2023 Chevrolet Silverado 2500

I recently discovered that Tasca Buick GMC Palm Harbor (located at [XXX]) submitted official paperwork stating they completed a safety recall. However, this work was never performed. My truck was never brought to this dealership, and I have never been to this facility on the date listed in their report Filing a completion record for a safety recall without performing the actual repair is a severe safety hazard and constitutes fraudulent reporting to a federal agency.Desired Resolution:I request that NHTSA investigate Tasca Buick GMC Palm Harbor for fraudulent warranty and recall record filings. I also request that the recall status for my vehicle be reset to "Incomplete" in the national database so I can take it to a trustworthy dealer to get the actual safety repair performed NHTSA Campaign 24V-060 / GM Recall N232426400 (Power-Unlatching Tailgate Switch Replacement) INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I am filing this complaint regarding my 2023 Chevrolet Silverado 2500HD, which has approximately 20,000 miles and has been babied since new. The truck is maintained meticulously and the undercarriage is washed weekly. The brake failures I have experienced are completely unacceptable for a truck with this mileage and maintenance history. Both the FRONT and REAR brake friction material has completely DELAMINATED from the brake components. This is not normal brake wear. The material has separated from the underlying metal, which I believe is a serious material/manufacturing-quality issue. The dealer is now reporting that the rear emergency/parking brake shoes are also defective and require replacement. These components are inside the rear rotor and are not visible during a normal inspection. I strongly dispute any suggestion that this is simply corrosion or abuse. This truck is babied, maintained properly, and the undercarriage is washed every week specifically to prevent buildup and corrosion. At only 20,000 miles, having the front brakes, rear brakes, AND parking-brake shoes fail is completely unacceptable. The brake failures are also part of a disturbing pattern of component failures on this truck. The A/C compressor failed, leaving me without reliable air conditioning and resulting in a SIX-WEEK wait for replacement during the middle of summer. Additionally, only FIVE DAYS after I purchased the truck brand new, it required replacement of the Engine Control Module. This is a 2023 truck with only 20,000 miles. I expect normal wear items to wear normally—not to physically delaminate and fail. I am requesting that NHTSA investigate whether there is a systemic safety or manufacturing defect involving the brake materials/components used on these trucks. A brake component physically separating from its backing material is a serious safety concern and should not be dismissed as routine maintenance. GM needs to be held accountable for the quality and safety of this

I was on a two lane driving down the road and getting up to speed. I was still about 45 miles per hour on my way up to 55 mph my vehicle started de rating very fast as I’m driving and then my engine shut off. I had no control over my steering as I made a turn to get off the two-lane road because there was no shoulder. I had to turn the steering wheel really hard and was not able to control the vehicle at all because the engine shut down completely. Everything shut down. I was sticking out in the road. I have no clue yet. What caused it I had to get it towed to a dealership. I just thank God I wasn’t on an interstate but still I was on a two lane and had just topped over a small hill where nobody could see me when they topped the little hill. It could’ve been a very dangerous situation.