Engine. Review the 42 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Fuel/propulsion System. Review the 26 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Power Train. Review the 20 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

0 crash reports3 fire reports2 injury reports

Air Bags complaints

3 reports

Clear category filter

Mileage unknown · Nov 21, 2021

Air BagsUnknown Or Other

Read full complaint

I had been having problems with my seatbelt alarm coming on for a while with nothing in the seat of the passenger and then as I was trying to turn in to park I heard a click from my steering wheel as if it didn’t want to turn and the driver seat restraint malfunction error popped up . Now my horn will not work as well . I’m told that the dealership is the only place it can be repaired. I’m worried that it will deploy on me while driving . I’m sure this is an issue others have experienced as well .

NHTSA ODI #11441192

25,000 miles · May 17, 2019

Air BagsStructure

THE FRONT PASSENGER OCCUPANCY SEAT SENSOR IS DEFECTIVE/NOT WORKING EVEN THOUGH THE CAR HAS ONLY 25,000 MILES. THIS IS A SAFETY ISSUE AND THERE ARE SO MANY OWNERS HAS SIMILAR ISSUE WITH THIS DESIGN

NHTSA ODI #11208241

47,000 miles · May 23, 2018

Air BagsSeat Belts

Read full complaint

TL* THE CONTACT OWNS A 2012 BMW 528I. WHENEVER THE FRONT PASSENGER SEAT WAS OCCUPIED, THE AIR BAG AND SEAT BELT WARNING INDICATORS ILLUMINATED. THE VEHICLE WAS TAKEN TO THE DEALER (CENTER BMW, 5201 VAN NUYS BLVD, SHERMAN OAKS, CA 91401) WHERE IT WAS DIAGNOSED THAT THE SEAT SENSOR FAILED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED AND INFORMED THE CONTACT THAT THE VEHICLE WAS NOT UNDER WARRANTY OR RECALL; THEREFORE, THE CONTACT WOULD BE RESPONSIBLE FOR REPAIRS. THE FAILURE MILEAGE WAS 47,000. *TT

NHTSA ODI #11097681

Official recalls

24V608000 · Electrical System:wiring:connectors/plugs/receptacles; Engine And Engine Cooling:cooling System:pump

Aug 13, 2024

BMW of North America, LLC. (BMW) is recalling certain 2012-2015 X1 sDrive28i, X1 xDrive28i, 2012-2016 Z4 sDrive28i, 528i, 528i xDrive, 328i, 328xi, 2016-2018 X5 xdrive 40e, 2014-2016 228i, 228xi, 428i, 428i xDrive, 328xi Gran Turismo, 2013-2017 X3 sDrive28i, X3 xDrive28i, 2015-2018 X4 xDrive28i, 2015-2016 428xi vehicles. An improperly sealed electrical connector on the water pump may be exposed to water and short circuit.

Consequence & remedy

Consequence: An electrical short increases the risk of a fire.

Remedy: Dealers will inspect and replace the water pump and plug connector as necessary, and install a protective shield, free of charge. Owner notification letters were mailed on March 28, 2025. Owners may contact BMW customer service at 1-800-525-7417.

Additional source detail variants (2)

Electrical System:wiring:connectors/plugs/receptacles

Consequence: An electrical short increases the risk of a fire.

Remedy: Dealers will inspect and replace the water pump and plug connector as necessary, and install a protective shield, free of charge. Owner notification letters were mailed on March 28, 2025. Owners may contact BMW customer service at 1-800-525-7417.

Engine And Engine Cooling:cooling System:pump

Consequence: An electrical short increases the risk of a fire.

16V746000 · Fuel System, Gasoline:delivery:fuel Pump

Oct 17, 2016

BMW of North America, LLC (BMW) is recalling certain model year 2007-2011 BMW X5 3.0si, X5 4.8i, X5 M, X5 xDrive30i, X5 xDrive35i, X5 xDrive48i and X5 xDrive50i, 2008-2011 X6 x Drive35i, X6 xDrive50i and X6 M, 2010-2011 X6 ActiveHybrid, 535i xDrive Gran Turismo, 535i Gran Turismo, 550i xDrive Gran Turismo and 550i Gran Turismo, 2011-2012 528i, 535i, 535i xDrive, 550i and 550i xDrive and 2012 535i ActiveHybrid, 640i Convertible, 650i Convertible, 650i xDrive Convertible, 650i Coupe and 650i Coupe xDrive vehicles. The affected vehicles have in-tank fuel pumps that may have insufficiently crimped wire contacts.

Consequence & remedy

Consequence: The loose wires may cause the connector to melt, resulting in a fuel leak. Additionally, the fuel pump may stop working, possibly causing an engine stall and increase the risk of a crash.

Remedy: BMW will notify owners, and dealers will replace the fuel pump module, free of charge. The recall began February 2017. Owners may contact BMW customer service at 1-800-525-7417.

14V627000 · Service Brakes, Hydraulic:power Assist:vacuum; Service Brakes, Hydraulic:power Assist:vacuum:hoses, Lines/piping, And Fittings

Oct 7, 2014

BMW of North America LLC (BMW) is recalling certain model year 2014 BMW 328i xDrive Sports Wagon, 2012-2014 BMW 320i Sedan, 328i Sedan, 320i xDrive Sedan, 328i xDrive Sedan, 2012-2013 BMW 528i Sedan, 528i xDrive Sedan, 2013-2014 BMW X1 sDrive28i, X1 xDrive28i Sports Activity Vehicle, 2013-2014 BMW X3 xDrive28i Sports Activity Vehicle, 2012-2014 BMW Z4 sDrive28i Roadster, and 2014 BMW 428i Coupe, and 428i xDrive Coupe. Due to insufficient lubrication, the vacuum pump that supplies brake power assistance may fail. Note: This recall is an expansion of recall 13V-454.

Consequence & remedy

Consequence: A failure of the brake vacuum pump results in a reduction in braking power that could increase the risk of a crash.

Remedy: BMW will notify owners, and dealers will install a locking ring in the camshaft to retain the camshaft seal disk in the proper location, free of charge. The recall began on December 2, 2014. Owners may contact BMW customer service at 1-800-525-7417.

Additional source detail variants (2)

Service Brakes, Hydraulic:power Assist:vacuum:hoses, Lines/piping, And Fittings

Consequence: A failure of the brake vacuum pump results in a reduction in braking power that could increase the risk of a crash.

Remedy: BMW will notify owners, and dealers will install a locking ring in the camshaft to retain the camshaft seal disk in the proper location, free of charge. The recall began on December 2, 2014. Owners may contact BMW customer service at 1-800-525-7417.

Service Brakes, Hydraulic:power Assist:vacuum

Consequence: A failure of the brake vacuum pump results in a reduction in braking power that could increase the risk of a crash.

13V454000 · Service Brakes, Hydraulic:power Assist:vacuum; Service Brakes, Hydraulic:power Assist:vacuum:hoses, Lines/piping, And Fittings

Sep 26, 2013

BMW of North America LLC (BMW) is recalling certain model year 2012-2014 320i, 328i, 320i xDrive, and 328i xDrive sedans; model year 2014 328i xDrive Sports Wagons; model year 2012-2013 528i and 528i xDrive sedans, model year 2013-2014 X1 sDrive28i and X1 xDrive28i vehicles and model year 2012-2014 Z4 sDrive28i roadsters. Due to insufficient lubrication, the vacuum pump that supplies brake power assistance may fail.

Consequence & remedy

Consequence: A failure of the brake vacuum pump results in a reduction in braking power that could increase the risk of a crash.

Remedy: BMW will notify owners, and dealers will modify the vehicles to prevent insufficient vacuum pump lubrication, free of charge. The safety recall began on January 31, 2014. Owners may contact BMW customer relations at 1-800-525-7417 or email BMW at CustomerRelations@bmwusa.com.

Additional source detail variants (2)

Service Brakes, Hydraulic:power Assist:vacuum:hoses, Lines/piping, And Fittings

Consequence: A failure of the brake vacuum pump results in a reduction in braking power that could increase the risk of a crash.

Remedy: BMW will notify owners, and dealers will modify the vehicles to prevent insufficient vacuum pump lubrication, free of charge. The safety recall began on January 31, 2014. Owners may contact BMW customer relations at 1-800-525-7417 or email BMW at CustomerRelations@bmwusa.com.

Service Brakes, Hydraulic:power Assist:vacuum

Consequence: A failure of the brake vacuum pump results in a reduction in braking power that could increase the risk of a crash.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE13030 · Loss Of Power Assist Braking

Opened Sep 6, 2013 · Closed Oct 25, 2013

Status: closed (inferred from source dates) · Service Brakes, Hydraulic:power Assist:vacuum

In a letter dated September 26, 2013, BMW Group submitted a safety recall notice to NHTSA identifying a defect condition in the vacuum pump oil supply that may result in loss of power assist braking in 76,191 model year (MY) 2012 through 2014 BMW 3-Series, 5-Series, X1 SAV, X3 SAV, and Z4 vehicles equipped with 4-cylinder engines (NHTSA Recall 13V-454).According to BMW, movement of the seal disk within the camshaft may result in blocking of the oil supply to the vacuum pump, resulting in improper pump operation and loss of power assist braking.On July 11, 2013, BMW initiated a change to the camshaft geometry that prevented the seal disk from blocking the oil port.BMW has not received any braking complaints related to loss of power assist after the design change was implemented in production.The owners of all affected vehicles will be contacted by mail and asked to take their vehicle to a BMW dealer who will install a locking ring into the camshaft to keep the seal disk in its proper location.BMW expects to begin dealer and owner notification in November 2013 and complete dealer and owner notification in December when the remedy is expected to be available.Based on the actions taken by BMW, this investigation is closed.