IllustrationSWAY BAR LOCATED TOO CLOSE TO TIRE THAT KEEPS BACK END STABLE. BACK TIRES RUB AGAINST SWAY ARM. ALSO, CAN'T PUT FINGER BETWEEN SWAY BAR AND TIRE. CONTACTED DEALER, AND WAS TOLD TO BRING VEHICLE IN.*AK
1997 Chrysler Sebring
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 1997 Chrysler Sebring do not stand out strongly from the model-year median of 132.
About this comparison →How this year compares
Owner complaints by model year
Compare all Sebring years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 34 of 210 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Service Brakes, Hydraulic. Review the 30 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 29 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Suspension. Review the 28 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
36 crash reports4 fire reports16 injury reports
Suspension complaints
28 reportsCONTROL ARM MALFUNCTIONED DUE TO DEFECTIVE BALL JOINTS. CONSUMER HEARD A CREEKING NOISE AND A LOUD BUMP WHEN TURNING. PLEASE PROVIDE ANY FURTHER INFORMATION. *AK
CONSUMER RECEIVED NHTSA RECALL NOTICE 00V421002000/MANUFACTURER'S RECALL 967. VEHICLE WAS STARTING TO MAKE A RATTLING NOISE, AND CONSUMER DECIDED TO HAVE IT CHECKED OUT. DEALER FOUND NO PROBLEM, AND STATED THAT BALL JOINTS WERE OKAY, AND DIDN'T NEED TO BE REPAIRED. RATTLING NOISE GOT WORSE, AND CONSUMER WENT TO A MECHAN…
Read full complaint
CONSUMER RECEIVED NHTSA RECALL NOTICE 00V421002000/MANUFACTURER'S RECALL 967. VEHICLE WAS STARTING TO MAKE A RATTLING NOISE, AND CONSUMER DECIDED TO HAVE IT CHECKED OUT. DEALER FOUND NO PROBLEM, AND STATED THAT BALL JOINTS WERE OKAY, AND DIDN'T NEED TO BE REPAIRED. RATTLING NOISE GOT WORSE, AND CONSUMER WENT TO A MECHANIC WHO WOULD NOT LET VEHICLE LEAVE THE LOT BECAUSE BALL JOINTS WERE DEFECTIVE, AND VEHICLE COULD EASILY LOSE STEERING. CONSUMER HAS BEEN WAITING FOR CONTACT SINCE JULY FROM MANUFACTURER. *AK
THE CONSUMER RECEIVED A RECALL (00V421002) NOTICE REGARDING BALL JOINTS AND TOOK VEHICLE TO THE DEALER. THE RECALL COULD NOT BE PERFORMED BY THE DEALER BECAUSE THE PART WAS ON NATIONAL BACK ORDER. *YH
STEERING WOULD MAKE LOUD NOISES WHEN TURNING AND WOULD JERK VEHICLE. TOOK VEHICLE TO MECHANIC, AND WAS INFORMED THAT IT WAS THE BALL JOINTS WHICH WERE RUSTED AND WERE REPLACED. *AK
WHEN DRIVING AT 65MPH THERE WOULD BE A LOT OF NOISE. VEHICLE NOT CONTROLLABLE; WOULD DRIF, AN D PULL TO RIGHT ONLY. *AK
FRONT END WAS NOT RIDING RIGHT, IFTURN STEERING WHEEL SOMETHING IN FRONT WOULD POP.*AK
RECALL 97V201000; LOWER BALL JOINT WITH CONTROL ON BOTH SIDES, DEALER STATED THAT THIS VEHICLE'S VIN NUMBER WAS NOT INCLUDED IN RECALL. ROTORS, BRAKE PADS AND CALIPERS NEEDED REPLACED. VEHICLE EXPERIENCED AN OIL LEAK. LOCKS DO NOT WORK. *SLC
1997 SEBRING'S RECALLED FOR THIS REASON. WHEN I CONTACTED CHRYSLER THEY SAID THIS PARTICULAR CAR DID NOT HAVE A RECALL. WHY, THEN, DID THIS HAPPEN TO MY CAR. I REPORTED THE FRONT END OF THE CAR TWICE. THE FIRST TIME, WHEN THE CAR WAS UNDER WARRANTY, NOTHING WAS WRONG WITH IT. THE SECOND TIME, NOT UNDER WARRANTY, THERE WAS 3…
Read full complaint
1997 SEBRING'S RECALLED FOR THIS REASON. WHEN I CONTACTED CHRYSLER THEY SAID THIS PARTICULAR CAR DID NOT HAVE A RECALL. WHY, THEN, DID THIS HAPPEN TO MY CAR. I REPORTED THE FRONT END OF THE CAR TWICE. THE FIRST TIME, WHEN THE CAR WAS UNDER WARRANTY, NOTHING WAS WRONG WITH IT. THE SECOND TIME, NOT UNDER WARRANTY, THERE WAS 3,500 WORTH OF DAMAGE. THE DEALER TOLD CHRYSLER IT WAS CAUSED BY AN ACCIDENT. I NEVER HAD AN ACCIDENT IN THIS CAR. *AKPERHAPS, BEFORE I OWNED IT?
BACK LATERAL WENT OUT, IT SNAPPED IN HALF. THE DEFECT MADE CONSUMER LOSE CONTROL OF STEERING WHEEL AND RUN INTO A DITCH. DEALER REFERRED CONSUMER TO CALL HOTLINE. *AK
Official recalls
502V186000 · Vehicle Speed Control
Jul 8, 2002
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.5L V6 ENGINES, THE THROTTLE CONTROL CABLE CAN FRAY CAUSING THE THROTTLE TO BIND OR STICK.
Consequence & remedy
Consequence: THIS COULD POTENTIALLY RESULT IN A LOSS OF THROTTLE CONTROL, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REPLACE THE THROTTLE CABLE ASSEMBLY. OWNER NOTIFICATION BEGAN AUGUST 5, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
00V421002 · Suspension:front:control Arm:lower Ball Joint
Dec 18, 2000
VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.
Consequence & remedy
Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.
Remedy: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.
98V183000 · Power Train:automatic Transmission:park/neutral Start Interlock Switch
Aug 6, 1998
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS. THE ADJUSTMENT OF THE CABLE CONNECTING THE CONSOLE SHIFTER MECHANISM TO THE IGNITION KEY CAN CAUSE A TRAPPED KEY CONDITION WHICH CAN RESULT IN A LOW FORCE REQUIRED TO DEPRESS THE SHIFT BUTTON. A COMBINATION OF APPLYING A MIS-ADJUSTED RELEASE BUTTON WITH A LOW FORCE ATTEMPT TO SHIFT OUT OF PARK WITH THE KEY IN THE LOCKED POSITION, CAN BREAK THE CONNECTING PIN IN THE SHIFTER.
Consequence & remedy
Consequence: IF THIS HAPPENS, THE "IGNITION-PARK" INTERLOCK SYSTEM WILL BE NONFUNCTIONAL.
Remedy: DEALERS WILL INSPECT FOR PROPER OPERATION OF THE SYSTEM. ANY VEHICLES THAT ARE NOT FUNCTIONAL AFTER THE INSPECTION WILL HAVE THE SHIFT MECHANISM AND CABLE REPLACED WITH A "SELF-ADJUSTING" DESIGN.
97V201000 · Suspension:front:control Arm:lower Ball Joint
Nov 13, 1997
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE LOWER CONTROL ARM BALL JOINT CAN SEPARATE DUE TO LOSS OF LUBRICATION.
Consequence & remedy
Consequence: SEPARATION OF THE BALL JOINT COULD CAUSE A LOSS OF STEERING CONTROL INCREASING THE RISK OF A VEHICLE CRASH.
Remedy: DEALERS WILL INSPECT THE BALL JOINT END HOUSING COVER SEAL FOR LEAKAGE WITH A HIGH PRESSURE AIR TESTER AND THE RUBBER BOOT WILL BE VISUALLY INSPECTED FOR DAMAGE. IF THE COVER SEAL LEAKS OR THE BOOT IS DAMAGED, THE LOWER CONTROL ARM WILL BE REPLACED.
97V081002 · Seats:front Assembly:head Restraint
Aug 8, 1997
THE HEADREST GUIDE BRACKET WAS IMPROPERLY WELDED TO THE SEAT BACK FRAME ON THE PASSENGER SIDE SEAT BACK ASSEMBLIES ONLY.
Consequence & remedy
Consequence: THE HEADREST SUPPORT BRACKET CAN BREAK, INCREASING THE RISK OF PERSONAL INJURY.
Remedy: DEALERS WILL REPLACE THE PASSENGER SEAT BACK ASSEMBLY WITH A NEW ASSEMBLY.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
5PE02082 · Safety Belt Cinching Latch Plate
Opened Nov 6, 2002 · Closed Apr 23, 2003
Status: closed (inferred from source dates) · Seat Belts
THERE ARE NO INJURIES OR FATALITIES ASSOCIATED WITH THIS ALLEGED DEFECT.WHILE CONDUCTING THIS INVESTIGATION, ODI FOUND THAT THE SUBJECT CINCHES MEET THE LOAD BEARING REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 208, AND THAT MANY OF THE REPORTED FAILURES WERE DUE TO INCORRECT CHILD SAFETY SEAT INSTALLATIONS. ADDITIONALLY, THE REPORT RATE IS LOW (1.60/100K).THE INFORMATION AVAILABLE FAILS TO ESTABLISH THE EXISTENCE OF A DEFECT TREND AT THIS TIME.FURTHER ALLOCATION OF AGENCY RESOURCES TO THIS ISSUE IS UNWARRANTED AND THE PRELIMINARY EVALUATION IS BEING CLOSED.
EA99028 · Steering Shaft Binding
Opened Sep 10, 1999 · Closed Jul 26, 2001
Status: closed (inferred from source dates) · Steering
There is no summary currently available
PE99030 · Steering Shaft Binding
Opened May 3, 1999 · Closed Sep 10, 1999
Status: closed (inferred from source dates) · Steering
There is no summary currently available
EA98014 · Automatic Transaxle Ignition Interlock
Opened May 29, 1998 · Closed Sep 14, 1998
Status: closed (inferred from source dates) · Power Train
ALLEGED FAILURE OF THE AUTOMATIC TRANSAXLE IGNITION INTERLOCK SYSTEM THAT EITHER ALLOWS THE IGNITION KEY TO BE REMOVED WHEN THE TRANSMISSION GEAR SELECTOR IS NOT IN THE PARK POSITION AND THE TRANSMISSION GEAR SELECTOR TO BE SHIFTED WHEN THE IGNITION KEY IS REMOVED OR PREVENTS THEIGNITION KEY FROM BEING REMOVED WHEN THE TRANSMISSION GEAR SELECTOR IS IN THE PARK, OR ANY OTHER, POSITION.
EA97025 · Convertible Top Cover Disengagement
Opened Nov 24, 1997 · Closed Nov 17, 1998
Status: closed (inferred from source dates) · Structure
ALLEGED THAT THE CONVERTIBLE TOP COVER MAY DISENGAGE FROM THE SUBJECT VEHICLES WHILE DRIVING.