2018 Chevrolet Malibu

Cam-driven Brake Booster Vacuum failure without warning. My engine died, my brake pedal and steering wheel stiffened, while in moderate traffic. I had use excessive brake force to slow my vehicle to a stop. Currently have 78,012 miles as it is sitting in the repairs shop. This is the first time it has happened, but I worry it may happen again because upon further research, it is a very common part failure.

While picking my kids up from school my car suddenly lost braking ability and I heard a weird noise under the hood. Like it needed an oil change. Tension from the brakes and couldn’t stop when tried. Definitely gained anxiety from this event. I did get the part replaced however I’m concerned for the engine and any possible damage that may have been caused. I still have the original part to the vehicle as well.

12/27/2021 I started my car to leave work & noticed a loud tap. I've worked for dealerships in the past & was part owner of my own repair shop for many years. Popped the hood, checked the oil level which was good, & figured I'd be fine to drive it home to park it & then hook the scanner up. Mid-way home I received an engine performance notification on my dash, but other than that it seemed safe with no diminished speed. Less than 3 miles from home I went to stop at a red light & had the hardest brake pedal I've ever felt in my life. I was fortunate nobody was around me so I put all the weight of my body on the pedal to stop the car at the light. The engine was sputtering & the steering felt tight & it felt like it was stalling, with a green turn arrow I risked crossing the highway & was able to safely park in the community's rec center. I'm not one who is quick to take anything to the dealership because many times the techs are lazy, so I hit the web & found two things. One - there is an extended warranty on the TPS sensor which is the entire gas pedal itself. This could explain the engine performance notification, but not the lack of brakes. Upon hours & hours of additional reading I found the problem - the vacuum brake pump. We ordered it & replaced it but I can tell you my engine likely needs an additional camshaft replacement for it to ever be right again. Two codes remain: P0014 & P0017 - Exhaust camshaft/crankshaft position not plausible. What was the condition of the vacuum pump? It was SHATTERED & had spewed chunks of metal directly into my engine. I was lucky that day, had I gotten 1/4 mile down the road I could have wound up in a lake instead of a parking lot. GM should be ASHAMED of this design & it's continued failure to not only address the issue, but lie about it in the process. First owner, failure occurred at 54,500 miles - no warranty. What scares me the most, is how many times the same owner has had this pump fail again & again.

8 months ago brakes failed, you could stop but they were hard and stretched stopping distance, vacuum pump failure was the cause, when it failed it broke apart and sent parts into the engine, (valve cover ). Replaced vacuum pump removed valve cover and fished out the broken pieces, was lucky on this occasion, fast forward 8 months later , the mother of my kids was on freeway and car completely died,, got it to dealer and was informed, vacuum pump failed again sending metal fragments into the valve cover but this time pieces destroyed the cam and caused the reluctor to slip thus causing ecm to shut down engine. I’m concerned with there not being some sort of housing inside the valve cover cupping the side of cam that meets vacuum pump to shield engine components from metal pieces incase vac pump broke into pieces since vacuum pump isn’t part of the engine itself and the torque of cam shaft up against the gear on vac pump is very high, the expectation of parts braking off is highly likely, and there nothing protecting your engine from those fragments.. I’m not the smartest but I would not think a $100 external part could destroy and engine and take your braking function without any warning. I guess if I happen once I wouldn’t think to much into it but for the third time and being extreamly lucky on the first two occasions and taking responsibility for repairs are totally uncalled for , so now I have to replace and engine, WOW... I hope this can be addressed before someone actually gets hurt, I’m so lucky that my kids mother was able to coast off the highway b/c it could have been bad..

The vacuum pump on my vehicle has gone out for the 3rd time in 2.5 years. This creates a safety issue as that the brakes stop working and it takes an extreme amount of pressure for the car to stop. This has occurred once on the freeway and twice in heavy traffic areas. This could cause an accident and potentially seriously hurt or kill someone. This has occurred once before the engine was replaced and twice since it's been replaced.

MY VEHICLE ACTS AS IF IT DOESNT WANT TO START AFTER BEING AT A RED LIGHT OR STOP SIGN WHEN MY FEET IS RELEASED OFF THE BREAK IT TAKES A FEW SECONDS TO START BACK UP. ALSO I HAVE ISSUES WITH CHECK ENGINE LIGHT COMING ON TOOK IT TO AUTO ZONE AND THEY RECEIVED A CODE DEALING WITH THE WIRING ON THE BATTERY NOT THE ACTUAL BATTERY NEEDING TO BE REPLACED

The contact owns a 2018 Chevrolet Malibu. The contact stated that the vehicle failed to start up. Additionally, the brake pedal was applied but was hard to depress. The engine power reduced message was displayed. The check engine warning light was illuminated. The vehicle was towed to the local dealer where NHTSA Campaign Number: 19V642000 (Electrical System, Fuel System, Gasoline, engine) was completed. The vehicle was repaired however, the failure recurred. The manufacturer was not contacted. The failure mileage was approximately 130,000.