In July of 2024 I had to brake to avoid striking a deer. My ABS and Traction Control light came on in the dash, and my cruise control stopped working. I took the vehicle to the dealership and they said the HCU and ABS Modules were bad, but the ABS Module was no longer made by Chrysler, and it wasn't available aftermarket. I c…
Read full complaint
In July of 2024 I had to brake to avoid striking a deer. My ABS and Traction Control light came on in the dash, and my cruise control stopped working. I took the vehicle to the dealership and they said the HCU and ABS Modules were bad, but the ABS Module was no longer made by Chrysler, and it wasn't available aftermarket. I contacted Stelantis and they said the ABS module was under "Engineering Review" and not available. I received an email in September indicating the part was now available and it was being shipped to my dealership. I never heard back from the dealership, and I called them back on December 17th. The parts manager said his computer indicated again that the part was unavailable and it had been discontinued on October 14th, 2024. He sent me a screenshot of the order screen showing the part was discontinued which I've attached below. I recontacted Stelantis on December 23rd and they started another case (Case #[XXX]) and a case manager would call me back within one working day. I called Stelantis back on January 3rd and spoke with "Edward" who said my case was never assigned and he was going to "expedite" the case (as every other person I had spoken to previously said) and that a case manager would contact me within one working day. As of now, I have not heard back. My ABS brakes and Traction Control (Federally mandated safety equipment since 1998) are inoperable and according to Stelantis, the ABS module is no longer made and there are no aftermarket replacements. My Cruise Control does not work either and I don't know if any of the other safety features are affected. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Chrysler (FCA US, LLC) is recalling certain 2019-2021 Ram ProMaster and 2019-2020 Dodge Journey vehicles. Cracks in the microprocessor may cause the vehicle's rearview camera image not to display properly. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility.
Consequence & remedy
Consequence: A rearview image that does not display properly reduces the driver's view behind the vehicle, increasing the risk of a crash.
Remedy: Dealers will replace the rearview camera, free of charge. Interim notification letters, notifying owners of the safety risk, were mailed beginning September 30, 2025. A second notice will be sent once the final remedy is available, anticipated July 2026. Owners may contact Chrysler customer service at 800-853-1403. Chrysler's number for this recall is 59C.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2
EA24003 · Vehicle Entrapment
Opened Aug 1, 2024 · No close date supplied
Status: open (inferred from source dates) · Latches/locks/linkages
The Office of Defects Investigation (ODI) opened PE23-008 on May 1, 2023 to investigate an incident involving a 2009 Dodge Journey alleging occupant entrapment during a vehicle fire that resulted in a fatality. During the investigation, ODI collected information from the manufacturer and involved parties to confirm or refute the defect allegation. ODI has determined that additional reports of vehicle entrapment exist for other model year Dodge Journey vehicles. ODI continues to explore the cause of the thermal event and its potential effect on the actuation of the door locks. ODI also continues to explore other potential causes for door lock malfunction. ODI has determined that an upgrade to an Engineering Analysis (EA) is necessary to continue the review of the investigative material and to assess the risk to motor vehicle safety . To review the ODI report cited in the Opening Resume ODI Report Identification Number document, go to NHTSA.gov.
PE24006 · Back Up Camera Failure
Opened Feb 27, 2024 · Closed Sep 26, 2025
Status: closed (inferred from source dates) · Back Over Prevention: Sensing System: Camera
On February 27, 2024, the Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) to investigate complaints alleging a loss of back up camera function in Model Year (MY) 2018 through 2020 Dodge Journey vehicles. Complainants reported experiencing black screens, upside down images, flashing images, or blurred images. A back up camera that does not display correctly increases the likelihood of a crash or injury. Analysis of warranty data provided in response to ODI’s information request letter demonstrated a pattern of elevated warranty claims in subject vehicles built in calendar years (CY) 2019 and 2020. The rate of camera related warranty repairs for models built in CY 2019-2020 was nearly double that of vehicles built in CY 2017-2018. This increase in warranty claims occurred after the introduction of a new camera part number. ODI presented this analysis to FCA in February 2025. In response, FCA started a review of component change history in February 2025 and opened an internal investigation into MY 2019-2020 Dodge Journey and 2019-2021 Ram Promaster vehicles in May of 2025. On August 26, 2025, FCA submitted a Part 573 Safety Recall Report to the agency. In the report, FCA notes that a damaged microprocessor may cause the camera to not function properly. FCA will replace defective cameras in the recalled vehicles with an updated part that mitigates the issue. See NHTSA recalls 25V552 and 25E052 for further details. Based on available information, FCA's recalls address the alleged defect identified in this PE. Accordingly, this investigation is closed. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.
Additional source detail variants (2)
Back Over Prevention: Sensing System: Camera
On February 27, 2024, the Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) to investigate complaints alleging a loss of back up camera function in Model Year (MY) 2018 through 2020 Dodge Journey vehicles. Complainants reported experiencing black screens, upside down images, flashing images, or blurred images. A back up camera that does not display correctly increases the likelihood of a crash or injury. Analysis of warranty data provided in response to ODI’s information request letter demonstrated a pattern of elevated warranty claims in subject vehicles built in calendar years (CY) 2019 and 2020. The rate of camera related warranty repairs for models built in CY 2019-2020 was nearly double that of vehicles built in CY 2017-2018. This increase in warranty claims occurred after the introduction of a new camera part number. ODI presented this analysis to FCA in February 2025. In response, FCA started a review of component change history in February 2025 and opened an internal investigation into MY 2019-2020 Dodge Journey and 2019-2021 Ram Promaster vehicles in May of 2025. On August 26, 2025, FCA submitted a Part 573 Safety Recall Report to the agency. In the report, FCA notes that a damaged microprocessor may cause the camera to not function properly. FCA will replace defective cameras in the recalled vehicles with an updated part that mitigates the issue. See NHTSA recalls 25V552 and 25E052 for further details. Based on available information, FCA's recalls address the alleged defect identified in this PE. Accordingly, this investigation is closed. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.
Back Over Prevention: Sensing System: Camera
On February 27, 2024, the Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE) to investigate complaints alleging a loss of back up camera function in Model Year (MY) 2018 through 2020 Dodge Journey vehicles. Complainants reported experiencing black screens, upside down images, flashing images, or blurred images. A back up camera that does not display correctly increases the likelihood of a crash or injury. Analysis of warranty data provided in response to ODI’s information request letter demonstrated a pattern of elevated warranty claims in subject vehicles built in calendar years (CY) 2019 and 2020. The rate of camera related warranty repairs for models built in CY 2019-2020 was nearly double that of vehicles built in CY 2017-2018. This increase in warranty claims occurred after the introduction of a new camera part number. ODI presented this analysis to FCA in February 2025. In response, FCA started a review of component change history in February 2025 and opened an internal investigation into MY 2019-2020 Dodge Journey and 2019-2021 Ram Promaster vehicles in May of 2025. On August 26, 2025, FCA submitted a Part 573 Safety Recall Report to the agency. In the report, FCA notes that a damaged microprocessor may cause the camera to not function properly. FCA will replace defective cameras in the recalled vehicles with an updated part that mitigates the issue. See NHTSA recalls 25V552 and 25E052 for further details. Based on available information, FCA's recalls address the alleged defect identified in this PE. Accordingly, this investigation is closed. The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.
2020 Dodge Journey Problems, Complaints & Recalls | Skip That Year
Illustration