2009 BMW R1200 Rt

AFTER ENTERING THE INTERSTATE FUEL BEGAN SPEWING FROM THE UPPER LEFT FAIRING AREA. I PULLED OFF AND SHUT IT DOWN. I COULDN'T TELL WHERE IT ORIGINATED FROM. IT DIDN'T APPEAR ANY LONGER SO I DECIDED TO RETURN HOME, ABOUT 2 MILES. UPON ENTERING THE INTERSTATE AGAIN FUEL SPEWED OUT WITH SUCH FORCE IT COVERED MY ENTIRE LEFT SIDE AND LEG. I PULLED OFF ASAP. A MOTORIST SAW ME AND STOPPED TO HELP. HE WAS AFRAID OF A FIRE, AS I WAS, AND PULLED OUT AN EXTINGUISHER. FUEL WAS EVERYWHERE. HE HELPED ME TOW IT HOME.

2014 RECALL ON THE FUEL PUMP FLANGE WAS ISSUED AND IT WAS COMPLETED AT A BMW DEALER IN JUNE OF 2014. NOW MAY 6, 2018 THE FUEL PUMP FLANGE HAS FAILED SPRAYING FUEL OVER THE ENGINE. I CONTACTED THE BMW CUSTOMER SERVICE DEPARTMENT THEY INFORMED ME THAT DUE TO THE PART BEING OVER 2 YEARS OLD AND THEY NO LONGER RESPONSABLE FOR THE REPLACEMENT OF THE PART. THIS IS THE SAME ISSUE FOR THE 2014 RECALL AND NOW IT HAS HAPPENED AGAIN.

THE VEHICLE HAS 52500 MILES. AFTER FUELING THE MOTORCYCLE I ATTEMPTED TO RESET THE TRIP ODOMETER IN THE NORMAL WAY BY TURNING THE THROTTLE TO MAXIMUM WHILE HOLDING THE BC BUTTON ON THE DASHBOARD. BIKE WAS ON, ENGINE NOT RUNNING. THE PLASTIC PULLEYS ON BOTH THROTTLE BODIES SNAPPED SUDDENLY, LEAVING THE THROTTLE BODY SET TO FULL THROTTLE. I VERIFIED THIS BY STARTING THE BIKE. IF THIS PULLEY FAILURE HAD HAPPENED WHILE IN MOTION IT COULD HAVE RESULTED IN AN ACCIDENT. THE THROTTLE BODY PULLEYS ARE NOT REPLACEABLE NOR ARE THE THROTTLE BODIES SERVICEABLE. AFTER A PERIOD OF TIME THE PLASTIC PULLEY DETERIORATES DUE TO HEAT AND LOSES STRENGTH. I REGARD THIS AS A DEFECTIVE DESIGN AND SAFETY HAZARD. THE PART SHOULD BE METAL AS ON PREVIOUS MODELS. MY R1100RT HAS 150,000 MILES AND NO ISSUES WITH THE TB PULLEYS. I WOULD URGE THAT BMW BE REQUIRED TO RECALL THE 2005-2009 MODELS WITH THESE PLASTIC PULLEYS AND REPLACE WITH METAL ONES OR THAT THEY WARRANTY THE REPAIR WHEN THIS FAILURE OCCURS.

RE: VIN [XXX] DEAR BMW MOTORCYCLES OF AMERICA I DEVELOPED A SERIOUS AND SIGNIFICANT FUEL LEAK TODAY FROM THE LEFT SIDE OF MY FAIRING/ TANK OF MY R1200RT. THE FUEL ONLY LEAKED WHEN THE KEY WAS ON, OR THE ENGINE WAS RUNNING, INDICATING THE FUEL WAS COMING FROM THE PRESSURIZED SIDE OF THE FUEL CIRCUIT, FROM LIKELY THE FUEL PUMP FLANGE. THERE IS EVIDENCE IN FORUMS AND THE RESPONSES FROM OWNERS TO DEALERS THAT THIS FUEL PUMP FLANGE CRACKING IS A COMMON ISSUE, AND THAT THERE HAS BEEN A RECALL ISSUED (13V617000) FOR REPAIR AND REPLACEMENT. I AM THE ORIGINAL OWNER OF THIS BIKE AND I NEVER RECEIVED A NOTICE FROM BMW REGARDING THIS ISSUE, AND WHEN I TRY TO ENTER MY VIN WITH THE BMWUSA.COM SITE AS WELL AS WITH NHTSA.GOV (SAFERCAR.GOV), I CANNOT MAKE PROGRESS BECAUSE I AM TOLD MY VIN IS INVALID. THIS IS NOT SO, AS I HAVE HAD OTHER WARRANTY WORK NOTIFIED AND COMPLETED VIA THIS VIN. (REPEATED FUEL STRIP SENSOR FAILURE, AND THE REAR WHEEL FLANGE CRACK RECALL). PLEASE CONTACT ME REGARDING THIS FUEL LEAK RECALL ISSUE AND HELP ARRANGE APPROPRIATE REPAIRS AND REPLACEMENT. THIS IS A FAILURE OF A PART THAT IS NOT NORMAL WEAR AND TEAR, AND POSES A SIGNIFICANT SAFETY RISK FOR FIRE. SINCERELY, INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). *TR

WHEN SHIFTING INTO SECOND GEAR, THE ENGINE SPEED DROPPED TO IDLE AND I LOST ALL POWER AND THE ABILITY TO CONTROL ENGINE SPEED. I COASTED TO THE SHOULDER AND HAD TO CALL FOR A TOW AS THE BIKE WOULD ONLY IDLE. UPON FURTHER INSPECTION AFTER I GOT THE BIKE HOME, I DISCOVERED THAT THE PLASTIC PULLEYS ON THE THROTTLE BODIES HAD SHEARED OFF. THIS REQUIRES REPLACEMENT OF THE THROTTLE BODIES. I WAS SHOCKED TO FIND OUT THE PULLEYS ARE PLASTIC. PREVIOUS MODELS WERE METAL AND MOST CARS/BIKES USE METAL, WHICH WOULD BE MORE RESISTANT TO FAILURE. TO QUOTE ANOTHER COMPLAINT: "IF OR WHEN THE PLASTIC FAILS, THERE IS NO THROTTLE AND THE ENGINE GOES TO IDLE, THUS CREATING AN EXTREME SAFETY HAZARD IF ONE IS DRIVING IN TRAFFIC AND UNABLE TO MAINTAIN SPEED OR ACCELERATE. IN THIS CIRCUMSTANCE THE RIDER COULD BE FORTHRIGHTLY IN HARM'S WAY AND ENDANGERED. THIS SHOULD BE AN URGENT RECALL ISSUE FOR REPLACEMENT OF THE PLASTIC PART WITH A SOLID CABLE PULLEY WHICH WILL NOT BREAK. PREVIOUS MODELS USED METAL CABLE PULLEYS WHICH DID NOT FAIL." THIS IS A POTENTIAL DANGER. IF SOMEONE HAD BEEN ACCELERATING BEHIND ME, I COULD HAVE BEEN REAR ENDED. BMWS INTRANSIGENCE IS MIND BOGGLING. *TR