2016 Chevrolet Malibu

2016 Chevrolet Malibu Hybrid LT 1.8L - current mileage 147,059 miles The factory exhaust heat exchanger failed internally, leaking engine coolant into the exhaust system. This caused check engine codes P0401 / P26BE, loss of cabin heat, coolant loss, and exhaust fumes entering cabin. GM has released 4 revisions of this part and all fail the same way, indicating known defective design. The part is currently on indefinite national backorder with no ETA from GM (Order #343585 from GMPartsNow on 08/22/2025 held without ship date). Dealers quote $1,587 and cannot obtain part either. This is a safety and emissions defect: coolant loss risks engine overheating, exhaust leak risks carbon monoxide in cabin, and coolant contaminates catalytic converter. GM discontinued Malibu Hybrid in 2019 without proper fix. This should be recalled. They produced a car, we bought it and now they don’t have the overpriced parts in stock to fix my car and when the parts is backordered, I keep driving it because i can’t work without my car which I very much need, the hybrid battery gets overheated, then they sell battery too and other damages too which will cost thousands to fix. This is a scam!

My car started overheating on my way home. I pulled over to find that there is a hole in my lower radiator hose, which was caused by the lower radiator hose being rubbed against the belt that is turned by the water pump. I had my wife and child bring me coolant on the side of the road where I was broken down. I eventually was able to get my car to my brothers but it required multiple stops and refilling of coolant. Once we got the car jacked up and the lower radiator hose replaced, we found the bottom of the radiator is loose and is pushing the lower radiator hose against the belt that rubbed the hole into the lower radiator hose. I then had my car towed to Dan Cummins in Georgetown Kentucky, located at 1470 Cherry Blossom Way, Georgetown, KY 40324. The mechanic drove my car that I had towed to the shop which damaged the new radiator hose that I had just put on the car. Dan Cummins of Georgetown Kentucky, who is an authorized Chevrolet Dealership, was informed (by me) that some 2016 Chevy Malibu's have been recalled because of a faulty lower radiator mount causing the lower radiator hose to push against the belt which causes the lower radiator hose to get a hole and leak. Dan Cummins suggested that I report my issue because my VIN is not covered by the recall. Authorized Chevy dealer Dan Cummins also suggested that I take my car elsewhere to be repaired while refusing to cover the damage they caused to the brand new lower radiator hose that I had purchased and put on the car. I would like for my Chevy Malibu with VIN [XXX] added to the recall so that I can have my Chevy Malibu repaired by an authorized Chevy dealership at no cost to me for something I did not do or cause. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

On 04/28/2026, when diagnosing a reoccurring check engine light on the vehicle at a Chevy Certified Service, the mechanic "Borescoped cylinder 4 and found significant scuffs on the cylinder wall which along with the misfires indicate a cracked piston. The big picture appears to be the piston cracked which caused excessive oil consumption and misfires. The excess oil and unburned fuel overloaded the converter causing it to fail. The engine and converter will need to be replaced." In 2017, a recall was issued by GM to mitigate Stochastic Pre-Ignition (SPI) Causing Cracked Piston (17019). Between the initial purchase of the vehicle (11/2016) and performed service required by this recall (03/10/2017), there were approximately 5000 miles driven. No engine diagnosis was performed or recommended. After the 17019 was addressed, the engine misfires continued along with reoccurring CEL. C.S.P. N182195660 Predictive Monitoring for Stochastic Pre-ignition (SPI) released in 2019 states the 1.5 L LFV engines in certain 2016 and 2017 model year Chevrolet Malibu vehicles may have a preignition condition that requires immediate repair. This condition may cause the engine to perform poorly, misfire, run rough, and/or excessively consume oil. It may also illuminate the vehicle’s service engine light. Over time, if not repaired, the condition can damage the vehicle’s pistons and engine. The VIN for this Malibu was not attached to this notice despite it having SPI recall history. On 06/2023 (after the N182195660 program ended), at 80k miles a diagnosis revealed a potential cracked cylinder with no mention of the pre-ignition condition that could cause the crack, and the only way to fix is to replace the entire engine (as per dealer recomendation). Since vehicle was out of warranty, the repair est. was nearly $10k. I firmly believe my 2016 Malibu has suffered the consequences of poor mismanagement on this recall, and am demanding mitigation from GM to fix this issue.

My car will rev up to 4000 rpm’s and my car will not go about 20 mph. My cruise stopped working after my car went into reduce engine power. The dealership said they fixed all issues but was back to doing the high rev within a week. It started this week telling me to shift to park even though my car was in park. The shift to park cable has been replaced twice now. I have been dealing with this since July of 2025. My car has been in the shop more times than I can count.

Fuel Injector Backing ring Failing causing O-ring to dislodge and Rupture due to high pressure fuel leaking past the seal. This is causing a Major fire Hazard. Gm seal kits will not fix the problem do to Backer ring not being in the kit. part number for the o-ring kit is 12673056. this part should not be sold without the backer ring. if installed without the rings they will fail and will be Leaking fuel on the hot Cylinder next to the ignition coils. Misfire and bad fuel smell and possible no start or Fire!!