2007 Dodge Caliber

I BOUGHT MY CAR IN FEBRUARY OF 2013. APPROXIMATELY 6 MONTHS LATER I HAD TO REPLACE THE STRUTS AND BALL JOINTS ON THE CAR. THEN HAD THEM REPLACED AGAIN. 09/29/14 AND WAS TOLD AGAIN BY THE REPAIR SHOP LAST WEEK WHEN I BROUGHT THE CAR IN FOR A TUNEUP BECAUSE IT WAS HESITATING WHEN YOU STARTED TO ACCELERATE THAT I'M GOING TO NEED TO HAVE THE STRUTS REPLACED AGAIN. SO NOW THAT'S 3 TIMES IN A LITTLE MORE 3 YRS I HAVE OWNED THE CAR. THIS CAN'T BE NORMAL. I LOOKED ONLINE AND THERE HAVE BEEN 100'S OF PEOPLE COMPLAINING ABOUT FRONT SUSPENSIONS ON THEIR CALIBERS. SO I THINK IT'S A DESIGN FAULT THAT NEEDS TO BE CORRECTED. THE ONE TIME ( THE 2ND REPAIR) I WAS TOLD THAT IT WAS A GOOD THING I BROUGHT THE CAR IN WHEN I DID OR I COULD HAVE BEEN IN A SERIOUS ACCIDENT BECAUSE THE STRUTS WERE SO BADLY DAMAGED.

AT 132000 MILES, I AM REPLACING BOTH CONTROL ARMS FOR THE FOURTH TIME ON MY 2007 DODGE CALIBER SXT 2.0L, NO TO MENTION THE NUMEROUS CV BOOTS AND BALL JOINTS. WITH THE NUMEROUS COMPLAINTS I HAVE SEEN ONLINE, IT IS SURPRISING THAT NO RECALL EFFORTS (AT LEAST SEEMINGLY) HAVE BEEN MADE FOR SUCH A DANGEROUS AND COSTLY DEFECT. I IMPLORE YOUR COMPANY, PLEASE INVESTIGATE THE CONCERNS AND HAVING CHRYSLER-DODGE FIX THEIR ERRORS!!! EVEN MY MECHANIC INFORMED ME THAT THE LENGTH OF THE ARM IS JUST SHORT ENOUGH TO CREATE CONTINUAL ISSUES. THIS ISN'T RIGHT. AS A RESULT OF SO MANY REPAIRS ON THIS VEHICLE, I WILL NEVER OWN A CHRYSLER-DODGE PRODUCT AGAIN. THANK YOU FOR YOUR TIME AND CONSIDERATION. *TR

ENGINE CRADLE IS COMPLETELY RUSTED OUT ON OUR 2007 DODGE CALIBER SXT. I HAVE NEVER SEEN SOMETHING LIKE THIS ON A CAR THAT'S NOT TOO OLD. LOOKING AT THE ENGINE CRADLE IT HAS A HOLE ABOUT 12 INCHES ROUND AND ALONG THE ENGINE CRADLE SUPPORT OR WHATEVER ITS CALLED THAT STICKS UP IN THE AIR WELDED TO THE CRADLE ...UPDATED 07/30/15 *BF THE CONSUMER STATED THE PART WAS REPLACED AT NOT CHARGE. UPDATED 08/13/14*JB

FRONT OF VEHICLE STARTED TO SHAKE AND DRIVERS SIDE FRONT MADE CREAKING NOISE. TOOK VEHICLE TO DEALER AND THEY STATED FRONT STRUTS AND COMPONENTS WERE BAD AS WELL AS DRIVERS SIDE BALL JOINT. VEHICLE WAS REPAIRED HOWEVER THERE IS VIBRATION IN THE STEERING AND THE VEHICLE PULLS HARD RIGHT. ALSO FRONT END MAKES A LOT OF NOISE. DEALER PERFORMED FRONT WHEEL ALIGNMENT AND BALANCED TIRES BUT PROBLEM IS STILL THERE AND MECHANICS CAN'T FIND THE ISSUE. VEHICLE IS UNSAFE TO DRIVE AND AM VERY AFRAID TO DRIVE IT ESPECIALLY SINCE I'M DISABLED WITH YOUNG CHILDREN. THERE ARE NUMEROUS COMPLAINTS ABOUT THE SUSPENSION ISSUES WITH THESE CARS AND THE PROBLEMS NEED TO BE FIXED BEFORE SOMEONE GETS SERIOUSLY INJURED OR KILLED. CAN'T UNDERSTAND WHY NOTHING IS BEING DONE AFTER ALL OF THESE COMPLAINTS HAVE BEEN MADE BY SO MANY. THIS IS WHY PEOPLE DON'T BUY AMERICAN CARS ANYMORE. FOREIGN MANUFACTURERS WILL ACTUALLY RECALL VEHICLES AND STAND BEHIND THEIR PRODUCTS.

MY WIFE WAS DRIVING MY CAR HEARD A SQUEALING NOISE AND COULD NOT CONTROL THE CAR. THE STEERING SEEMED VERY LOSE. SHE WAS BY A GARAGE AND STOPPED AND LEFT THE CAR THERE. TODAY THEY LOOKED AT THE CAR AND SEND THE UNDERCARRIAGE WAS SHOT AND COULD NOT BE FIXED.. CAN CHRYSLER BE NOTIFIED OF THIS AND SHOULD WE GET A SECOND OPINION? ITS A GOOD THING THIS HAPPENED ON A BACK ROAD WITH NO TRAFFIC OR MY WIFE COULD HAVE BEEN SERIOUSLY INJURED.

UPON DRIVING HOME FROM WORK IN FEBRUARY OF 2015, I NOTICED A HORRIBLE NOSE COMING FROM THE FRONT OF MY CAR. AS THE DAYS PROGRESSED, THE NOSE HAD BECOME WORSE. I HAD ASSUMED THERE WAS A PROBLEM WITH THE STRUTS AND HAD THEM REPLACED RIGHT AWAY. MY FATHER IN LAW, A MECHANIC, SAW THAT THE FRONT SUB FRAME CROSS MEMBER IS COMPLETELY RUSTED OUT. I WAS THEN TOLD BY SEVERAL MECHANICS THAT THE CAR IS UNSAFE TO DRIVE DUE TO THE AMOUNT RUST ON THE SUB FRAME AND THE HIGH RISK OF THE CROSS MEMBER BREAKING THUS CAUSING AN ACCIDENT. AFTER MUCH RESEARCH, IT HAS COME TO MY KNOWLEDGE THAT THIS IS A MANUFACTURERS PROBLEM AND NOTHING HAS EVER BEEN DONE ABOUT IT. THE A/C UNIT IS LOCATED RIGHT ABOVE THE CROSS MEMBER. THIS UNIT IS LEAKING WATER ONTO THE SUB FRAME THUS CAUSING THE PART TO RUST.

TL* THE CONTACT OWNS A 2007 DODGE CALIBER. WHILE DRIVING AT 40 MPH, THERE WAS AN ABNORMAL NOISE THAT CAME FROM THE UNDERCARRIAGE. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO DIAGNOSED THAT THE SUBFRAME AND SWAY BAR NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 138,000.

DRIVING NORMALLY ON A TOWN ROAD AND I HEARD A THUD. STEERING WHEEL JERKED AND CAME BACK TO CENTER. CAR SWERVED INTO THE ONCOMING TRAFFIC LANE. DROVE HOME AT A STEADY CRAWL WITH FRONT END SHAKING AND FEELING REAL LOOSE. CHECKED MY FRONT END AND COULD SEE MY SPRING BINDING OVER THE STRUT AND STRUT MOUNTS WERE SQUEAKING AND MAKING NOISE WHILE TURNING THE STEERING WHEEL. STRUT RODS WERE STUCK AND WOULD NOT COMPRESS. ORDERED NEW STRUTS AND MOUNTS. WILL BE REPLACING AS SOON AS THEY COME IN. GLAD THIS DIDN'T HAPPEN ON THE HIGHWAY AND THERE WERE NO CARS COMING IN THE ONCOMING LANE OR THERE WOULD HAVE BEEN A SERIOUS CRASH. *TR

TL*THE CONTACT OWNS A 2007 DODGE CALIBER. THE CONTACT STATED THAT THE CROSS MEMBERS ON THE VEHICLE HAD RUSTED THROUGH. THE CONTACT STATED THAT THE STEERING WHEEL WOULD SHAKE WHILE DRIVING AT 50 MPH OR OVER. THE VEHICLE WAS TAKEN TO THE DEALER WHERE IT WAS DETERMINED THAT THE CROSS MEMBERS NEEDED TO BE REPLACED. THE VEHICLE HAD NOT BEEN REPAIRED. THE FAILURE MILEAGE WAS 87,000.