1992 Buick Roadmaster

CONSUMER STATED WITHOUT PRIOR WARNING, THE VEHICLE HESITATES WHEN SHIFTING GEARS.*AK. CONSUMER STATED THE DRIVER WHEEL FELL BROKE OFF DUE TO THE NUTS AND BOLTS HAD BROKEN OFF, THE BRAKES WENT OUT, THE VEHICLE WOULD NOT GO INTO REVERSE, THE THERMOSTAT WENT OUT, PASSENGER WINDOW WOULD NOT ROLL DOWN, TURN SIGANL WAS INOPERATIVE, WINDSHIELD WAS REPLACED, AND THE UPPER BALL JOINTS WERE REPLACED.*SLC

FOLD DOWN SEAT BEHIND DRIVER AND PASSENGER HINGE CUT THROUGH SHOULDER BELTS ON BOTH SIDES OF FOLD DOWN SEAT. THESE BELTS ARE AT LEAST HALF CUT THRU OR SEVEREL DAMAGED IN JUST THE LAST 2 YEARS. THE CUT APPEARS WITHIN 8" OF FLOOR OF VEHICLE. THEY HAD BEEN INSPECTED JUST TWO YEARS AGO. THIS IS SAFETY EQUIPMENT AND SHOULD BE THE RESPONSIBILTIY OF MANUFACTURER TO REPLACE BELTS OR SUPPLY PLASTIC GUARD WHICH WOULD KEEP BELT FROM BEING CUT OR CRUSHED BY SEAT HINGE SHEARING ACTION.*AK

WHILE DRIVING THE VEHICLE, DRIVER HEARD A LOUD BANG AND LOST CONTROL OF THE STEERING OF THE VEHICLE. DRIVER WAS ABLE TO AVOID HITTING ANY OTHER VEHICLE OR RUNNING OFF THE ROAD. HAD VEHICLE BEEN TRAVELING AT HIGHWAY RATE OF SPEED INSTEAD OF 35 MPH, DRIVER AND WIFE COULD HAVE BEEN KILLED OR SERIOUSLY MAIMED NOT TO MENTION OTHERS DRIVING IN THE PROXIMITY OF MY VEHICLE. THE BOLTS HOLDING THE LEFT SIDE UPPER CONTROL ARM ASSEMBLY BROKE FOR NO APPARENT RESASON,. *AK

WHEN VEHICLE WAS EITHER IN DRIVE OR REVERSE AND MAKING A TURN, COULD HEAR A CLUNKING NOISE. THIS PROBLEM OCCURRED AT LOW SPEEDS. HAVE TAKEN VEHICLE TO DEALER AT LEAST 4 OR MORE TIMES. EACH TIME MECHANIC INDICATED NON-SLIP DIFFERENTIAL WAS CAUSING CLUNKING NOISE. MECHANIC DRAINED DIFFERENTIAL, AND REPLACED IT WITH AN ADDITIVE TO HELP RELEASE BETTER.BUT, PROBLEM STILL EXISTS.*AK DEALER HAS: REPLACED THE SERPENTINE BELT, SERVICED THE REAR DIFFERENTIAL TWICE, AND DRAINED AND REFILLED FLUIDS, PROBLEM STILL REMAINS. *SLC

BOLTS ON THE UPPER CONTROL ARM THAT AFFIX THE CONTROL ARM ASSEMBLY WERE EXPOSED TO CONDENSATION CONTAINING BATTERY ACID THAT DRIPPED DOWN THE FRONT OF THE ENGINE BAY SIDE OF THE RIGHT WHEEL WELL, FROM THE POSITIVE BATTERY POST THAT IS DIRECTLY ABOVE IT, AND CORRODED THROUGH THE BOLTS, WHICH SUBSEQUENTLY SHEARED, CAUSING THE RIGHT FRONT SUSPENSION TO COLLAPSE WHILE THE VEHICLE WAS IN MOTION. MECHANIC WHO FIXED IT, ($900.00- INCLUDED REPLACING THE CONTROL ARM, SWAY BAR, TIE ROD, DUE TO BEING BENT WHEN THE SUSPENSION COLLAPSED), STATED THAT THE OVERALL DESIGN WAS POOR, (IN THAT, THE BATTERY IS PLACED IN SUCH A POSITION, AND THE BATTERY STAGE WAS TOO NARROW TO CAPTURE ANY CONDENSATION DRIPPING OFF THE BATTERIES POSITIVE TERMINAL), THAT HE HAD SEEN MANY OF THESE IN THE PAST. IS THERE A RECALL OF THIS? IS BUICK/GM AWARE OF THIS? MY WIFE AND THREE CHILDREN WERE IN THAT CAR AT THE TIME: I CAN'T BELIEVE NONE OF THEM WERE HURT. PLEASE RESPOND ASAP.