2020 Chevrolet Blazer

Engine showing PO128 code. Steering Assist System reduced power. Engine fan constantly running. Engine temp on dash is stuck on the "C" mark, doesn't move. Thermostat and temp sensor replaced, issue continues. THIS IS A VERY COMMON PROBLEM ON GM VEHICLES WITH THE 3.6L AROUND THE 60,000 MILE MARK. GM NEEDS TO GET IT FIGURED OUT.

The driver information center suddenly indicated steering assist disabled, temperature gauge drops to below cold, air conditioning blows warm air. This issue has happened several times and is able to be reset by disconnecting/reconnecting the battery or using a scan tool. Temperature sensor is not the cause in my opinion, and I have read that the harness for the temperature sensor also includes the coil wires, which can lead to electrical/rf interference, triggering this issue. I have read about many owners having this same issue, even after temperature sensor and thermostat replacement, at low mileages. This should be recalled and handled by GM, whatever the cause.

Action required steering assist reduced and coolant temperature at 0. Air con blowing hot and check engine light on. The vehicle became hard to handle and keep in my lane on the interstate at high speeds. The problem has persisted. It has not been recitfied. I am not driving the car to avoid damage and danger. I bought the blazer on 1/6/26. The lights and issues began 8 days later. Dealership will not help me. 2020 Blazer RS AWD bought from Morgan city Toyota Louisiana

1) Part that failed per General Motors Chevrolet dealer was the Thermostat along with Coolant Sensor. 2) I was getting warning notices on dash board screen stating (Reduced steering assist) I was also getting a ESC warning 3) Problem has been repaired at GM dealer 4) Parts were replaced by GM dealer/service center 5) ESC warning light that came on for a short time after motor stopped for auto stop / start and then restarted. If auto stop / start was turned off ESC warning did not come on. Reduced steering assist warning would come on but then go off. Finally the service engine light came on and stayed on. 6) GM Service stated Code for engine light was P01F0. Autozone read a P0128 code. 7) From investigating online this seems to be a very common problem with the 2019 and 2020 Chevrolet Blazer with the 6 cylinder engine. Note: I believe this should be a warranty repair due to the fact that 1) This is a known issue with the 2020 Blazer and known poor design 2) The warning about reduced steering assist and 3) ESC warning

Where do I start. Spring of 2024 I believe, less than 55,000 miles, my transmission went out. No warning. I just went out to my vehicle to go to work and when I put it into reverse, my vehicle make a awful noise, jerked forward almost going into my garage door, then wouldn't move.. I put it back in park, tried to put into reverse again and it wouldn't go. It was stuck in park. Had to get it towed to the dealership where they advised me the transmission went out. It was covered under the drivetrain warranty, but the GM warranty doesn't cover rental. It took almost 4 weeks for GM to approve for a new transmission due to parts being on back order to rebuild my transmission. Several months later, I was driving down the road when the ESC light and then it said "shift to neutral & press start" and I lost power. I coasted into a parking lot, got it fired up, but had no air conditioning (of course it was summer). Took it to the dealer and they said my radiator and A/C Compressor had to be replaced. Luckily my extended warranty covered the $5000 repair. Now 4 months later I got "steering assist reduced, drive with care" with codes. Took to shop and the codes basically was the temp was to low, but the shop couldn't find anything wrong. Cleared the codes and so far so good, but now my ESC light pops on once a week again. I don't even have 60,000 miles on my vehicle.

Component/System Involved: The electric power steering system in my 2020 Chevy Blazer is malfunctioning. A warning appears on the dashboard: “Steering Assist is Reduced – Drive with Care.” When this happens, steering becomes very stiff and difficult. The issue is ongoing, and the component is available for inspection if requested. Safety Risk: This creates a serious safety hazard. The sudden loss of steering assist makes it hard to turn the wheel, especially at low speeds or when maneuvering. It puts me and others at risk, especially if it happens in traffic or while turning. Problem Confirmed by Dealer: No, the issue has not yet been inspected or confirmed by a dealer or service center. Inspection History: The vehicle has not been inspected by a dealership, manufacturer, police, or insurance. Warning Signs: The only warning is the “Steering Assist is Reduced – Drive with Care” message, which appears randomly—sometimes at startup, sometimes while driving. The issue began around 10/15/2024 and continues to be an on going issue.

"Steering Assist Reduced” warning message appears on dashboard display and temperature gauge stuck on cold on the dashboard display. I understand this such a common issue with the 2019 and 2020 Blazer that General Motors has issued Technical Service Bulletins but refuses to repair these vehicles for free. This is unacceptable! Issue a mandatory recall therefore GM must perform the repairs for free.