2007 Dodge Caliber

My car was slow to accelerate, and sounded like the engine was over-revving. The engine stalled several times, and the car itself was shaking, while driving at a moderate speed level, which I feared would have caused an accident, because it was sudden. The service warning light appeared. I had the manifold replaced by one mechanic, but the problem occurred again. I got a second opinion, that determined it was the throttle body assembly, which was replaced. That was three years ago. Now, the same issue has cropped up again. The cost was exorbitant, and is something I can't afford every few years.

Vehicle has less than 100,000 miles (strictly highway miles) and rear sub frame has completely rusted through causing back alignment to be drastically out, and fish tailing, which also causes hazardous steering control on dry and especially wet roads. Rapid wear and replacement of tires on rear end. I have researched and found this to be a consistent problem on multiple sites and forums.

The contact owns a 2007 Dodge Caliber. The contact stated that after driving approximately a block from her residence, she noticed that the vehicle was unable to exceed 15 MPH while accelerating. The contact stated there was no warning light illuminated. The vehicle was driven back to her residence and then the vehicle was towed to an independent mechanic. The contact stated that the vehicle was diagnosed, and she was informed that the intake manifold needed to be replaced. Additionally, the vehicle subframe was rusted. The contact stated that she was informed of an unknown recall however, she was informed that the VIN was not included. Neither the dealer nor the manufacturer was notified of the failure. The approximate failure mileage was 79,000.

The contact owns a 2007 Dodge Caliber. The contact stated while driving at various speeds, the front end of the vehicle emitted abnormal sounds and the vehicle was vibrating. The vehicle was taken to an independent mechanic where it was diagnosed that the front passenger's side and the front driver's side tires were wiggly and the front lower ball joints had failed. Additionally, the independent mechanic diagnosed that the front subframe was severely rusted and had a hole. The vehicle was then taken to another independent mechanic who diagnosed that the rear subframe was severely rusted as well. The vehicle was not repaired. The dealer and the manufacturer were not notified of the failure. The failure mileage was approximately 133,000.

I had brought my 2003 Stratus and 2007 Caliber in to the dealership for their 3000 mile oil change and check-up. When the Stratus was done, I switched it out with the Caliber. The receptionist came into the waiting room to inform me that my vehicle was dangerous to drive. The engine cradle had rotted out. The manager had asked her to tell me: "If you hit a big bump, your engine could fall out." She showed me a picture of the area in question. I asked what I was supposed to be looking for and was shown where the cradle was supposed to be. A post-it note was on the picture saying that the manager "will do some pricing". The invoice states: "We question the structural integrity of it being able to hold up much longer." When I did not hear anything for a few weeks, I called in and was told that it had not been done but the manager would get right on it. I had asked the manager how this could have been missed during all the years I had been bringing it in for any kind of maintenance and was told: "It probably looks worse that what it should because I poked it with a screwdriver a few times to see how bad it was." Invoice total: $1884.20. I have since spoken with a general manager for Magna Corporation who produced the cradle for the Caliber. They were aware of the design flaw of the cradle that did not allow for drainage of water/road chemicals from the cradle. A lawsuit was filed by Magna against Dodge which Magna won. The particulars of the lawsuit were not made known to me other than Magna charges $42 for the cradle, but I was billed $859. I have found numerous customer complaints online over the corrosion of the cradle in other Dodge model years as well. The 2007 Caliber seems to have more overall customer complaints that all othe model years combined.

My throttle body keeps going in and out which cause me to have to get an alternator replaced twice plus a crankshaft twice. Now my car is smoking which is the valve cover gasket . Also my car lights went out one at a time so my driver side lights wnt work at all in the front and the passenger side front won't work just my signal on the passenger side. Also my dashboard won't work properly it keeps goin on and off as I turn on other lights in my car . When I signal left my car light on the roof comes on. I spent $12000 on this car from a dealership and have done nothing but put money into it more than I paid for it.

Passenger side headlight and driver's side tail light not working. Bulbs have been replaced and tested as to being good. Went on internet and found this to be a very common problem with Dodge and Chrysler vehicles, many times requiring replacement of the TPIM. Grounds have been checked as good. Dealer says repair requires replacement of the TIPM for $1,600.00!! Vehicle lighting are safety items covered by vehicle laws. These are safety issues and customers should not be held hostage for ransom for their poor design. Dodge and Chrysler should be replacing these TIPMs when they start failing without cost to customers.