2022 CAN-AM Ryker

When making left turns, vehicle's rear tire wobbles severely. When doing this, it also causes the handle bars to try and straighten out during the turn almost causing the vehicle to hit a curb or guardrail. This only happens on left turns, never on right turns. After incident, the rear tire suspension feels spongy. I have taken the vehicle back to the dealer for this issue. The had it for 5 weeks and could never reproduce the issue. I have also contacted Can Am BRP about this issue who only recommended that I take the vehicle back to the dealership.

My vehicle start to lose control when I drive around left or right corner the rear end felt like it was bucking or slipping. The VSS fault error and Limp Mode kicked in and the speed doesn't really matter once you are over 20 mph. My vehicle is at the dealership as of 8/13/23 to replace the pitman arm to see if that fix the problem. The VSS fault error happens about 4 times since I brought the vehicle.

I have a 2022 Can-Am Ryker 900 sport. when I purchased it around a week or two later, my left brake and wheel started squeaking loud. I returned it to the dealer. One of the service men said its brand new brakes and tires give it time to wear down.low brake warning came across the screen and my handlebars started feeling loose,a lot of play. I returned it again. They checked my handlebars and fixed my front truck and said my brand new brakes were fine. It wasn’t my handlebars. It was my suspension starting to malfunction making my left brake pad wear uneven low brake warning came across again. I returned it again for the recalls the service man assured me this will fix my problem. last night August 5,2023 I was out, riding with friends, proceeded into a curve, and my handlebars would not allow me to turn my wheels. My left wheel seemed as though it was trying to lock up. I could not turn the curve.it started to do what they call the Death turn. Two of my friends almost ran into the back of me because the bike slowed itself down, My check engine light started flashing VVS fault code came across the screen, I end up hitting the curb scratching my rim, and now the bike is on limp mode.

The cruise control will disconnect randomly causing sudden deceleration. Sometimes it will go off almost immediately after setting it and others it may stay engaged for several miles. It disengaging randomly is a safety issue as I’m not expecting the sudden deceleration and it could cause a vehicle that is following closely to hit me. This issue has been present since I purchased the vehicle and it has been looked at 3 times by the dealer. The first time they adjusted the brake pedal switch, the second time that switch was replaced under recall and the last time the cruise control cable was replaced.

The contact owns a 2022 Can-Am Ryker. The contact received notification of NHTSA Campaign Number: 23V175000 (Exterior Lighting) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. Parts distribution disconnect.

On left hand turns only, even at lower speeds, the VSS system is kicking in, preventing safe control of the vehicle, was almost rear ended today when my vehicle refused to accelerate out of a left hand curve, speeding rating curve was 20mph, I was doing 10mph. This occurs frequently to varying degrees on a regular basis, always on left hand turns only. It's never happened on a right hand trun or curve.