IllustrationSTEERING ASSEMBLY ON VEHICLE IS NOT DESIGNED PROPERLY, TURNING RADIUS IS TOO LARGE, STEERING SENSE IS SLUGGISH AND POWER STEERING ASSIST IS NOT ADEQUATE.
1996 Buick Century
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 1996 Buick Century do not stand out strongly from the model-year median of 28.
About this comparison →How this year compares
Owner complaints by model year
Compare all Century years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 14 of 80 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Service Brakes, Hydraulic. Review the 12 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Fuel System, Gasoline. Review the 10 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Steering. Review the 10 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
6 crash reports1 fire reports6 injury reports
Service Brakes, Hydraulic complaints
12 reportsIN JULY 1996, OWNER BEGAN HAVING PROBLEMS W/HIGH IDLE. AREA DEALERSHIP REPLACED COMPUTER BUT VEHICLE STILL EXPERIENCES SAME CONDITION, ALSO, FRONT BRAKE ROTORS/PADS OVERHEATED/REPLACED. *AK
Official recalls
195V173000 · Seat Belts:front:anchorage
Sep 15, 1995
THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."
Consequence & remedy
Consequence: CONSEQUENCE OF NON-COMPLIANCE: IN A COLLISON, STRESS CAN CAUSE THE ATTACHMENT METAL TO TEAR AND ALLOW THE ANCHORAGE TO SEPARATE FROM THE BODY OF THE VEHICLE. THE SAFETY BELT MAY NOT PROTECT AN OCCUPANT IN THE EVENT OF A VEHICLE CRASH.
Remedy: DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.