2017 Chevrolet Equinox

When I was driving the vehicle, the dash said low pressure oil turn car off. Not even enough time to find a place to pull over. It just shuts off. Had been going 55 instead of 35. I could’ve gotten rear-ended with it just shutting off talk to a Car repair shop and they said those are all starting to do that the rear main seal blowing out. They didn’t have a big enough hole in the intake and it’s plugging up and building pressure and blowing the rear main seal.

My engine failed. It's available for inspection upon request. The engine stalled in the middle of high traffic. I called GM customer care and explained to them what happened. They told me to take it to a GM dealership for diagnosis, (it was already diagnosed by a major company). The dealership confirmed a broken timing chain and bent valves. They also said that it was $12,000 to repair and that GM would only cover $1,200 since its out of drive train warranty. They request that I put down $8,657 before they could order a new engine. The codes the car gave were P0016, P0017, P228D, P0089, and P0341.

My 2017 equinox which I purchased at this dealership starting burning excessive oil and has bad piston rings, they quoted me a $9500 for engine... I had those issues at 97500 miles and the dealership failed to properly inspect and fix the rings even though this motor was known for these issues. The failed piston rings should have been fixed when my vehicle was covered under warranty at approx 97,500 miles! My equinox has approx 100,600 miles on it currently and has sat for 1.5 months. So 600 miles past the warranty and now it needs a new engine? It needs a new engine because the service department knowingly failed to thoroughly fix my car when I had it in at 97,500 miles.

I am a recent 2017 Equinox owner with a 2.4L Ecotec engine. I purchased the vehicle 9 months ago and have put less than 30k miles on it since owning the vehicle. On Tuesday, 1.31.23, while driving to a work appointment on a busy interstate my equinox seemed to have a power failure and started making a noise. I proceeded to move toward the shoulder of the highway and before I could get to the shoulder, a warning light came on that there was low oil pressure, to stop the vehicle. Before I could safely get all the way to the shoulder, the car shut off and the engine ceased. From the time my vehicle started making noises, to it ceasing on that 4-degree weather day, was bout 6 seconds. The mechanic states the engine is ceased and that it would be about 10k for a remanufactured engine installed. No guarantees that this would not happen in the future as this is a manufacturer's defect in the size of the PCV system that is on vehicles with this motor, the 2.4L ecotec . The mechanic states that the rear engine seal has failed. This was caused by the defective PCV valve being too small which causes excessive pressure to build up and the rear main engine seal to fail. This is a known issue for vernal motors. There are literal thousands of people in this same situation, and I could have been killed by oncoming traffic had I not been able to get to the shoulder all the way. I have documents relating to this system failure and copies of the bulletins that gm has issued their dealerships, however the file is too large to attach here. Please email me for documentation.

The rear main seal on the vehicle broke and dumped oil onto the road. The vehicle instantly stopped being able to accelerate, but no engine lights came on. My safety was put at risk as I was on a main county road in heavy traffic. Luckily, I was able to pull into a parking lot, but had it happened five minutes later, I would have been stranded on the side of the interstate. Prior to this incident, my vehicle has been in near mint condition and has regularly been serviced for upkeep. At the time of the repair, there were other cars of the same model with this issue in the repair shop. It left me without a vehicle for five days, and cost just south of $1,300. For a vehicle of this age, milage, and condition to have this kind of mechanical error is not acceptable, especially knowing it is a common issue with this model. General Motors should issue a recall on this as it has the potential to leave someone in a very dangerous situation.

I arrived at my workplace. Was there for about an hour, I then went outside to grab something from my vehicle and noticed that I was leaking oil. After further inspection, I realized that I no longer had oil in my vehicle. I had it towed to my service station. After looking at it they called me and said that the PCV had gotten clogged with ice, therefore causing pressure buildup and blowing out the rear main seal. There were no warning lights whatsoever of this problem. I am just happy that I wasn't on the highway or long drive, because this would have left me stranded or worse causing an accident. From doing research online, this seems to be an issue that GM is aware of and refuses to make right. They had a recall for this exact issue for model years 2010-2014 but now are refusing to issue one for later years, even though the same engine style and PCV placement are the same. Not telling their customers about this potential serious issue is almost criminal and then not standing behind their product with either a recall or reimbursement of cost of repairing is ridiculous.

Several transmission components and functions have failed. This has caused dangerous lurching while gears change and the loss of the ability to move forward, all while driving and without warning. The transfer case also failed, resulting in similar lurching, as well as bouncing and grinding. This problem has been attempted to be repaired multiple times with the dealership returning the car each time claiming that it was repaired, inspected and found good. In all cases the same problem reoccurred within 50 miles of driving. There were no warning lights or symptoms leading up to the failure which would worsen as time went on. The lurching generally occurred when reducing speed, which would unexpectedly bounce the vehicle towards other slowing vehicles, greatly increasing the likelihood of rear ending another driver. When the complete loss of forward function occurred, it had done so similarly while slowing down, which nearly resulted in another driver rear ending us. Fortunately, the reverse gear still worked and the car was able to be removed from the road. The unexpected nature of the behavior of the car and the failures in general, paired with the false assurance from the dealership that the problem was fixed, left the driver highly likely of being involved in a collision.

Chevy is already well aware there is a prominent issue with timing chains on their equinox model and refuses to acknowledge or recall the issue. This is the second major repair I am needing to my vehicle in just barely over 1 year. Both the timing chain and the rear main seal need repairs in approx 1 years time. Again, these are known issues Chevy refuses to acknowledge that is costing many customers thousands of dollars.