2006 Acura Rsx

DURING THE PAST SEVERAL MONTHS I HAVE NOTED WATER ACCUMULATION IN BOTH TAIL LIGHTS ON MY 2006 ACURA RSX. THERE IS CURRENTLY 1-INCH OF STANDING WATER IN ONE OF THE TAILLIGHTS AND APPROXIMATELY A INCH IN THE OTHER. THE VEHICLE IS APPROXIMATELY 3-1/2 YEARS OLD AND JUST PASTED THE 50,000 MILE ACURA STANDARD WARRANTY. ACCORDING TO ACURA CLIENT SERVICES, THEY HAVE NO OBLIGATION TO CORRECT OR COVER THE COST OF REPAIRS BECAUSE THE VEHICLE IS OUT OF WARRANTY! OUR LOCAL ACURA DEALER HAS NOT PROVIDED MUCH HELP. THIS IN MY OPINION IS A MAJOR SAFETY ISSUE. THE WATER THAT SLOSHES BACK AND FORTH WILL EVENTUALLY CAUSE LAMP FAILURE AND/OR LAMP SOCKET CORROSION AND FAILURE. THE FREEZE AND THAW CYCLE OF THE NORTHEAST WILL EVENTUALLY CRACK THE LENSES. THIS PROBLEM IS NOT AN ISOLATED INSTANCE. THE INTERNET AND VARIOUS FORUMS ARE LOADED WITH COMPLAINTS OF CONDENSATION AND STANDING WATER IN THESE TAIL LIGHT HOUSINGS. THIS IS AN OBVIOUS MANUFACTURE DEFECT AND THIS SAFETY ISSUE SHOULD BE CORRECTED AND COVERED BY ACURA REGARDLESS OF WARRANTIES. *TR

1. HAZARDOUS NIGHT DRIVING LOSS OF LOW BEAM HEADLIGHT DUE TO POOR LIGHT SOCKET DESIGN AND CONSTRUCTION. THIS DEFECT APPEARS TO BE A BURNOUT LIGHT HALOGEN LIGHT BULB. 2.THE BULB BURNS OUT DUE VIBRATION, OR ARCHING CAUSED BY THE LIGHT BULB LOCKING MECHANISM ASSEMBLY FAILURE LEAVING THE BULB LOOSE, AND HELD IN PLACE ONLY BY THE PROTECTIVE RUBBER BOOT. THE LAMP SOCKET IS HELD IN PLACE BY A HIGH TENSION SPRING LOCKING INTO A SMALL HOOK PROTRUDING FROM APPROXIMATELY 2? DIAMETER THIN SOFT WHITE METAL CAST DISK ATTACHED WITH 2 SMALL SCREWS TO THE HEADLIGHT REFLECTOR. THIS TOOTH SHAVES OFF BY THE SPRING PRESSURE AS EVIDENCED BY METAL SHAVINGS PRESENT IN BASE OF THE REFLECTOR. THIS IS NOT AN ISOLATED OCCURRENCE, AND A BRIEF INTERNET SEARCH HAS TURNED UP MANY OF SIMILAR OWNER REPORTS. LOSS OF LIGHT IS OFTEN PRECEDED BY THE BLINKING HEADLIGHT. THERE IS A DANGER OF CRASH DUE TO LOSS OF LIGHTS ON AN UNLIT HIGHWAY. 3.THE SOFT METAL LIGHT SOCKET MOUNT SHOULD BE REPLACED BY A STAMPED SHEET METAL PART THAT WOULD NOT CRACK UNDER THE SPRING PRESSURE. THE CHOICE OF A VERY SOFT AND THIN METAL DIE CAST FOR THIS PART IS AN OBVIOUS ERROR. THE STAMPED PART SHOULD BE ALSO MUCH LESS EXPENSIVE THEN THE DIE CAST. THE ONLY FIX SO FAR IS A REPLACEMENT OF THE ENTIRE HEADLIGHT ASSEMBLY WITH 3 LIGHTS AT $619.53 BECAUSE ACURA REFUSES TO MAKE THE REPLACEMENT DIE CAST DISK AVAILABLE AS A REPLACEMENT PART. ACURA SERVICE STONEWALLS THE WARRANTY REPAIR REQUESTS. IN MY CASE, THE ORIGINAL DEALER HAS CLAIMED THAT THE LIGHT IS NOT ABLE TO BE FIXED UNDER THE WARRANTY BECAUSE CAR ?HAD AN IMPACT?. THE ACURA CASE MANAGER HAS ARRANGED OPINION FROM ANOTHER DEALER WHO HAS SAID THERE WAS ?NO IMPACT?, BUT THE USER ?MUST HAVE BROKEN THE RETAINING HOOK DURING THE LIGHT BULB REPLACEMENT?, HENCE NO WARRANTY SERVICE. THE ISSUE IS THAT THE LIGHT BULB HAS BEEN FOUND LOOSE IN THE SOCKET, MAKING IT IMPOSSIBLE TO BE REPLACED AT NIGHT. YOU NEED TO REQUIRE THAT ALL LIGHT BULBS MUST BE REPLACEABLE WITHOUT USE OF TOOLS. *TR

I OWN A 2006 ACURA RSX. I WAS DRIVING AT 40 MPH ON THE NEW YORK STATE THRUWAY YESTERDAY (12/9/09) MORNING AT APPROXIMATELY 6:55AM. IT WAS RAINING AND THE ROAD WAS SLUSHY. I WAS DRIVING SLOWLY IN THE RIGHT LANE AND MY CAR SPUN ALL THE WAY AROUND TO THE RIGHT AND MY FRONT BUMPER HIT THE RIGHT CORRIDOR OF THE THRUWAY. MY CAR THEN KICKED BACKWARDS AND SPUN AROUND IN A COMPLETE CIRCLE AGAIN AND MY BACK BUMPER HIT THE RIGHT CORRIDOR. PRIOR TO THIS ACURA, I HAD A 2001 ACURA INTEGRA. THE SAME EXACT PROBLEM OCCURRED. I SPUN OUT AND TOTALED MY CAR. CLEARLY THIS IS NOT A SAFE CAR AND I NEED THIS TO BE BROUGHT TO LIGHT TO SAVE LIVES. IF THERE WAS ANOTHER CAR NEAR ME ON BOTH OCCASIONS, I WOULD HAVE DIED. *TR

PURCHASED CAR ON JULY 31, 2006 AND DROVE CAR DIRECTLY HOME. OVERNIGHT, PARKING BRAKE FAILED AND CAR CRASHED INTO TREE & BOAT TRAILER DAMAGING REAR BUMPER AND REAR LEFT PANEL (DRIVER'S SIDE). SUBSEQUENT FOLLOW-UP REVEALED THAT BRAKE WOULD NOT HOLD AS IT SHOULD - VIDEO AND OTHER EVIDENCE INCLUDING STATEMENT FROM AUTO REPAIR PROFESSIONAL SUPPORTS CLAIM. AUTO DEALER (APPLE ACURA) AND ACURA CLIENT SERVICES REFUSED TO HONOR WARRANTY. AUTO DID NOT MEET PENNSYLVANIA INSPECTION STANDARDS WHEN SOLD. WHILE AUTO WAS AT DEALER, AND WITHOUT AUTHORIZATION FROM US, BRAKES WERE ADJUSTED/CORRECTED PRIOR TO DELIVERING VEHICLE BACK TO US. AUTO WAS TAKEN TO AN INDEPENDENT AUTO BODY SHOP FOR REPAIR. *JB

I BOUGHT THE CAR BRAND NEW, 2006 ACURA RSX(SEPT.16,2005), AT ABOUT BETWEEN 300 TO 500 MILES I STARTED TO HEAR POPPING NOISE OR SOME TYPE OF NOISE SOUNDING LIKE A BAD AXLE WOULD MAKE WHEN I MAKE SLOW TURNS OR FAST TURNS SOMETIMES. ACURA FIXED THE PROBLEM AND TOLD ME IT WAS SOME CUSHION PROBLEM WITH THE SPRINGS. AT ABOUT BETWEEN 10K TO 15K MILES I STARTED TO HEAR IT AGAIN(BETWEEN DEC. AND BEGINNING OF JAN) I TOOK IT BACK TO ACURA THEY FIXED IT AGAIN ...NOW AT ABOUT 30K MILES I STARTED TO HAVING THE SAME PROBLEM, BUT I DON'T TAKE IT INTO ACURA UNTIL ABOUT 36K BECAUSE I DON'T HAVE TIME AND I WANT THE NOISE TO BE LOUDER AND WORST AND SO IT DID AT ABOUT 36K...IM SCHEDULE FOR A SERVICE AT ACURA ON SEPT.6 . THIS CAR IS STARTING TO BECOME A LEMON IN MY VIEWS. I ALSO KNOW IM NOT THE ONLY ONE WITH THIS PROBLEM WITH THE 2006 ACURA RSX. *NM

FIRST STARTED HEARING A POPPING/KNOCKING NOISE ON THE FRONT RIGHT SIDE OF THE CAR WHEN TURNING THE WHEEL AT SLOW SPEEDS AT 5,034 MILES. DEALER TIGHTENED STRUT TOWER NUT AND LUBED SPRING BEARING. THE NOISE WENT AWAY AND REAPPEARD AT 5,527 MILES. THE DEALER THEN REPLACED THE RIGHT FRON STRUT. THE NOICE WENT AWAY AND REAPPEARD AT 9,278 MILES. THE DEALER HAD A REGIONAL FACTORY REP COME AND LOOK AT THE CAR. THEY REPLACED BOTH FRONT STRUTS. THE NOISE WENT AWAY AND REAPPEARD AT 12,978 MILES. THE DEALER TEST DROVE AND DID HEAR THE NOISE AGAIN. WE ARE NOW IN THE FIRST STAQES OF IMPLEMENTING OUR LEMON LAW RIGHTS BY SUBMITTING BY CERTIFIED MAIL, NOTICE TO MANUFACTURER OF FINAL OPPORTUNITY TO REPAIR, FOUND ON THE LEMON LAW WEBSITE. WE FULLY INTEND ON PURSUING OUR CONSUMER RIGHTS TO EITHER REPLACE OR REFUND .