOR COMPLAINT PACKAGE FROM THEM. PURCHASED A NEW SET OF 4 TIRES FROM 4WHEEL PARTS. THEY GAVE ME CREDIT FOR 2 DEFECTIVE TIRES AND MADE ME PAY FOR OTHER 2. *TR

TL* THE CONTACT OWNS A 1998 DODGE RAM 2500. THE CONTACT STATED THAT THE DASHBOARD EXHIBITED SEVERAL FRAGMENTED PIECES. IN ADDITION, THE FAULTY HORN SWITCH WAS NO LONGER BEING PRODUCED AS AN INDIVIDUAL PART AND WAS CURRENTLY BEING MANUFACTURED AS ONE ASSEMBLY PART WITH THE COMBINATION OF THE HORN SWITCH AND FRONTAL AIR BAG. THE CONTACT STATED THAT THE PART WAS MORE COSTLY. THE VEHICLE WAS NOT REPAIRED. AN AUTHORIZED DEALER AND THE MANUFACTURER WERE NOTIFIED OF THE PROBLEM. THE APPROXIMATE FAILURE MILEAGE WAS 70,000.

I AM AMAZED THERE ARE NO REPORTS ON 1998 1/2 - 2001 MODEL DODGE PICKUPS WITH THE CUMMINS DIESEL ENGINE AS THE BOSCH VP44 MAIN (INJECTOR) FUEL PUMP HAS A FAILURE RATE OF 100%. I'VE HAD 3 FAIL SO FAR & FOR DIESEL MECHANICS IT'S COMMON KNOWLEDGE THAT IT'S NOT A MATTER OF IF THE THE VP44 PUMP WILL FAIL, IT'S JUST A MATTER OF WHEN. THE LAST TIME A PUMP DIED ON ME WAS WHEN I WAS GOING DOWN THE INTERSTATE @ 70 MPH & THE ENGINE JUST SHUT OFF. I KNEW IMMEDIATELY IT WAS ANOTHER FUEL PUMP FAILURE, BUT OTHER DRIVERS MAY NOT REALIZE WHAT WENT WRONG & I'D BE SURPRISED IF THERE HAVEN'T BEEN ANY WRECKS DUE TO VP44 PUMP FAILURE, WHICH GIVES YOU NO ADVANCE WARNING - IT JUST QUITS. IN 2002 DODGE/CUMMINS CHARGED THE FUEL SYSTEM ON THE DIESEL ENGINE FOR DODGE PICKUPS (INCLUDING A DIFFERENT FUEL PUMP), BUT ALL 1998 1/2 THRU 2001 MODELS CAME WITH THE SAME BOSCH VP44 MAIN INJECTOR PUMP. *TT

ON A 1998 DODGE RAM 2500 THREE OF THE FIVE STOCK GOODYEAR WRANGLER RT/S 245/75 R16 TIRES HAVE BEEN VOLUNTARILY REPLACED BY THE MANUFACTURER FOR SIDEWALL SEPARATION. THE FOURTH TIRE BLEW ONE WEEK AGO WHILE TOWING A LIGHT BOAT (2000LBS) AT APPROXIMATELY 65MPH. I WAS ABLE TO MAINTAIN CONTROL, BUT I HAD MY WIFE AND TWO CHILDREN ABOARD AND AM UPSET THAT THE SAME PROBLEM HAS OCCURRED REPEATEDLY DUE TO AN ADMITTED MANUFACTURER ERROR. THE TIRES HAVE LESS THAN 45,000 MILES ON THEM AND THE REPLACEMENTS ARE SHOWING MINUTE SIGNS OF SIDEWALL SEPARATION WITH LESS THAN 10,000 MILES. TO REPLACE THESE TIRES WOULD COST APPROXIMATELY $800, $1000 WITH THE SPARE. I FEEL ENDANGERED BY THE REPUTATION OF THE TIRES AND TRULY FEEL THAT THE PRODUCT THAT I HAVE PAID FOR HAS FALLEN WOEFULLY SHORT OF EXPECTATION, WHILE OPERATED UNDER VERY LIGHT WORKLOADS AND VERY LOW MILEAGE. I FEEL IT IS THE RESPONSIBILITY FOR GOODYEAR TO PROVIDE A SAFE AND QUALITY PRODUCT THAT MEETS THE DEMANDS OF A LOAD RANGE E TIRE. *TR